Craftsman 536.886440- Manuals

ASSEMBLY Contents of Parts Bag (actual size) 1 - Owner’s Manual (not shown) 1 - Packet of Fuel Stabilizer (not shown) 1 - Warranty Card (not shown) 2 - Parts bags (not shown) *Non-Assembly Parts, found in toolbox located on belt cover 1- Screw, 5/16-18 X 2 in o 1-Split Lockwasher 1-Flatwasher11/32ln...

OPERATION KNOW YOUR SNOW THROWER READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with your SNOW THROWER to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Bedric lilton (right h...

OPERATION Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. 1. Fill the fuel tank only with a fresh, clean, unleaded regular, unleaded premium, or reformulated automo­ tive gasoline. DO NOT use leaded gasoline. Make sure that the con­ tainer you pour the...

MAINTENANCE CUSTOMER RESPONSIBILITIES SERVICE RECORDS Fill in dates as you complete regular service. Before Each Use Often Every 5 Hours Every 10 Hours Every 25 Hours Each Season Before Storage SERVICE DATES Check Engine Oil Level V V V Change Engine Oil V a / Tighten All Screws and Nuts V V Check S...

MAINTENANCE PRODUCT SPECIFICATIONS HORSEPOWER 11.0 HP DISPLACEMENT 21.82 cu. in. GASOLINECAPACITY 4 quarts (unleaded) OIL CAPACITY (20 oz capacity) 5W30 SPARK PLUG; Champion RJ19LM (Gap .030 in.) or equivalent VALVE CLEARANCE: Intake: .010 In, Exhaust: .010 In. SNOW THROWER AS REQUIRED The following...

SERVICE AND ADJUSTMENT A WARNING: Always discon­ nect the spark plug wire and place it where it cannot make contact with spark plug to pre­ vent accidental starting when mak­ ing any adjustments or repairs. TO ADJUST SKID HEIGHT This snow thrower is equipped with two height adjustment skids, located...

SERVICE AND ADJUSTMENT HOW TO CHECK AND ADJUST THE CABLES The cables are adjusted at the factory and no adjustment should be neces­sary. If the cables have become stretched or are sagging adjustment will be necessary. To check for correct adjustment,discon- nect the Z-fitting at the drive lever, mov...

SERVICE AND ADJUSTMENT 2. Be sure spark plug is clean and free of foreign material. Check elec­trodes gap with a wire feeler gauge and reset gap to 0.030” if neces­sary. See Figure 34. To Replace: 1. If you need a new spark plug, use only the proper replacement spark plug. 2. Set the gap to 0.030 in...

STORAGE A WARNING: Never store your snow thrower indoors or in an enclosed, poorly venti­ lated area. If gasoline remains in the tank, fumes may reach an open flame, spark or pilot light from a fur­ nace, water heater, clothes dryer, cigarette, etc. NOTE: To prevent engine damage (if snow thrower is...

TROUBLE SHOOTING TROUBLE CAUSE CORRECTION Difficult starting Defective spark plug. Replace spark plug. Water or dirt in fuel system. Use carburetor bowl drain to flush and refill with fresh fuel. Engine runs erratic Blocked fuel line, empty gas tank, or stale gasoline Clean fuel line; check fuel sup...

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 FRAME ASSEMBLY 12 13 41 42 43 44 45 53 54 57 58 59 60 63 67 68 69 SCREW, 5/16-18 WASHER, SPTLK .31X.58X.08 GUIDE. ROD BELT PLASTIC WASHER WASHER, SPTLK .31X.58X.08 SCREW, 5/16-24X 1.00 SPACER PULLEY, HALF WASHER. FLAT .752X.91X.02 BELT, V3L 33.13LG FLATWASHE...

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 ELECTRIC START ASSEMBLY REF. ENGINE 319051 Key No. Description Part No. 6 MOTOR, STARTER 330783 7 SCREW 762226 8 SCREW 6217 9 CORD, STARTER 6219 F-001087J 31

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 GEAR CASE ASSEMBLY Key No. Description Part No. 300 CASE, GEAR, RH 10577 301 CASE. GEAR, LH 10576 303 SCREW, 1/4-20X.75 710025 304 NUT.1/4-20 302635 305 NUT, 1/4-20 HEXKEPS 303008 306 SCREW, 3/8-16X.50 9344 310 SEAL, OIL 9566 311 BEARING, FL 50304 312 WASHER...

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 DRIVE COMPONENTS 192 190 225 226 230 313995 REV P F-001087J 34

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 AUGER HOUSING ASSEMBLY 339972 F-001087J 36

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 DISCHARGE CHUTE ASSEMBLY 337160 F-001087J 38

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 HANDLE ASSEMBLY

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 WHEEL ASSEMBLY 679 REF. LEFT WHEEL 676 655 REF. RIGHT WHEEL Key No. Description Part No. 650 SHAFT, AXLE 580883 652 SPRKT & HUB 583012 653 SCREW, 1/4-20X2.25 73839 654 NUT, 1/4-20 HEX NYLOCK 780029 655 BRNG, FL 581730 656 CHAIN, ROLLER 579867 LINK, CHAIN...

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 SHIFT YOKE ASSEMBLY Key No. Description Part No. 790 ROD, SHIFT 581631-853 791 SCREW, 1/4-20X.75 302628 792 NUT, 1/4-20 REGHEXCTRLK 73826 795 NUT. 1/2-13 HEXJAM 318486 796 KNOB, SHIFT 304438 800 LEVER, SPRING SHIFT 760564 801 SCREW, 1/4-20X.75 302628 802 NUT...

CRAFTSMAN 24” 5HP SNOW THROWER 536.886440 CHUTE CONTROL ROD ASSEMBLY 856 Key No. Description Part No 850 CRANK, ASSY CHUTE 585426 854 HANDLE, CHUTE CRANK 307399 855 FLATWASHER .39X.70X.05 309312 856 E RING 578159 860 EYE BOLT 3/8-16X6.00 581618 861 GROMMET. EYE BOLT 148 862 BOOT 308145 863 NUT. 3/8-...

For the repair or replacement parts you need delivered directly to your home Call 7am-7pm, 7days a week 1-800-366-PART (1-800-366-7278) Para ordenar piezas con entrega a domicìlio -1-800-659-7084 For in-house major brand repair service Call 24 hours a day, 7days a week 1-800-4-REPAIR (1-800-473-7247...