Coleman 9971-A50 - Manuals

Grill Assembly continued 9. Remove plastic cap from top of propane bottle and turn propanecylinder clockwise into regulator until hand tight. (Fig. 9 & 10) 10. Never operate grill with propane cylinder in an inverted position.(Fig. 11) 8 Fig. 9 Fig. 10 Fig. 11 Leak Check • Perform leak test outd...

9 • Do not attempt to operate this grill until you have read and understood all General Safety Information in this manual and all assembly is com-plete and leak checks have been performed. • Never ignite grill with lid closed. Operation Fig. 13 Fig. 12 DANGER DANGER • CARBON MONOXIDE HAZARD • For ou...

10 To Light NOTE: A gap of 1/8” should be maintained between the endof the wire on the electrode and the burner tube for properignition spark. (Fig. 15) 1. Set on sturdy, flat surface. 2. Grasp end of wire with a needle nose pliers and carefully bendto adjust to proper spacing from burner tube (Fig....

11 G OOD Yellow Blue Holes in Burner Blue Yellow B AD Fig. 18 To Light continued To Match Light (continued) 4. A good flame should be blue with minimal yellow tip. Someyellow tips on flames are acceptable as long as no carbon orsoot deposits appear. (Fig. 18) NOTE: If the burner flame is accidentall...

12 To Clean continued 5. Optional Griddle has a non-stick coating. Use only nonmetallicutensils to prolong life of non-stick coating. 6. To reduce sticking and improve clean-up, spray cooking surfacewith vegetable oil prior to lighting grill. 7. Wipe clean with soft cloth and mild dish detergent. Do...

13 1. For storage or transport, regulator may be located below grate.(Fig. 25 & Fig. 26) 2. Make sure lid is latched and carry grill with handle as shown.(Fig. 27 & 28) 3. Always store grill in a clean, dry location. DANGER • EXPLOSION - FIRE HAZARD • Never store propane near high heat, open...

14 Trouble Shooting Guide Problem Possible Cause Possible Solution Burner will not light Igniter electrode covered with Clean igniter electrode with igniter grease or residue Igniter/electrode too far from Adjust electrode until proper burner spark appears (see page 11) Igniter/electrode wire loose ...

15 Replacement Parts List — 9971 Series No. Description Part Number 1 Grill Grate 5010000092 2 Heat Tent (1 pk.) 5010000093 3 Thermometer Assembly 5010000091 4 Regulator 5010000090 5 Rubber Leg Pads (4 pk.) 5010000095 6 Igniter/Piezo/Wire Assembly (2 pk.) 5010000089 7 Grease Tray 5010000094 3 5 4 7 ...

16 9971-050 (20070628) The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, KS 67219 U.S.A. 1-800-356-3612 • TDD: 316-832-8707 © 2007 The Coleman Company, Inc. All rights reserved. Coleman® and are registered trademarks and InstaStart™ and Shoreside™ are trademarks of The Coleman Company, Inc...