Char-Broil 3201560 - Manuals

Page 2 - No need to go back to the store!; Call Our Help Line; IS

STOP! Missing a part? No need to go back to the store! The store where you made your purchase does not stock parts for this item. If you need parts, whether they are missing or damaged, call the Customer Service toll free Help Line. Call us and we will gladly ship the part you need FREE OF CHARGE. C...

Page 3 - Do not fully tighten screws until Step 8 is complete.; pick a suitable location to; TO BEGIN ASSEMBLY; , build two leg assemblies by sliding the; long; leg sections into the; short

Attach leg braces to the outside of one leg assembly using #10-24x1¾” screws and #10-24 flange nuts . Make sure slotted (oval) hole is toward bottom of leg . Do not fully tighten screws until Step 8 is complete. 2 1 FIRST, GET A HELPER! This unit is heavy and requires a second person for lifting and...

Page 5 - Insert a; cotter pin; Smoker chamber door not pictured; flange nuts; flange nuts inside chamber.; FULLY TIGHTEN ALL SCREWS AND

6 5 Insert a cotter pin into the hole at one end of the axle and bend the ends of the pin back so that it cannot be removed. Slide a wheel onto the axle. Slide the axle through the holes at the ends of the short legs. Slide remaining wheel onto axle and secure with remaining cotter pin. Axle NOTE: S...

Page 6 - Diamond Fire Plate Installation; Second; The firebox should be slightly offset from the smoker; flat washer

7 8 Smokestack NOTE: Smoker chamber door not pictured for clarity. From inside the smoker chamber, slide the smokestack through the large hole. Align the two holes in the smokestack plate with the holes in the chamber and secure with two 1/4-20x3/4” hex-head bolts outside the chamber and 1/4-20 flan...

Page 10 - logo plate clips; onto pins until snug against inside of door.; Smoker chamber door not pictured for clarity.

16 15 If logo plate is not already installed, insert logo plate pins into two holes in lower right corner of smoker chamber door. Press logo plate clips onto pins until snug against inside of door. Logo plate NOTE: Smoker chamber door not pictured for clarity. If you wish to grill in the smoker cham...

Page 12 - WARNING; MOST SURFACES ON THIS UNIT ARE HOT WHEN IN USE.; HARDWARE LIST

WARNING MOST SURFACES ON THIS UNIT ARE HOT WHEN IN USE. USE EXTREME CAUTION. KEEP OTHERS AWAY FROM UNIT. ALWAYS WEAR PROTECTIVE CLOTHING TO PREVENT INJURY. HARDWARE LIST Hardware is shown actual size. You may have spare hardware after assembly is complete. #10-24x1” Machine Screw Qty: 16 #10-24x1¾” ...

Page 13 - Preparing and Using Your Silver Smoker; GRILLING; • Remove the ash after each use.

Preparing and Using Your Silver Smoker Before cooking with your Silver Smoker, the following steps should be closely followed to both cure the finish and season the interior steel. Failure to properly follow these steps may damage the finish and/or impart metallic flavors to your first foods. 1. Bru...

Page 14 - Limited Warranty

Limited Warranty Charbroil warrants the Silver Smoker for replacement or repair of parts and/or workmanship for a period of 3 months. Charbroil warrants to the original Silver Smoker owner repair or replacement of the cooking chamber only should "burn out" or "rust through" occur for...