Crosley 2212430 - Manuals

5 Electrical Requirements Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection: Recommended grounding method A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recommended that ...

6 6. Fasten shut-off valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the ¹⁄₄ in. drilled hole in the water pipe and that washer is under the pipe clamp. Tighten packing nut. Tighten the pipe clamp screws carefully and evenly so washer makes a watertight seal. Do not overti...

7 Refrigerator Doors: Removing, Reversing (optional) and Replacing TOOLS NEEDED: ⁵⁄₁₆ in. hex-head socket wrench, No. 2 Phillips screwdriver, flat-head screwdriver, ⁵⁄₁₆ in. open-end wrench, flat 2 in. putty knife. IMPORTANT: Before you begin, turn the refrigerator control OFF, unplug refrigerator o...

8 Door and hinge removal ⁵⁄₁₆ ” Hex Head Hinge Screw 1. Unplug refrigerator or disconnect power. 2. Open refrigerator door and remove base grille from the bottom front of the refrigerator (see Base Grille graphic). 3. Close the refrigerator door and keep both doors closed until you are ready to lift...

9 4. Use a screwdriver to adjust the leveling screws. Turn the leveling screw to the right to raise that side of the refrigerator or turn the leveling screw to the left to lower that side. It may take several turns of the leveling screws to adjust the tilt of the refrigerator. NOTE: Having someone p...

10 Setting the Control(s) For your convenience, the refrigerator controls are preset at the factory. Controls for the refrigerator and freezer are located in the top of the refrigerator section. When you first install your refrigerator, make sure that the control(s) are still preset. The control(s) ...

11 REFRIGERATOR FEATURES Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word “Accessory.” Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the tol...

12 To remove and replace the shelf track: 1. Remove the shelf track by lifting both sides of the track slightly and pulling the track straight out. 2. Replace the track by guiding the track hooks into the shelf support slots on the back wall. NOTE: Make sure that both sets of track hooks are in the ...

13 To replace crisper(s) cover: NOTE: Before reinstalling the cover, make sure the U-shaped reinforcement bar is reinstalled in the front edge of the crisper cover. 1. Fit back of cover frame into supports on side walls of the refrigerator and lower the front of the cover frame into place. 2. Slide ...

14 To turn the ice maker off: ■ Automatic turn off: As ice is made, the ice cubes will fill the ice storage bin, and the ice cubes will raise the wire shut-off arm to the OFF (arm up) position. ■ Manual turn off: Lift the wire shut-off arm to the OFF (arm up) position and listen for the click to mak...

15 Pull-out Freezer Floor (on some models) To remove and replace the freezer floor: 1. Lift both back “fences” up and out. 2. Remove the freezer floor by pulling it out about 1 in. (25.40 mm) with one hand around the air tower section (center back) and one hand at center front. 3. Lift up floor at r...

16 To adjust the utility compartment or tray: 1. Lift the front slightly and slide to desired position. 2. Lower front to lock into place. Flip-up Door Shelf (on some models) The shelf bottom flips up so you can store taller items in the door shelf below. When in the down position, the shelf is stro...

17 Power Interruptions If the electricity in your house goes off, call the power company and ask how long it will be off. 1. If the power will be out for 24 hours or less, keep both refrigerator doors closed to help food stay cold and frozen. 2. If the power will be out for more than 24 hours: a) Re...

19 There is interior moisture build-up ■ Are the air vents blocked in the refrigerator?Remove any objects from in front of the air vents. Refer to “Ensuring Proper Air Circulation” for the location of air vents. ■ Is the door opened often?To avoid humidity build-up, try to get everything you need ou...