Page 2 - Not for use with LP gas; DANGER
WARNING FOR YOUR SAFETY1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity ofthis or any other appliance. 2. An LP Tank not connected for use shall not be stored in the vicinity of this or any otherappliance. FOR YOUR SAFETYIf you smell gas:1. Shut off gas to the ap...
Page 4 - Part
4 • 4638234 Parts List - Model 4638234 Key Qty. Description Part # . . . . . . . . . . A 1 Condiment Wire . . . . . 4151005 B 2 Tent Frame . . . . . . . . . 4151014 C 1 Griddle . . . . . . . . . . . . 4152038 D 1 Cooking Grate, 12” . . . 4152045 E 1 Cooking Grate, 15” . . . 4152046 F 1 Chef’s Delite...
Page 6 - To prevent scratching, lay grill on packing material to assemble.; Lower Panel inserts into Upper Panel
NOTE: To prevent scratching, lay grill on packing material to assemble. 1 2 6 • 4638234 Qty: 2 Items to Assemble:2 Wheels1 Tank Bracket2 Axle Bolts2 Hitch Pins2 Hub Caps2 Control Knobs Qty: 2 Wheel attachesto BOTTOM HOLEon legs Hub on wheel faces into leg. Attach inbottom hole on leg with axle bolt ...
Page 7 - Stand Car t Upright; four tabs are
4 3 4638234 • 7 Stand Car t Upright Items to Assemble: 1 Left Shelf2 3/4” Carriage Bolts2 Wing Nuts, Metal2 Wing Screws, “AB” point Qty:2 MetalQty: 2 Qty: 2End hassharp point“AB” View looking down Insert 3/4” Carriage Bolts into bracketon Legs Make sure all before fastening four tabs are inside slot...
Page 8 - st Remove styrofoam pad; Shield
2nd: Shield 3rd: Tent Frame 4th: Burner Tent Grates Griddle 6 5 8 • 4638234 1st Remove styrofoam pad Items to Assemble:2 Tent Frames2 Burner Tents2 Grates 1 Griddle 1 Shield Qty: 2 Items to Assemble:1 Grill Lid2 Hinge Pin2 Hitch Pin Qty: 2 Hinge Pinand Hitch Pin Qty: 2 Items to Assemble:1 Logo Plate...
Page 9 - Back of Grill; Place end of chain through hole, reattach coupling to end of chain.; See Use & Care Manual for; Eyelet End; Remove coupling from chain
Items to Assemble:2 Chains with Coupling1 Match-Holder 8 7 4638234 • 9 Items to Assemble1 Chef’s Delite2 Swing Grid Bolts2 Wing Nuts, Metal Qty: 2 MetalQty: 2 Back of Grill Place end of chain through hole, reattach coupling to end of chain. Thread eyelet on second chain into loop of match holder. Se...
Page 10 - CAUTION; • Failure to install can in clip will cause hot; View of underside of Grill Bottom; Clip
B A 9 10 • 4638234 10 Center ofgrill bottom Grease clip CAUTION ! • Failure to install can in clip will cause hot grease to drip from bottom of grill with risk of fire or property damage. Hang grease clip from center of grill bottom.Use an empty soup can (not included) to hang from grease clip. Item...
Page 11 - Connecting Your Grill to the Natural Gas Source; Coat pipe nipple with gas resistant dope. Screw socket onto; • Connection to gas source must be done by a certified; WARNING; • Do not use hard metal piping of any kind to connect this
Connecting Your Grill to the Natural Gas Source 1. Coat pipe nipple with gas resistant dope. Screw socket onto gas manifold at gas source (A). 2. Connect unattached end of natural gas hose to socket. Push sleeve back on socket (B) and insert plug until sleeve snapsforward, locking plug into socket. ...
Page 12 - Leak Testing Valve and Hose; bubbles appear, there is a leak. Turn gas off at; Safety Tips; be attached to grease clip and emptied; For Safe Use of Your Grill and to Avoid; Before Your First Cookout; • Light burners, check to make sure they are lit, close the lid
WARNING • Do not use grill until leak checked.• If leak is detected at any time, STOP and call the Fire Department. • If you cannot stop a gas leak, immediately close LP tank Valve and call LP gas supplier or your fire department! Leak Testing Valve and Hose 1.2. Check to make sure grill is connecte...
Page 13 - Match Lighting; Troubleshooting Section; HIGH; See following pages for specific
Ignitor Lighting s s Do not lean over grill while lighting.Open lid during lighting. OFF Do not lean over grill while lighting. Open lid. 1. Turn on gas at gas source. 2. To ignite any burner, turn burner knob to HI, turn ROTARY IGNITOR button rapidly. 3. If ignition does NOT immediately take place,...
Page 14 - Cleaning the Burner Assembly; Remove cooking grates, burner tents and tent frames.; Turn gas off at control knobs and gas source.; Reattach soup can to grease clip under grill bottom.; Valve
Cleaning the Burner Assembly Follow these instructions to clean and/or replace parts of burnerassembly or if you have trouble igniting grill. 1.2. Remove cooking grates, burner tents and tent frames. 3. Under grill remove soup can from grease clip. 4. Beneath grill bottom remove ignitor wires by pul...
Page 15 - Cooking Chart; Food Safety; “Cleaning Burner
Cooking Chart Cooking times and temperatures may vary according to specificrecipes, cooking conditions or barbecue equipment used. Takethese factors into consideration to insure best results. If you usethe indirect cooking method (lighting only one burner and placingfood on opposite side of cooking ...
Page 16 - Troubleshooting; Problem
Troubleshooting Problem Burner will not lightusing ignitor. Burner(s) will notmatch light. Flames blow out. Flare-up. Persistent greasefire (can damagethe appearance ofsteel panels andaluminum castingson the grill). Flashback...(fire in burner tube(s) Possible Cause Wire covered with cookingresidue....