Cub Cadet 435D- Manuals

5 2 Safe Operation Practices WARNING This symbol points out important safety instructions which, if not followed, could endanger the per- sonal safety and /or property of yourself and others. Read and follow all instruc- tions in this manual before attempting to operate or service this vehicle. When...

6 3 Know Your Utility Vehicle WARNING Never leave a running machine unattended. Always set parking brake, stop engine and remove key to prevent unintended starting. Know Your Utility Vehicle NOTE: Reference to right or left hand side of the utility vehicle is observed from the operating position. Re...

7 Horn Switch (Optional) The horn switch is located on the right side of the dash panel. Push button to activate horn. 12V Power Outlet The 12V power outlet is located on the right side of the dash panel. It is used for the convenience of plugging in accessories that require a power source with a ma...

8 in serious personal injury or death. Fuel Shut Off Valve The fuel shut off valve is located under the seat and it is strapped onto the fuel tank. It controls fuel to the engine. To turn fuel off, turn knob so indicator is down. To turn fuel on, turn knob to the up position. See Figure 5. Adjustabl...

9 4 Operation WARNING This is an off-road utility vehicle and it should not be operated on public highways. Know and comply with all laws and regulations governing the use of off-highway vehicles in your area. Do not run an engine in an enclosed area. Move the vehicle to an outside area before runni...

10 Manual Lift 1. Park the vehicle safely on level ground and set parking brake. 2. Empty cargo by hand and unlatch cargo box by pushing down on the cargo latch. See (A) Figure 13. 3. While holding the latch down, lift the cargo box (B). 4. Lower and allow bed to re-latch cargo box before operating ...

11 Dumping Load From Cargo Box 1. Back up the vehicle to the dump site and apply parking brake. 2. Unhook the tailgate from cargo box.3. If using an electric lift, raise cargo box to dump load and lower box when empty. WARNING: The center of gravity changes as a loaded cargo box is raised. Do not al...

12 Lubrication Front Axle Lubrication 1. Lubricate one grease fitting on each axle with 2 or 3 shots of grease every 50 hours. Engine Read the engine operator’s manual for any service or maintenance information pertaining to the engine. Filling Fuel Tank 1. Stop vehicle on a level surface and apply ...

13 NOTE: For high loads 8-10 psi is recommended for all tires. The recommended tire pressure while using the snow plow option is 8-12 psi in the front tires. Wheel Replacement WARNING: Using an unstable lifting device and vehicle support may result in bodily injury. Use a safe lifting device and sup...

14 Clutch Pulley (Rear) Drive Pulley(Front) 5. Check O-ring on drain plug and replace if missing or in poor condition. 6. Install and tighten drain plug. IMPORTANT: Dirt and debris in oil may cause damage to transaxle. Clean area around opening before removing oil cap.7. Remove oil cap and add appro...

15 Adjusting Brake To adjust the brakes: 1. Stop the vehicle on a level surface. 2. Turn the ignition key to the STOP position and remove the key. 3. Make sure the parking brake is released and the vehicle is in neutral. 4. Unlatch and move hood forward.5. Check to see if the equalizer bracket is in...

16 6 Service Chart DESCRIPTION MODEL NO. Horn 39A-101-100 Rear Electric Outlet 39A-102-100 Front/Rear Hitch 39A-103-100 Front Brush Guard 39A-104-100 Floor Mat 39A-105-100 Front Receiver (Requires Hitch) 39A-106-100 Canopy W/ 4 Post Frame 39A-108-100 72” Snow Blade (Requires 115 Bracket) 39A-109-100...

17 INFORMATION For parts or accessories, contact your local Cub Cadet dealer. To locate the dealer nearest you call 877-282-8684 or log onto www.cubcadet.com 8 Specifications Engine / Electrical Make 18HP*** Kohler Command ® Pro V-Twin OHV Type\Cylinders 4 Cycle Gas/2 Cylinders Displacement 38.0 cu. ...

18 ELECTRONIC SHIFT MODULE – FAULT CODE LIST If your unit does not shift properly, the ESM will let you know there is a problem using the following table of fault codes. Once you select a gear, the instrument panel will illuminate a gear light, or a combination of gear lights. These lights can be us...

19 9 ELECTRONIC SHIFT MODULE Fault Code List WARNING If the vehicle is shut off under a fault condition, before the vehicle will start again the Neutral Sensor must function properly AND the vehicle will have to be manually shifted into “NEUTRAL”. Figure 18 FAULT CODES DEFINED Code 1: “REVERSE” and ...

20 For repairs beyond minor adjustments or corrections, contact your nearest Cub Cadet service dealer or call 1-877-282-8684. If you would like to order a Service Manual, please call the Publications Department at 800-800-7310, and order Form# 770-0909G. 10 Trouble Shooting Possible Cause(s) Problem...

The limited warranty set forth below is given by CUB CADET LLC (“CUB CADET”) with respect to new merchandise purchased and used in the United States, its possessions and territories.CUB CADET warrants this product against defects in material and workmanship for a period of one (1) year for commercia...

The limited warranty set forth below is given by Cub Cadet LLC with respect to new merchandise purchased and used in the United States, its possessions and territories.“Cub Cadet” warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date o...