Cub Cadet CC 22- Manuals

4 Understanding model and serial numbers The model number of the 22” trimmer mower described in this manual is 25A-262J710. The break down of what the model number means is as follows: • 25 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . indicates that this is a edger or tr...

22” Trimmer Mower 5 Trimmer Line The trimmer line is a fixed length and can easily be replaced following the diagram on the front of the trimmer base assembly. See Figure 3. 1. Disconnect and ground the spark plug wire. 2. Remove the worn string from the spindle. 3. Fold the replacement trimmer line...

6 Skid Assembly NOTE: The skid assembly is available as service part number: 982-0143. See Figure 5. To remove/replace the skid assembly: 1. Turn of the engine. 2. Disconnect the spark plug wire and ground it to the engine block. 3. Remove and discard the three nuts and bolts that secure the skid to...

22” Trimmer Mower 7 Spindle NOTE: The spindle can not be serviced, and must be replaced as a unit if it gets damaged. See Figure 6. NOTE: The cutting height is adjusted by sliding the disc that the trimmer line is attached to up or down the spindle shaft. • The disc is held in position by two wing n...

8 5. Loosen the idler pulley nut and bolt with a pair of 1/2” wrenches, until the belt keeper opens. See Figure 9. 6. Slip the belt off of the idler pulley. See Figure 10. 7. Disconnect the extension spring from the belt guide bracket. See Figure 11. NOTE: The extension spring applies tension to the...

22” Trimmer Mower 9 8. Remove the hex nut and hex bolt that hold the idler pulley assembly to the trimmer base, using a pair of 1/2” wrenches. NOTE: Record the mounting hardware positions as you remove it. See Figure 12. 9. Remove the center hex bolt securing the spindle assembly to the trimmer base...

10 Belt Replacement IMPORTANT: Allow the engine to cool if it has been running. 1. Disconnect and ground the spark plug wire. 2. Drain the fuel tank. 3. Position the trimmer so the rear edge of the trimmer base is resting securely on a work bench, and pivot the handle down. NOTE: The handle should b...

22” Trimmer Mower 11 13. Secure the pulley flywheel so that it will not spin during removal of the crankshaft bolt. See Figure 17. 14. Remove the crankshaft bolt using a 9/16” wrench. 15. Remove the left wheel. 16. Slide the axle to the right until it clears the left side of the frame. See Figure 18...

12 Wheels and Axle To remove the wheels and axle: 1. Remove the screw and washer that secures the wheel, using a 7/16” wrench. See Figure 19. NOTE: If the axle is being removed, the left wheel must be removed. NOTE: There is a stop welded to the axle where it passes through the right hand side of th...

22” Trimmer Mower 13 Debris Screen There is a debris screen over the cooling fan. Its pres-ence is necessary to prevent the cooling fins from getting clogged. Customers should not operate the trimmer with-out the screen in place. See Figure 22. To remove/replace the debris screen: 1. Press in on the...

MTD Products Inc - Product Training and Education Department FORM NUMBER - 769-09529 11/2013