Char-Broil 10201595 - Manuals

Page 2 - DANGER; Safety Symbols; Indicates an imminently hazardous situation; Indicates an potentially hazardous situation; CAUTION; CAUTION; TABLE OF CONTENTS; WARNING; Wash your hands after handling this product.; WARNING; WARNING

DANGER Safety Symbols The symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING WARNING: Indicates an p...

Page 3 - GRILLING; SMOKING AND SLOW COOKING; Preparing and Using Your American Gourmet Smoker; Grilling with Wood Chips/Wood Chunks; – Mesquite; USDA Recommended

Page 3 1. Brush all interior surfaces including grills and grates with vegetable cooking oil. 2. Build a small fire on the fire grate, being sure not to lay coals against the walls. 3. Close door. (Position butterfly damper and smokestack damper approximately at one quarter open.) This burn should b...

Page 4 - THE HEAT OF THE COALS; Building Your Fire; COOKING TIPS

Page 4 THE HEAT OF THE COALS seconds you can hold the palm of your hand 4 inches above the coals temperature range (Fº) visual cues HOT COALS 2 400 to 450 barely covered with gray ash; deep red glow MODERATELY HOT 375 to 450 thin coating of gray ash; deep red glow MODERATELY HOT COALS 4 325 to 375 s...

Page 6 - LIMITED WARRANTY

This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated...

Page 7 - PARTS LIST; Key Qty

PARTS LIST Page 7 Key Qty Description 17 1 Firebox Cook Grate 18 2 Wheel 19 1 Firebox Bottom 20 2 Leg Support Tube 21 2 Leg With End Caps 22 2 Leg For Wheels 23 2 Leg Brace 24 1 Firebox Door 25 2 Hinges for Firebox Door 26 1 Damper Door — 1 Hardware Pack --- 1 Assembly Instructions, English — 1 Asse...

Page 8 - ASSEMBLY

2 1 ASSEMBLY Page 8 2 1 FIRST, GET A HELPER! This unit is heavy and requires a second person for lifting and moving. NEXT, pick a suitable location to work. Open the carton and slit the corners so that the carton lays flat. This will give you a protective surface during assembly. SmokerChamber LegSu...

Page 11 - Fully tighten all screws and nuts.; wing nut

Page 11 7 NOTE: The temperature gauge may be packed inside of the smokestack to prevent damage during shipping. If so, remove gauge before assembling smokestack to chamber. • Place fiber washers on handle rods.• Place the handle assembly into the holes on the front of the smoker chamber door and sec...

Page 12 - Fire Grate

10 Page 12 9 • Attach shelf support to side of smoker chamber with one #10-24 X 1/2” machine screw where screw is going through inside of chamber through hole of support and secured with one #10-24 flange nut. • Lay side shelf on top of other end of shelf support so that it fits inside holding brack...

Page 14 - HARDWARE LIST; You may have spare hardware after assembly is complete.; Hardware not shown actual size.

HARDWARE LIST You may have spare hardware after assembly is complete. Page 14 Hinge Pin Qty. 2 Qty. 4 Hair Pin Clip Logo Clip Qty. 2 #6-32 X 3/8” Machine Screw Qty. 8 #10-24 x 1/2” Machine Screw Qty. 21 1/4-20 X 1-3/4” Machine Screw Qty. 12 Fiber Washer Qty. 4 1/4-20 Flange Nut Qty. 18 #10-24 Flange...