Cobra 29 LTD BT - Manuals

ANT The CB/PA button should be in the CB position. Operation 9 Operation Turning On Setting ChannelSelector 8 Turning On Make sure the power cord, antenna andmicrophone are connected to their properconnectors before starting. Setting Channel Selector 2 1 Rotate the On/Off Volume knob clockwise to a ...

Operation 13 Operation 12 Note The reading will be slightlyhigher on Channels 1 and 40compared to Channel 20. Note When switched to SWR positionthe meter needle should ideallybe as far to the left as possible.Anything over 3 is not acceptable.The antenna indicator will light.A slight antenna heighta...

Operation Operation Bluetooth ® 15 14 Bluetooth Calls on a Bluetooth enabled cell phone can berouted through the 29 LTD BT speaker or externalspeaker accessory. To Pair with a Cell Phone With 29 LTD BT power On, press and hold the BT Buttonfor six seconds to enter Standby mode. A tone will soundand ...

ANT/ Operation 17 Operation 16 Switch to NOR to select desired channel. 1 Selecting AChannel Selecting A Channel ANT/ NB-ANL/ANL/OFF (NoiseBlanker /AutomaticNoise Limiter)Switch Note The RF noise blanker is veryeffective in reducing repetitivenoises such as ignitioninterference. When switched to ANL...

The S/RF-SWR-CAL switch must be in the S/RF position to read the meter. 1 S-Meter S-Meter Swings proportionately to strength of incomingsignal when receiving. Operation Operation 19 18 RF Gain Control RF Gain Control The RF Gain is used to optimize reception instrong or weak signal areas. Note The R...

Full clockwise rotation closes the gate allowing only very strong signals to enter. Full counterclockwise rotation opens the “gate” allowing all signals in. To achieve the Desired Squelch Setting (DSS),turn the Squelch control counterclockwise until you hear noise. Now turn the control clockwise jus...

Setting Dynamike® This controls the microphone sensitivity(outgoing audio level). To Transmit 23 To Transmit Transmit TalkBack 22 SettingDynamike ® Caution! Be sure the antenna is properlyconnected to the radio beforetransmitting. Prolongedtransmitting without anantenna, or a poorly matchedantenna, ...

Operation Operation PA (PublicAddress) 25 24 PA (Public Address) Connect an external PA speaker to the PA jackon the rear panel. Set CB/PA switch to PA position. Push and hold microphone button and speak in a normal voice. Your voice will now transmiton the PA speaker. Adjust PA speaker volume with ...

Temporary Mobile Set-Up 27 Base StationOperation(From 120V ACHouse Current) TemporaryMobile Set-Up Temporary Mobile Operation For temporary mobile operation you may want topurchase an optional automobile power adapterfrom your COBRA dealer. This adapter and amagnetic mount antenna allow you to quick...

How Your CB Can Serve You How Your CB Can Serve You 29 28 The FCC gives these examples of permitted andprohibited messages for channel 9. These areonly guidelines and not all-inclusive: Permitted Example Message Yes “Tornado sighted six miles north of town.” No “Post number 10. No tornado sighted.” ...

How Your CB Can Serve You How Your CB Can Serve You 31 30 Code Meaning 10-29 Time is up for contact 10-30 Does not conform to FCC rules 10-33 Emergency traffic 10-34 Trouble at this station 10-35 Confidential information 10-36 Correct time is 10-37 Wrecker needed at 10-38 Ambulance needed 10-39 Mess...

Optional Accessories 35 Replacement DC Power Cord For in vehicle use426-002-N-001 Replacement MountingBracket For in vehicle use251-353-9-001 Replacement Thumb Screws For in vehicle use634-081-9-001 Replacement MicrophoneBracket For in vehicle use741-080-9-001 Limited One Year Warranty 34 COBRA ELEC...

Dynamic External Speaker HG S100 Noise Canceling ExternalSpeaker HG S300 Noise Canceling With TalkBack External Speaker HG S500 Optional Accessories You can find quality Cobra products and accessories atyour local Cobra dealer, or in the U.S.A., you can orderdirectly from Cobra. See ordering info on...