Cub Cadet 60 Fabricated Deck- Manuals

Cub Cadet 60 Fabricated Deck– User Manual in PDF format online.

Manuals:

User Manual

User Manual Cub Cadet 60 Fabricated Deck

Summary

Page 2 - TABLE OF CONTENTS

2 TABLE OF CONTENTS Foreword . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3General Safety Operations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 A.Danger . . . . ....

Page 3 - FORWARD; WARNING; MODELS LISTED IN THIS MANUAL

3 FORWARD The Tank Hydrostatic Zero-Turn Commercial Riding Mower provides superb maneuverability, mid-mount cutting capability for professional landscapers, commercial lawn service compa-nies, professional turf managers and golf course superintendents. The machine incorporates many safety features t...

Page 4 - SAFETY PRECAUTIONS

4 GENERAL SAFETYOPERATIONS A. DANGER 1. Do not operate machine in confined areas where exhaust gases can accumulate. 2. Do not operate machine without mower chute deflector in place and operational. 3. Do not carry passengers. B. WARNING 1. Do not operate machines under the influence of alcohol or d...

Page 5 - Do not overfill; C. Related to Batteries; Note

5 11. When looking for oil leaks, never run your hand over hydraulic hoses, lines or fittings. Never tighten or adjust hydraulic hoses, lines or fittings while the system is under pressure. If high-pressure oil penetrates the skin, the oil must be removed within a few hours by a doc-tor familiar wit...

Page 6 - E. Operator Protection System

6 blade bolts are tight before restarting the engine. 13. Never leave the mower unattended without: turning off the blade clutch switch; placing the left and right steering levers in the neutral opened-out position; moving the throttle to slow; setting the parking brake; shutting off the engine and ...

Page 7 - SAFETY DECALS AND LABELS; R O T A T I N G B L A D E; D A N G E R; OFF

7 SAFETY DECALS AND LABELS K E E P H A N D S a n d F E E T A W A Y D A N G E R TO REDUCE THE RISK OF INJURY,D O N O T O P E R A T E M O W E R U N L E S S DISCHARGE CHUTE COVER OR GRASS C A T C H E R IS I N I T S P R O P E R P L A C E . WARNING SHIELD MISSING DO NOT OPERATE Do not put hands or feetun...

Page 8 - SPECIFICATIONS

8 SPECIFICATIONS GENERAL INFO.Controls: Engine ignition and start switch; throttle; choke; left and right steering levers; electric blade clutch switch; parking brake; mower deck lift Parking Brake: Mechanical linkage brake handle to internal drum brakes Seat: Adjustable seat and armrests. 5" Ad...

Page 9 - OPERATING INSTRUCTIONS; Safety Awareness when Mowing

9 OPERATING INSTRUCTIONS A.General 1. When Mowing: a. Keep adults, children, and pets away from the area to be mowed. b. When operating this mower, in the forward direction, do not allow the steering levers to return to Neutral on their own. Always maintain a firm grip on the levers, operate them sm...

Page 12 - C.Initial Adjustments; Check the fluid levels and tires:; Check the tension of the deck drive belts.

12 C.Initial Adjustments 1. Check the fluid levels and tires: Note: These checks should be made daily, before starting the engine. a. Fuel: Using a good grade of unleaded, regular gasoline (for a gasoline engine), fill the fuel tank (beside the engine on the left or right side of the mower). When th...

Page 15 - E.Mower Cutting Blades; Mulch

15 Note: Do not hold the key in the “Start” position for more than 10 seconds or you may damage the starter. If the engine does not start in this time, wait about 30 seconds and try again. i. Gasoline Engine: Once the engine starts, push the choke on halfway and as the engine warms, push the choke o...

Page 16 - Removing the Mower Deck:

16 MAINTENANCE ANDSERVICE WARNING: Disconnect the spark plug wires or remove the key from the ignition to prevent the engine from accidentally starting before performing any maintenance on this mower. A. Mower Deck 1. Removing the Mower Deck: a. Apply the parking brake. Remove ignition key and both ...

Page 17 - Changing the Blade Drive Belts:; Changing the Spindle Assembly

17 a. Set the parking brake.b. Clean any debris from the blades. Keep blades sharp and free of build up at all times. c. Sharpen blades evenly at the original 30° angle to maintain balanced cutting blades. Do not sharpen the underside of the blades. Use a electric blade sharpener, a conventional ele...

Page 19 - Battery Removal; Installing the Battery; Jump Starting; Specific Gravity

19 c. Store the battery with a full charge. A dis-charged battery will freeze (refer to the table below). d. Recharge battery when ever the specific gravity value is less than 1.225 3. Battery Removal Warning: When removing the cables from the battery follow these steps to avoid a short between the ...

Page 22 - Hydraulic Oil Tank and Filter:; Hydrostatic Pumps and Motors:; Steering Lever Adjustments:

22 pin from the clevis pin and pulling the clevis pin from the brake clevis. Loosen the hex nut and turn the brake clevis in a clockwise direction one full turn looking down the brake rod. This will tighten the brake about .040 inch. Tighten the hex nut and reassemble the brake clevis to the brake s...

Page 23 - To Put the Mower Back in Service:

23 tion the mower moves — to the front or the rear. To make the adjustment, place the steer-ing levers in the opened-out neutral position and set the parking brake, shutoff the engine, take the key from the ignition switch and pivot the seat forward. If the mower creeps to the right, you will adjust...

Page 24 - MAINTENANCE SCHEDULE; Before starting engine:; B. Every 25 Hour Checks; Follow the Oiling Chart.; D. Every 100 Hour Checks

24 MAINTENANCE SCHEDULE A. Daily Checks 1. Before starting engine: a. Check the fuel level.** b. Check the engine oil level.** c. Check the hydraulic oil level. d. Check the hydraulic hoses for leaks, abra-sion, kinks, twists, or a flattened condition. e. Check the tires and tire pressure.Drive Tire...

Page 25 - OIL CHART; DAILY; LUBRICATION CHART; EVERY 25 HOURS

25 . OIL CHART Apply a few drops of engine oil or use a spray lubricant. Apply the oil to both sides of pivot points. Wipe off any excess. Start engine and operate mower briefly to insure that oil spreads evenly. Number of Oil Points Description DAILY 44222212 WEEKLY 1222111422 Deck Suspension Pivot...

Page 26 - Performance Adjustments; A. High Speed Tracking Adjustment; B. Enginge RPM Check and Adjustment

26 Performance Adjustments A. High Speed Tracking Adjustment If mower tracks to one side with both lap bars in fully forward position: 1. Check air pressure in all four tires: a. Pressure should be within specified ranges and balanced side-to-side. b. Rear tires 8-10 psi. recommended (20 psi MAX.) c...

Page 28 - F. Deck leveling Procedure

28 F. Deck leveling Procedure 1. Park the mower on a flat paved surface, engage the parking brake, shut off the engine, remove the key from the ignition switch, disconnect the spark plug wires and using the transport lever, lower the mowing deck into the 4" height of cut position. (The 4" he...

Page 29 - WIRING DIAGRAM

Page 30 - MAINTENANCE RECORD; DATE

30 MAINTENANCE RECORD DATE WORK PERFORMED DATE WORK PERFORMED

Page 32 - MANUFACTURER’S LIMITED WARRANTY - TURF EQUIPMENT

MANUFACTURER’S LIMITED WARRANTY - TURF EQUIPMENT This warranty is specific to the product manual to which it is attached. For a complete list of products and warranties contact your authorized Cub Cadet Commercial dealer. Proper maintenance of the purchased Cub Cadet Commercial equipment is the owne...