Page 2 - Safety Symbols; Indicates an imminently hazardous situation; WARNING; Indicates an potentially hazardous situation; CAUTION; DANGER; and immediately call your fire department.; DANGER; of any flammable liquid.; CAUTION; TABLE OF CONTENTS
DANGER Safety Symbols The symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING WARNING: Indicates an p...
Page 3 - Wash your hands after handling this product.; Installation Safety Precautions; National Fuel Gas
WARNING CALIFORNIA PROPOSITION 651. Combustible by-products produced when using this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. 2. This product contains chemicals, including lead and lead compounds, known to the State of Ca...
Page 4 - ppliance; Cleaning the; Grease Tray; “For Best Results”; USDA Recommended
Food Safety Food safety is a very important part of enjoying the outdoor cooking experience. To keep food safe from harmful bacteria, follow these four basic steps: Clean: Wash hands, utensils, and surfaces with hot soapy water before and after handling raw meat and poultry. Separate: Separate raw m...
Page 5 - USE AND CARE; OPD Hand Wheel
• NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cylinder beyond 80% full. • An over filled or improperly stored cylinder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property d...
Page 6 - Connecting Regulator to the LP Cylinder; full stop; Safety Relief Valve; Strap and Cap; LP Cylinder Exchange; Exchange your; LP Cylinder Leak Test; For your safety
WARNING If “growing” bubbles appear do not use or move the LP cylinder. Contact an LP gas supplier or your fire department! Connecting Regulator to the LP Cylinder 1. LP cylinder must be properly secured onto . (Refer to assembly section.) 2. Turn all control knobs to the OFF position. 3. Turn LP cy...
Page 7 - Leak Testing Valves, Hose and Regulator; rushing sound; immediately
6. Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools. NOTE...
Page 8 - Keep fuel supply hose away from any heated surfaces.
24” 3 ft. 3 ft. WARNING CAUTION • Putting out grease fires by closing the lid is not possible. This a ppliance is well ventilated for safety reasons. • Do not use water on a grease fire. Personal injury may result. If a grease fire develops, turn knobs and LP cylinder off. • Do not leave appliance u...
Page 9 - Troubleshooting Section
CAUTION If ignition does NOT occur in 5 seconds, turn the control knob OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury. Turn control knob and LP cylin...
Page 10 - VERY IMPORTANT: Burner tube must re-engage over valve; Cleaning the Burner Assembly
Cleaning the Burner Assembly (Continued) 9. Clean inner burner as recommended below, shown E . We suggest three ways to clean the burner tube. Use the oneeasiest for you. (A) Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run hook through burner tube severaltimes. (B) U...
Page 11 - ITEMS MANUFACTURER WILL NOT PAY FOR:; DISCLAIMER OF IMPLIED WARRANTIES and LIMITATION OF REMEDIES; LIMITED WARRANTY; SCOPE OF COVERAGE
This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated...
Page 13 - ASSEMBLY; Carefully turn the unit upside down.; the valve engages the burner tube. shown; Figure A; Hold Heat Shield in place while attaching Control Panel
ASSEMBLY 2 1 Tools required for assembly: Phillips Screwdriver (Not Supplied); Small Adjustable Wrench (Not Supplied) • Carefully turn the unit upside down. Slide Heatshield into place over the exposed burner tube. • Align hole inHeat Shieldwith end of Burner Tube Heat Shield in Position • While hol...
Page 14 - Figure B; Windshield; Ignitor; • Attach round end of ignitor wire to electrode.
IgnitorWire The windshield is held in place once the legs are attached. 3 • The ignitor wire is factory installed to the ignitor. Pass the loose end of the wire through the hole in the body, shown Figure A • Place Windshield inside the bottom of the body. NOTE: Fasteners are not required for the win...
Page 15 - Slide the grease tray into the rear of the unit.; Grease tray; Install the control knobs on to the valve stem and the ignitor stem.; Control
4 • Install legs by engaging leg tabs over bottom edge of the appliance body. • • Slide the grease tray into the rear of the unit. • Once the leg is in place, attach two #10-24x1" screws through the leg and into the appliance body. • Repeat for the remaining legs.When all four legs are securely ...
Page 16 - Fiber Washer; Fiber Washer; Repeat for opposite side.; LH Hinge
Page 16 Qty: 8 #10-24x3/8" Screw Qty: 4 #10-24 Keps Nut Qty: 8 Fiber Washer 7 • Attach the hinges to the lid inserting a #10-24x3/8" screw into hinge, install a fiber washer onto screw, align lid onto screw, install fiber washer from inside the lid, and finally secure with a #10-24 Keps nut....
Page 17 - Accessory Use and Storage
Accessory Use and Storage Cooking Basket NOTE: Before cooking on your appliance for the first time, refer to the separate Cooking Guide on how to prepare the appliance for cooking. It is recommended that you season your appliance prior to cooking . • Once seasoning is complete, the appliance is now ...
Page 18 - Half Rack Storage; Accessory storage; Hanging hooks; Hole; Smoker Box Storage; Slot; Smoker Box
Half Rack Storage Accessory Use and Storage Accessory storage Accessory items such as the cooking grate, smoker box and half racks can be stored on board the Smoker, Roaster, & Grill as shown. Hanging hooks Hole Cooking Grate Storage Smoker Box Storage Slot Smoker Box The Smoker Box has a clip t...
Page 19 - Troubleshooting
EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Problem Gas leaking from cracked/cut/burned hose. Gas leaking from LP cylinder. Gas leaking from LP cylinder valve. Gas leaking between LP cylinder and regulator connection. Fire ...
Page 20 - continued; Possible Cause
Troubleshooting ( continued ) Possible Cause • Rotary knob rotates without clicking. • Sparking between ignitor and electrode. • See “GAS ISSUES:” on previous page. • Match will not reach. • Improper method of match-lighting. • Out of gas. • Excess flow valve on regulator tripped. • Vapor lock at co...
Page 21 - Notes