Char-Broil 4539937 - Manuals

Char-Broil 4539937 – Manual in PDF format online.

Manuals:

Manual

Manual Char-Broil 4539937

Summary

Page 2 - TABLE OF CONTENTS; DANGER; WARNING; Safety Symbols; • To order non-warranty replacement parts or accessories; USE AND CARE

2 For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Parts List/ Parts Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Main Burner Assembly. . ...

Page 3 - Wash your hands after handling this product.; National Fuel Gas; CAUTION; Food Safety; For more information call: USDA Meat and Poultry Hotline; How To Tell If Meat Is Grilled Thoroughly

3 WARNING CALIFORNIA PROPOSITION 651. Combustion by-products produced when usingthis product contain chemicals known to the State ofCalifornia to cause cancer, birth defects, and otherreproductive harm. 2. This product contains chemicals, including leadand lead compounds, known to the State ofCalifo...

Page 4 - LP Cylinder Removal, Transport and Storage; Failure to use; Do not store an LP cylinder in an area where children play.; NEVER; Do not store or use gasoline or other; USDA Safe Minimum Internal Temperatures; *United States Department of Agriculture

4 LP Cylinder Removal, Transport and Storage 1. Failure to use safety cap as directed may result in serious personal injuryand/or property damage. 2. 3. Turn OFF all control knobs and LP cylinder valve. Turn couplingnut counterclockwise by hand only - do not use tools to disconnect.Loosen cylinder s...

Page 5 - LP Cylinder Exchange; OPD Hand Wheel; LP cylinder in upright position for vapor withdrawal; LP Cylinder

5 If “growing” bubbles appear do not use or move theLP cylinder. Contact an LP gas supplier or your firedepartment! WARNING LP Cylinder Exchange LP Cylinder Leak Test Exchange your cylinder only for an OPD safety feature-equipped cylinder as described inthe “LP Cylinder” section of this manual. Leak...

Page 6 - STOP; and call the fire; Do not insert any tool or foreign object into the valve outlet; Full Stop; Safety Relief Valve; Connecting Regulator to the LP Cylinder

6 Straight STOP Outdoor gas appliance is not intended to be installed inor on a boat.Outdoor gas appliance is not intended to be installed inor on an RV.Never attempt to attach this grill to the self-contained LPgas system of a camper trailer or motor home.Do not use grill until leak-tested.If a lea...

Page 7 - use in; Leak Testing Valves, Hoses and Regulator; Turn all control knobs to the OFF position.; rushing sound

7 For Safe Use of Your Grill and to Avoid SeriousInjury: NEVER -Use grill at least 3 ft. from any wall or surface. Apartment Dwellers: NEVER attempt to light burner with lid closed. Abuildup of non-ignited gas inside a closed grill ishazardous. Never operate grill with LP cylinder out of correctposi...

Page 8 - Safety Tips; “Troubleshooting Section”; Emitter Plate Brackets

8 Ignitor LightingDo not lean over grill while lighting.Light burners one at a time. 1. Turn all Gas Burner Control Valves. 2. Turn gas source or tank. 3. Open lid during lighting.4. To ignite turn burner control valve to .5. Push and hold button until the burner lights. 6. If ignition does not occu...

Page 10 - Storing Your Grill; “Cleaning the; Stainless steel surfaces:; Cleaning the Burner Assembly; Turn gas OFF at control knobs and LP cylinder.

Correct engagement Reinstall Screws NOTE: We suggest three ways to clean the burner tubes. Use the one easiest for you. A. Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run the hook through each burner tubeseveral times. B. Use a narrow bottle brush with a flexible han...

Page 11 - Connecting Your Grill to the Natural Gas Source.; Figure A; Do not use flexible gas hose supplied for Drop-in Models.

Connecting Your Grill to the Natural Gas Source. 1. 2. Figure A A professionally-installed shut-off valve between the supply pipingand the socket is recommended, but not required, by the NationalFuel Gas Code. Socket connection must be made outdoors. Coat the gas supply pipe nipple with gas resistan...

Page 12 - Tools required for assembly:; Orifice Driving Tool - Provided

PARTS LIST/DIAGRAM Key Qty. Description Part No. A . . . . . 3 . . . . . Main Burner Natural Gas Bezel. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80004350B . . . . . 1 . . . . . Sideburner Natural Gas Bezel. . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 13 - Main Burner Conversion; Grease Pan; Remove LP tank Heat Shield; Note: The rear of the

Main Burner Conversion 1 - - Next, from rear of grill, remove grease pan.. First, make sure all control knobs are in the OFF position, LP tank valve is closed, and tank is disconnected from regulator andremoved from grill. Grease Pan 2 Remove LP tank Heat Shield - Open the cabinet doors. Remove any ...

Page 14 - Remove Grill Bottom Pan; Remove LP Orifices; . Repeat for each Orifice

3 Remove Grill Bottom Pan - Using a #2 Phillips screwdriver, remove the six #8x3/8” screws that attach the Grill Bottom Pan to the underside of grill - Holding the front of the Grill Bottom Pan, rotate it down and pull it forward to remove it. - Place the Grill Bottom Pan on the bottom shelf for sto...

Page 16 - Natural Gas Bezel

Main Burner Conversion (Cont.) 7 - Using a #2 Phillips screwdriver, reinstall the two #8x3/8” screws that attach the Orifice Holder to the burner flange . Repeat for each Orifice Holder. DO NOT over-tighten the Orifice Holder screws. Re-install 2 #8x3/8”screws intoBurner Flange. Orifice Holder Burne...

Page 17 - Reinstall Grill Bottom Pan; Natural Gas Hose Conversion

Main Burner Conversion (Cont.) 9 Reinstall Grill Bottom Pan - Holding the front of the Grill Bottom Pan, rotate it up and push it backwards to reposition the Grill Bottom Pan. - Using a #2 Phillips screwdriver, reinstall the six #8x3/8” screws that attach the Grill Bottom Pan to the underside of gri...

Page 18 - Reinstall LP tank Heat Shield; Manifold

12 Reinstall LP tank Heat Shield - Insert tabs without screw holes(at rear of heat shield) into back panel slots. - Align the tabs with screw holes at the front of the heat shield to the door brace. - Carefully insert the #8x3/8” screws through the tabs and into the door brace.. - Using a # 2 Philli...

Page 19 - Reinstall Grease Pan; Sideburner Conversion

Main Burner Conversion (Cont.) Reinstall Grease Pan - Reinstall Grease Pan into the rear of the grill. 13 Grease Pan - Open the sideburner cover. Remove the cooking grate. - Pull the sideburner control knob off the valve stem. Remove the existing bezel by removing the two screws and two lock washers...

Page 20 - Shown in illustration A.; Shown in illustration B.; Sideburner; Sideburner Valve; Orifice Driving Tool; Sideburner Fascia; Sideburner Drip Pan

- Remove the wingnut from the burner as Shown in illustration A. - Remove the Ignitor wire from the electrode as - Remove the burner from the sideburner pan as Shown in illustration B. Shown in illustration C. Sideburner Conversion (Con’t.) 15 Wingnut A Sideburner C Electrode SideburnerI gnitor Wire...

Page 21 - Proper Alignment

Sideburner Sideburner Drip Pan 17 - Reinstall the burner as Shown in illustration A. - Make sure the burner tube is properly aligned with the sideburner valve as - Reinstall the wingnut to the burner stud. Attach the ignitor wire to the electrode as Shown in illustration B. Shown in illustration C. ...

Page 22 - Possible Cause

EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Gas leaking fromcracked/cut/burnedhose. Possible Cause • Damaged hose. Prevention/Solution • Turn off gas at at source. If anything but burned, replace parts. If burned, discontin...