Char-Broil 10301569 - Manuals

Page 2 - DANGER; Safety Symbols; Indicates an imminently hazardous situation; Indicates an potentially hazardous situation; CAUTION; CAUTION; TABLE OF CONTENTS; WARNING; Wash your hands after handling this product.; WARNING; WARNING

DANGER Safety Symbols The symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING WARNING: Indicates an p...

Page 3 - PREPARING TO USE YOUR SANTA FE GRILL; GRILLING; GRILL MAINTENANCE; Always open lid; BEFORE; opening the ash door to

PREPARING TO USE YOUR SANTA FE GRILL Before cooking with your Santa Fe Grill, the following steps should be closely followed to both cure the finish 3 and season the interior steel. Failure to properly follow these steps may damage the finish and/or impartmetallic flavors to your first foods. 1. Bru...

Page 4 - THE HEAT OF THE COALS; Building Your Fire; COOKING TIPS

THE HEAT OF THE COALS seconds you can hold the palm of your hand 4 inches above the coals temperature range (Fº) visual cues HOT COALS 2 400 to 450 barely covered with gray ash; deep red glow MODERATELY HOT 375 to 450 thin coating of gray ash; deep red glow MODERATELY HOT COALS 4 325 to 375 signific...

Page 5 - USDA Recommended

Direct and Indirect Grilling Direct Grilling - For most grilling, the ignited coals are spread in a single layer under the food. This is called direct grilling and is appropriate for relatively quick-cooking items such as hamburgers, steaks and most seafood. The single layer of coals emits even, ste...

Page 6 - LIMITED WARRANTY

LIMITED WARRANTY 6 This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for th...

Page 8 - ASSEMBLY

2 • Open carton and place contents onto a clean floor. 1 • Place bottom on ground with clean out door opening facing ground. • Attach rear panel to the bottom with (3) 1/4-20x1/2” hex screws. • With lower section still in position from previous step, attach (1) short leg to the right end and (1) Lon...

Page 9 - This may require at least two people

3 4 This may require at least two people . • Insert a cotter pin through the hole in one end of the axle and bend it so it won’t back out (A). Axle Cotter pin A Cotter Pin Axle 9 Slide a wheel onto the axle. Slide axle through hole in bottom of short leg as shown. Slide the other wheel onto the end ...

Page 12 - Lid shown removed for clarity.

10 9 grill using (2) 1/4-20x1/2” long hex screws and (2)1/4” flange nuts each. 12 Attach left and right shelf brackets to both ends of • Attach (3) slats to each set of shelf brackets using (6) #10-24x1/2” screws. DO NOTTIGHTEN UNTIL ALL SLATS ARE ATTACHED. Lid shown removed for clarity. 11 attached...

Page 14 - HARDWARE LIST

HARDWARE LIST Hardware is shown actual size. You may have spare hardware after assembly is complete. 1/4-20 Flanged Lock Nut Qty.33 1/4” Flat Washer Qty.10 1/4-20x1/2” Hex Screw Qty.37 Cotter Pin Qty:2 #10-24x1/2” Screw Qty. 12 #1/4-20 Reversible Lock Nut Qty. 6 14 1/4-20x3/4” Hex Screw Qty.6