CyberPower CS150U48V3 - Manuals

Page 4 - PRODUCT INTRODUCTION; General Description; customers’ different needs; IMPORTANT SAFETY NOTES; with insulated handles.; Electrical Warnings; connected. Use extreme caution during these procedures.

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 3 of 17 1 PRODUCT INTRODUCTION 1.1 General Description The CS150U48V3 battery backup unit is designed to serve up to two MDU ONTs (Optical Network Terminal for Multi-Dwelling Use) and can be installed indoors or...

Page 5 - Limited Warranty

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 4 of 17 2.2 Battery Warnings • Danger of explosion if battery is incorrectly connected or replaced.• Worn-out or damaged batteries are considered environmentally unsafe. Always recycle used batteries or dispose ...

Page 7 - DIMENSIONS

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 6 of 17 Figure 1: Dimensions (Front View) Figure 2: Dimensions (Side View) 3 DIMENSIONS 17.14 inch (435.4 mm) 7.09 inch (180.1 mm) 5.79 inch (147.1 mm) 15.75 inch (400.1 mm) 16 inch (406.4 mm) 15.30 inch (388.6 ...

Page 8 - INSTALLATION

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 7 of 17 Figure 3: Unit Overview (Front) Figure 4: Unit Overview (Rear) Figure 5: Unit Overview (Side) Figure 6: Unit Overview (Bottom) 4 INSTALLATION 4.1 Overview 1. Internal AC power wiring inlet2. Alarm Silenc...

Page 9 - Prior to Installation

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 8 of 17 4.2 Unpacking Inspect the Battery Backup Unit upon receipt. The box should contain the following: • Battery Backup Power Supply Unit x 1• Battery Shelves x 2 – Battery Tray x 2 – Battery Tray Clamp x 2 –...

Page 11 - Battery Type; Battery Jumpers

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 10 of 17 Figure 10: Battery Wiring Secure harness with cable ties Battery Type The battery is a standard sealed lead acid battery rated at 12Vdc / 7.2 (7) Ah. When required, the battery may be replaced with an a...

Page 12 - Connecting to Power Source; Remove; Heater

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 11 of 17 4.7 Connecting to Power Source 4.7.1 Installing the Power Cord 1. Remove the 4 terminal strip cover screws (upper left hand corner) 2. Remove any convenient 3/4” knock-out of the UPS enclosure. 3. Insta...

Page 14 - ONT Alarm Connections; Tighten the strain relief around the power cord.; OPERATION; batteries are charging.

4.8 ONT Alarm Connections 1. Route the 7-wire cable back from the ONT enclosure to the UPS.2. Remove any convenient 3/4” knock-out of the UPS enclosure.3. Install a strain relief in the knock-out hole.4. Route the power cable up through the strain relief.5. Trim the cable to the desired length and s...

Page 17 - Table 7: Specifications; SPECIFICATIONS; Indicator), Battery (Battery Missing/Replacement Indicator)

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 16 of 17 Table 7: Specifications 6 SPECIFICATIONS Model Number CS150U48V3 Input: Rating Voltage/Frequency 100 - 240V / 50 - 60Hz Input Voltage Range 90 - 264Vac Frequency Range 47 - 63Hz P.F. > 0.9 at Rating ...