Cub Cadet 200 Series- Manuals

200 Series Single Stage Snow Throwers 3 3.4. Remove the bearing housing and bearing from the auger shaft. See Figure 3.4. NOTE: The left side (Drive Side) has a washer located between the auger housing and bearing. 3.5. Remove the three screws holding the right side bearing housing on with a 3/8” wr...

200 Series Single Stage Snow Throwers 4 5. CABLE REMOVAL 5.1. Remove the belt cover as described in the belt removal section of this manual to expose the Idler bracket. See Figure 5.1. NOTE: It is necessary to remove the idler bracket to remove the cable. 5.2. disconnect the return spring. See Figur...

200 Series Single Stage Snow Throwers 5 5.6. Pinch the tabs on the cable housing with a pair of needle nose pliers to free it from the holder on the frame. See Figure 5.6. 5.7. Cut the cable tie to release the cable from the handle bars. See Figure 5.7. Figure 5.6 Figure 5.7 5.8. If the cable is to ...

200 Series Single Stage Snow Throwers 6 6.2. Remove the three screws securing the front of the shroud to the auger housing using a 3/8” wrench. 6.3. Remove 4 screws (2 on each side) securing the shroud to the frame. 6.4. Lift the fuel tank up along withe wire brackets that are weaved in slots on the...

200 Series Single Stage Snow Throwers 7 8. FOUR-CYCLE MODELS 8.1. Some of the MTD single-stage snow throwers are powered by four-cycle Tecumseh Snow King Engines. They are very similar to the two-cycle version except for the engine and its mounting brackets. See Figure 8.1. 8.2. The four-cycle model...