Cub Cadet GT1554- Manuals

5 e. Use extreme care when approaching blind corners, doorways, shrubs, trees or other objects that may block your vision of a child who may run into the machine. f. To avoid back-over accidents, always disengage the cutting blade(s) before shifting into reverse. The “Reverse Caution Mode” should no...

6 8. Never tamper with the safety interlock system or other safety devices. Check their proper operation regularly. 9. After striking a foreign object, stop the engine, disconnect the spark plug wire(s) and ground against the engine. Thoroughly inspect the machine for any damage. Repair the damage b...

7 SECTION 2: SLOPE GAUGE 3IGHTANDHOLDTHISLEVELWITHAVERTICALTREE ORACORNEROFABUILDING ORAFENCEPOST &OLDALONGDOTTEDLINEREPRESENTSA—SLOPE —

8 SECTION 3: TRACTOR SET-UP Gas and Oil Fill-up The gasoline tank is located under the fender and has a capacity of three and-a-half gallons. Unthread the fuel cap by turning it counterclockwise. Use only clean, fresh (under 30 days old), unleaded gasoline. Fill tank to no more than four inches belo...

9 SECTION 4: KNOW YOUR LAWN TRACTOR Figure 2 NOTE: Any reference in this manual to the RIGHT or LEFT side of the tractor is observed from operator’s position. A Systems Indicator Monitor/Hour Meter H PTO (Blade Engage) Knob B Throttle Control Lever I Brake Pedal C Choke Control J Drive Pedal D Parki...

10 Throttle Control Lever The throttle control lever is located on the left side of the tractor’s dash panel. This lever controls the speed of the engine. When set in a given position, the throttle will maintain a uniform engine speed. IMPORTANT: When operating the tractor with the cutting deck enga...

11 Systems Indicator Monitor / Hour Meter LCD Located in the center of the tractor’s console, the systems indicator monitor records, and displays on its LCD, hours of tractor operation whenever the ignition key is rotated out of the STOP position. The Indicator Monitor will also remind the operator ...

12 SECTION 5: OPERATING YOUR LAWN TRACTOR Safety Interlock Switches This tractor is equipped with a safety interlock system for the protection of the operator. If the interlock system should ever malfunction, do not operate the tractor. Contact your Cub Cadet dealer. • The safety interlock system pr...

13 Starting the Engine WARNING: Never operate the tractor if the interlock system is malfunctioning. Thissystem was designed for your safety. NOTE: Refer to the TRACTOR SET-UP on page 8 of this manual for Gasoline and Oil fill-up instructions. • Insert the tractor key into the ignition switch module...

14 Driving On Slopes Refer to the SLOPE GAUGE on page 7 to help determine slopes where you may operate the tractor safely. WARNING: Do not mow on inclines with a slope in excess of 15 degrees (a rise ofapproximately 2-1/2 feet every 10 feet). Thetractor could overturn and cause seriousinjury. • Mow ...

15 Engaging the PTO Engaging the PTO transfers power to the cutting deck or other (separately available) attachments. To engage the PTO, proceed as follows: • Move the throttle control lever to the FAST (rabbit) position. • Pull the PTO/Blade Engage knob outward into the engaged (ON) position. See F...

16 SECTION 6: MAKING ADJUSTMENTS WARNING: Never attempt to make any adjustments while the engine is running,except where specified in the operator’smanual. Leveling the Deck NOTE: Check the tractor’s tire pressure before performing any deck leveling adjustments. Refer to Tires on page 24 for informa...

17 Parking Brake Adjustment If the tractor does not come to a complete stop whenthe brake pedal is completely depressed, or if thetractor’s rear wheels can roll with the parking brakeapplied (and the hydrostatic relief valve open), thebrake is in need of adjustment. See your Cub Cadet dealer to have...

18 SECTION 7: MAINTAINING YOUR LAWN TRACTOR NOTE: Refer to Maintenance Chart on page 28 for a reference of recommended maintenance intervals. WARNING: Before performing any maintenance or repairs, disengage PTO, setparking brake, stop engine and remove key toprevent unintended starting. Engine Maint...

19 Changing the Engine OIl The engine oil and oil filter should be changed after every 50 hours of tractor operation. WARNING: If the engine has been recently run, the engine, muffler and surroundingmetal surfaces will be hot and can causeburns to the skin. Allow the tractor to cool anduse caution w...

20 IMPORTANT: The oil fill cap/dipstick must be installed securely onto the tube at all times when the engine is operating . Severe engine damage could result from a failure to do so. • Start the tractor engine and allow it to run for thirty seconds, then stop the engine and remove the ignition key....

21 Figure 13 Fuel Filter WARNING: Do not replace the fuel filter when engine is hot. The engine is equipped with an inline fuel filter located on the left side of the engine. Visually inspect the filter periodically for a build-up of residue inside the filter body, and for a dirty element which can ...

22 Lubrication WARNING: Before lubricating, repairing, or inspecting, always disengage PTO, setparking brake, stop engine and remove key toprevent unintended starting. Engine Refer to Engine on page 18 for instruction regarding all engine-related lubrication. Front Wheels Each of the front wheel axl...

23 Adjustment NOTE: Engines may have a fixed idle or limiter cap on the idle fuel adjusting screw. Step 2 can only beperformed within the limits allowed by the cap. 1. Start the engine and run at half throttle for five to 10 minutes to warm up. The engine must be warm before performing steps 2 and 3...

24 SECTION 8: SERVICE Tires WARNING: Never exceed the maximum inflation pressure shown on the sidewall of thetire. The recommended operating tire pressure is approximately 10 psi for the rear tires and 14 psi for the front tires. Refer to the tire sidewall for exact tire manufacturer’s recommended o...

25 Battery California Proposition 65 Warning: Battery posts, terminals, and related accessoriescontain lead and lead compounds, chemicalsknown to the State of California to causecancer and reproductive harm. Wash handsafter handling. The battery is sealed and is maintenance-free. Acid levels cannot ...

26 • Repeat the above steps on the tractor’s right side. • Move the deck lift lever into the top notch to raise the deck lift arms up and out of the way. • Gently slide the cutting deck toward the front of the tractor allowing the hooks on the deck to release themselves from the deck stabilizer rod....

28 SECTION 9: OFF-SEASON STORAGE Clean and lubricate the tractor as instructed in Section 7: MAINTAINING YOUR LAWN TRACTOR on page 18 of this manual before storing for an extended period. Engine If the engine will be out of service for two months or more, use the following storage procedure: • Clean...

29 SECTION 11: MAINTENANCE LOG Please keep a record of the maintenance performed on your tractor. Date Hour Meter Maintenance Performed by

30 SECTION 12: TROUBLESHOOTING Trouble Possible Cause(s) Corrective Action Engine fails to start PTO/Blade Engage knob engaged.Parking brake not engaged.Spark plug wire(s) disconnected.Throttle control lever not in correct starting position.Choke not activatedFuel tank empty, or stale fuel.Blocked f...

31 SECTION 13: ATTACHMENTS & ACCESSORIES The following attachments and accessories are compatible for Series 1500 Garden Tractors . See your Cub Cadet dealer or the retailer from which you purchased your tractor for information regarding price and availability. † 190-824 is required for use of t...

32 SECTION 14: REPLACEMENT PARTS NOTE: Phone (800) 965-4CUB to order replacement parts or a complete Parts Manual (have your full model number and serial number ready). Parts Manual downloads are also available free of charge at www.cubcadet.com. WARNING: If a safety feature is not functioning prope...

IMPORTANT: To obtain warranty coverage owner must present an original proof of purchase and applicable maintenance records to the servicing dealer. Please see the operator’s manual for information on required maintenance and service intervals. The limited warranty set forth below is given by Cub Cad...