Compaq W25 - Manuals

2/221 02-FGB 101 327 Uen B – November 2007 5 2.2 VoIP network The basic building blocks for Voice and Fax over IP are a SIP server and a PSTN gateway with T.38 support. Sometimes the PSTN gateway might consist of two units; Media Controller and Media Gateway. Normally a Session Border Controller (SB...

2.2.2.2 Media Gateway (MGW) The Media Gateway (MGW) provides interworking between PSTN and IP media streams, i.e. conversion between circuit-switched TDM (Time Division Multiplexing) bearer circuits and packet-switched media streams (RTP). 2.2.3 Session Border Controller (SBC) The SBC can also be ca...

2.4 T.38 and T30 Protocol There are two protocols used to transfer a fax over IP; T.30 [2] and T.38 [3]. T.30 is the protocol that describes the communication process between two fax machines on a circuit-switched network. T.38 is the protocol that describes the process for sending and receiving fax...

3 Ericsson W25 The Ericsson W25 will work as a gateway, using T.38 protocol. The fax terminal shall be connected to the dedicated fax port on the Ericsson W25. Associated to this fax port is a SIP User Agent, which manages and controls the media streams by using the SIP protocol (RFC 3261) towards t...

3.3.2 Echo Canceller To improve the fax transfer the Ericsson W25 also has an echo canceller in accordance with G.168. 3.3.3 QoS The outgoing VoIP related traffic will be prioritized before other traffic from the Ericsson W25 to reduce the uplink delay and jitter. 3.4 Interoperability The Ericsson W...

4 W25 Configuration For configuration purpose, the Ericsson W25 includes a CLI (Command Line Interface) and a WUI (web user interface) which are accessible as illustrated in the figure below. Please also see the document “Ericsson W25 Administrator’s Guide” for more details on Ericsson W25 configura...

• user id , which is the public user identification e.g. the phone number xxxxx • password, which is the password for the user id 4.1.1.1 CLI commands The W25 has already one User Agent configured by default, so this needs to be modified. The commands to modify are: cf set ims.user_agent[0].auth_id ...

Note if the proxy[x].address is set to “localhost”, the W25 will not register to any SIP server. To display the entries in the call server, use the following command cf show ims.callserver ims.callserver[0].domain "server.com" .proxy[0].address "host.server.com" .port 5060 .outbound_...

It’s recommended to not enable “extended_roundtrip”, since it has been shown that this cause interoperability problems. Not all gateways support recovery packets, but then the recovery packets will be ignored. Note that at the same time as the recovery_packets is increase, the bandwidth requirement ...

5 References [1] Internal System Description IMT (IMS Multimedia Telephony) 3.01551-HSC 113 03/4 Uen [2] T.30 Procedures for document facsimile transmission in the general switched telephone network [3] T.38 Procedures for real-time Group 3 facsimile communication over IP networks 2/221 02-FGB 101 3...

6 Acronyms and Abbreviations CDMA Code Division Multiple Access CLI Command Line Interface DNS Domain Name System E.164 International Public Telecommunication Numbering Plan as described in the ITU-T Recommendation E.164. FoIP Fax over IP FWT Fixed Wireless Terminal GSM Global System for Mobile Comm...

7 Appendix A This chapter describes the test results for the End-to-End T.38 interoperability tests that has been performed on the T.38 implemented in W25. The list includes all successful fax machines (The list has the following format: Fax machine, Profile and Speed) AT/T PPF200 MMR, ECM, 200x100 ...