CyberPower UP1200 - Manuals

Page 2 - TABLE OF CONTENTS; - HARDWARE INSTALLATION GUIDE.................................................2

2 TABLE OF CONTENTS IMPORTANT SAFETY WARNINGS …………….……………………………………….………1 INSTALLING YOUR UPS SYSTEM …………………….………………………………….……2 - UNPACKING…… ………………………………………………………………..2 - HARDWARE INSTALLATION GUIDE…………………………………….……2 BASIC OPERATION …………………………………………......................................................

Page 3 - IMPORTANT SAFETY WARNINGS; DO NOT

UP1200 Guaranteed Uninterruptible Power System 3 IMPORTANT SAFETY WARNINGS (SAVE THESE INSTRUCTIONS) This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries. Please read and follow all instructions carefully during installation...

Page 4 - INSTALLING YOUR UPS SYSTEM; HARDWARE INSTALLATION GUIDE; BASIC OPERATION; FRONT PANEL AND REAR PANEL DESCRIPTION

4 INSTALLING YOUR UPS SYSTEM UNPACKING Inspect the UPS upon receipt. The box should contain the following: (1) UPS Unit; (1) User’s Manual for UPS; (1) Warranty Registration Card; (1) PowerPanel TM Software Disk; (1) User’s Manual for PowerPanel TM ; (1) Serial Interface Cable (DB-9); (1) Serial-to-...

Page 5 - Windows NT, Windows

UP1200 Guaranteed Uninterruptible Power System 5 ◆ Power Switch Press the power button to turn the UPS ON or OFF ◆ Power On Indicator This LED is illuminated when the utility condition is normal and the UPS outlets are providing “clean power”, free of surges and spikes ◆ Using Battery Indicator This...

Page 6 - BATTERY REPLACEMENT AND STORAGE; IMPORTANT SAFETY INSTRUCTIONS; BATTERY REPLACEMENT PROCEDURE:; Rotate the UPS from vertical to horizontal.

6 BATTERY REPLACEMENT AND STORAGE Contact your dealer or call the number in this manual for information on battery replacement. The order numbers for the battery are as follows: BA-UP1200 for UP1200 CAUTION! Read and follow the IMPORTANT SAFETY INSTRUCTIONS before servicing the battery. Service the ...

Page 7 - HAZARDOUS WASTE

UP1200 Guaranteed Uninterruptible Power System 7 8. Install the replacement battery by connecting the red wire to the positive (+) terminal of the battery and connecting the black wire to the negative (-) terminal of the battery. 9. Slide the battery back into the compartment. 10. Replace the cover ...

Page 8 - TROUBLESHOOTING; Problem

8 TROUBLESHOOTING Problem Possible Cause Solution Batteries are not fully charged. Recharge the battery by leaving the UPS plugged in. The UPS does not perform expected runtime. Battery is slightly worn out. Contact CyberPower Systems at [email protected] The on/off switch is designed to pr...

Page 9 - TECHNICAL SPECIFICATIONS; Model

UP1200 Guaranteed Uninterruptible Power System 9 TECHNICAL SPECIFICATIONS Model UP1200 Capacity (VA) 1200VA Capacity (Watts) 670W Input Input Voltage Range 100Vac – 140Vac Frequency Range 57 – 63 Hz Output On Battery Output Voltage Simulated Sine Wave at 120Vac +/- 5% On Battery Output Frequency 60 ...

Page 10 - DEFINITIONS FOR ILLUMINATED LED INDICATORS

10 DEFINITIONS FOR ILLUMINATED LED INDICATORS Power On Using Battery Wiring Fault Circuit Breaker Alarm Condition On Off Off Set Off Normal Off On On/Off Set Two Beeps Utility Failure- The UPS is providing battery power to the Battery-Power Supplied outlets. Off On On/Off Set Rapid Beeps Utility Fai...

Page 11 - LIMITED WARRANTY AND POWER CONTROL GUARANTEE; Limited Warranty; . CyberPower also provides the Initial Customer with protection; REGISTRATION

UP1200 Guaranteed Uninterruptible Power System 11 LIMITED WARRANTY AND POWER CONTROL GUARANTEE In purchasing UP1200 in the United States or Canada, the original end user receives a Limited Warranty and CyberPower's Power Control Guarantee from Cyber Power Systems (USA), Inc. (for ease of reading, re...

Page 13 - Making a Power Control Guarantee Claim.

UP1200 Guaranteed Uninterruptible Power System 13 The Limited Warranty does not cover Connected Equipment, but as is explained below, to be covered under the Power Control Guarantee, the Connected Equipment must have been damaged due to a failure of the Product. The Connected Equipment must have bee...

Page 14 - As to the CyberPower Product, the limited warranty; does not

14 If the damage to Connected Equipment is covered by the Power Control Guarantee, CyberPower will (in addition to Limited Warranty remedies for the CyberPower Product itself) repair (or pay the costs of repair) or replace the Connected Equipment or, at the option of CyberPower, as permitted by law,...

Page 15 - ANY SUCH USE IS IMPROPER AND IS A MISUSE OF A CYBERPOWER PRODUCTS

UP1200 Guaranteed Uninterruptible Power System 15 The Limited Warranty and the Power Control Guarantee Do Not Apply Unless The Initial Customer: 1. Has properly connected the Product and the Connected Equipment to properly wired and grounded outlets (including compliance with electrical and safety c...