Coleman 5040-761 - Manuals - manualsarea.com

Page 2 - For Outdoor Use Only

This manual contains important information about the assembly, opera- tion and maintenance of this portable heater. General safety information ispresented in these first few pages and is also located throughout the man-ual. Particular attention should be paid to information accompanied by thesafety ...

Page 3 - General Safety Information; Assembly; DANGER

3 General Safety Information continued. • CARBON MONOXIDE HAZARD • This heater is a combustion appliance. All combustion appliancesproduce carbon monoxide (CO) during the combustion process. Thisproduct is designed to produce extremely minute, non-hazardousamounts of CO if used and maintained in acc...

Page 4 - Hex Nut; Step 1

4 Assembly ■ Identify Center Rear Support Bracket. It has six holes, various sizes. ■ Place Center Rear Support Bracket in place over the centerscrew. ■ Assemble one nut loosely over the screw to attach the CenterRear Support Bracket. ■ Turn unit over and assemble large screw loosely through CoverPi...

Page 5 - Step 3

5 Assembly continued. Step 3 (continued) Step 4 (continued) Step 4 ■ Set cylinder cover assembly on top of heater base. Position openingopposite the wheels. ■ Tighten all fasteners. Use a #2 Phillips screwdriver to tighten allscrews. Use a 7/16" open endwrench to tighten all hex nuts. Step 5 ■ A...

Page 9 - Leak Check; WARNING; Connection; Mantles

9 Leak Check WARNING • Perform all leak tests outdoors.• Extinguish all open flames.• NEVER leak test when smoking.• Do not use the heater until all connections have been leak tested and do not leak. ■ Lift cover while installing remaining cylinder cover section. Hose/Regulator Connection Regulator/...

Page 10 - Operation; Lighting Instructions for HEATER; Battery Installation for HEATER

Operation 10 Lighting Instructions for HEATER 1. Push in and rotate (counter clockwise) heater control knob to thePilot position and release.2. Push in on heater control knob and push Igniter Button to ignitePilot Light. Note: Initial lighting after gas cylinder change can take up to two (2) minutes...

Page 11 - Match Lighting Instructions for HEATER

11 Match Lighting Instructions for HEATER 2. Push in and rotate (counter clockwise) Heater Control Knob to the Pilot position and release. 3. Use a long match. Locate Pilot Port directly above center glass panel.4. Light a long fireplace match (minimum 4" long) and insert into Pilot Port, then p...

Page 12 - Match Lighting Instructions for LIGHT; Storage; Maintenance; LIGHT

Operation continued. 1. Turn cylinder valve on. Match Lighting Instructions for LIGHT 2. Remove front glass. 3. Place a lighted match near mantle, then push in and rotate LightControl Knob to the ON position. Immediately light second mantle withmatch. Note: If BOTH mantles are not lighted within 5 s...

Page 13 - Service

Problem Possible Cause Solution Pilot won’t light Cylinder valve is closed Open valve Blockage in orifice or pilot tube Clean or replace orifice or pilot tube Air in gas line Pilot may take 1-2 minutes to light after a propane bottlehas been connected Low gas pressure with Cylinder Valve Cylinder is...

Page 15 - Replacement Parts - Table; Parts List

15 Replacement Parts - Table Parts List No. Part No. Description 1 5040-1031 Table Assembly (Painted, Pewter) 5040-1071 Table Assembly (Painted, Silver Vein) 2 5040-1032 Table Support & Hardware (Painted, Pewter) 5040-0871 Table Support & Hardware (Painted, Silver Vein) 3 5040A1033 Clamp (Pa...

Page 16 - Warranty; Coleman Limited 5-Year Warranty; WHAT IS NOT COVERED; IMPLIED WARRANTIES

16 5040-034 (10/03) ® The Coleman Co., Inc. • 3600 N. Hydraulic Wichita, KS 67219 U.S.A. 1-800-835-3278 • TDD: 316-832-8707 ©2003 The Coleman Company, Inc. All rights reserved. Coleman® is a registered trademark of The Coleman Company, Inc. Warranty Coleman Limited 5-Year Warranty Coleman will repai...

Coleman 5040-761 - Manuals

Manuals:

Manual Coleman 5040-761

Summary

Coleman Manuals