Char-Broil 10101480 - Manuals

Page 2 - Safety Symbols; Indicates an imminently hazardous situation; WARNING; Indicates an potentially hazardous situation; CAUTION; DANGER; and immediately call your fire department.; DANGER; of any flammable liquid.; CAUTION; TABLE OF CONTENTS

DANGER Safety Symbols The symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING WARNING: Indicates an p...

Page 3 - Wash your hands after handling this product.; Installation Safety Precautions; National Fuel Gas

3 WARNING CALIFORNIA PROPOSITION 651. Combustible by-products produced when using this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. 2. This product contains chemicals, including lead and lead compounds, known to the State of ...

Page 4 - ppliance; Cleaning the; Grease Tray; “For Best Results”; USDA Recommended

4 Food Safety Food safety is a very important part of enjoying the outdoor cooking experience. To keep food safe from harmful bacteria, follow these four basic steps: Clean: Wash hands, utensils, and surfaces with hot soapy water before and after handling raw meat and poultry. Separate: Separate raw...

Page 5 - USE AND CARE; OPD Hand Wheel

• NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cylinder beyond 80% full. • An over filled or improperly stored cylinder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property d...

Page 6 - Connecting Regulator to the LP Cylinder; full stop; Safety Relief Valve; Strap and Cap; LP Cylinder Exchange; Exchange your; LP Cylinder Leak Test; For your safety

WARNING If “growing” bubbles appear do not use or move the LP cylinder. Contact an LP gas supplier or your fire department! Connecting Regulator to the LP Cylinder 1. LP cylinder must be properly secured onto . (Refer to assembly section.) 2. Turn all control knobs to the OFF position. 3. Turn LP cy...

Page 7 - Leak Testing Valves, Hose and Regulator; rushing sound; immediately

6. Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools. NOTE...

Page 8 - Keep fuel supply hose away from any heated surfaces.; The grease tray

24” 3 ft. 3 ft. WARNING CAUTION • Putting out grease fires by closing the lid is not possible. This a ppliance is well ventilated for safety reasons. • Do not use water on a grease fire. Personal injury may result. If a grease fire develops, turn knobs and LP cylinder off. • Do not leave appliance u...

Page 9 - Troubleshooting Section

CAUTION If ignition does NOT occur in 5 seconds, turn the control knob OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury. Turn control knob and LP cylin...

Page 10 - VERY IMPORTANT: Burner tube must re-engage over valve; Cleaning the Burner Assembly

Cleaning the Burner Assembly (Continued) 7. Clean inner burner as recommended below, shown E . We suggest three ways to clean the burner tube. Use the oneeasiest for you. (A) Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run hook through burner tube severaltimes. (B) U...

Page 11 - ITEMS MANUFACTURER WILL NOT PAY FOR:; DISCLAIMER OF IMPLIED WARRANTIES and LIMITATION OF REMEDIES; LIMITED WARRANTY; SCOPE OF COVERAGE

This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated...

Page 12 - PARTS DIAGRAM

PARTS DIAGRAM NOTE: Some grill parts shown in the assembly steps may differ slightly in appearance from those on your particular model. However, the method of assembly remains the same. Q R K O F P M E D G I A B H J J C K N L S 12 T U V W X Key Qty Description O 4 Leg Assemblies P 1 Grease Tray Q 2 ...

Page 13 - ASSEMBLY; Leg Assembly; Remove top cover, cooking basket and cooking pot.; Burner

ASSEMBLY 2 1 Qty: 12 #10-24x1/2" Screw Leg Assembly with Rating Label • Remove top cover, cooking basket and cooking pot. • Turn appliance upside down. • Attach legs to body using three #10-24 x 1/2" screws and three #10-24 Keps nuts for each leg. Insert screw through appliance body from out...

Page 14 - Assemble the control panel to the appliance:; View is shown

3 Qty: 3 #10x3/8" Self-Tap Screw Make sure valve is centered with burner tube Burner Tube Valve end Valve and Burner Centered B A Electrode Spade end of ignitor wire D View is shown with unit upside-down Assemble the control panel to the appliance: Install 1 each #10x3/8” self-tap screw into the...

Page 15 - Grease tray; Control

5 • Slide grease tray onto grease tray rails. • Insert Foil Tray Liner into Grease Tray as shown. Grease tray rails Grease Tray 15 Foil Tray Liner 4 • Turn appliance upright on its legs. Push on control knob and ignitor knob (A). • If not already assembled, slide handle springs onto side handles (B)...

Page 16 - When cooking hang top cover on handle as shown.

6 Cooking Pot Cooking Basket Top Cover 16 • Place cooking pot and cooking basket into appliance body and place the top cover as shown. • When cooking hang top cover on handle as shown. Once seasoning is complete, the appliance is now ready for use. The cooking chamber will continue to darken with us...

Page 17 - NOTES

Page 18 - Troubleshooting

EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Problem Gas leaking from cracked/cut/burned hose. Gas leaking from LP cylinder. Gas leaking from LP cylinder valve. Gas leaking between LP cylinder and regulator connection. Fire ...

Page 19 - continued; Possible Cause

Troubleshooting ( continued ) Possible Cause • Rotary knob rotates without clicking. • Sparking between ignitor and electrode. • See “GAS ISSUES:” on previous page. • Match will not reach. • Improper method of match-lighting. • Out of gas. • Excess flow valve on regulator tripped. • Vapor lock at co...