Page 2 - The Protector System; must be used for all; WARNING; START BY READING THESE IMPORTANT SAFETY INSTRUCTIONS
1 CONTENTS PAGE SAFETY INSTRUCTIONS . . . . . . . .1CARTON INVENTORY . . . . . . . . . .2TOOLS REQUIRED . . . . . . . . . . . .2DOOR REQUIREMENTS . . . . . . . .2PREPARE & TEST THE DOOR . .3-4INSTALLATION . . . . . . . . . . . . . .5-6CONNECT ELECTRIC POWER . . .6ADJUSTMENT . . . . . . . . . . ....
Page 3 - on the door; DOOR REQUIREMENTS
1. Instruction manual (this document)2. Stop collar3. Clamp bracket4. Release handle, cord and risk of entrapment card5. Transmitters (2)6. Wireless wall button7. Hardware bag8. Weight bar9. Clamp plate 10. Warning label and risk of entrapment label11. Opener CARTON INVENTORY 1 11 13 mm, 10 mm, 8 mm...
Page 4 - TESTING THE DOOR; Non opener side; INSTALLING THE STOP COLLAR; Is the stop collar
TESTING THE DOOR 4 Complete the following test to ensure your door is wellbalanced, and not sticking or binding: • Disable all locks and remove any ropes connected to the garage door. • Lift the door to about halfway and then release it. The door should remain spring balanced. • Raise and lower the ...
Page 5 - PINNING THE DOOR; Free curtain; THE RELEASE HANDLE & CORD; click; OPERATING THE MANUAL RELEASE
PINNING THE DOOR Note: A ballooning door may delay the safety reversalresponse and can compromise garage door security. • To remedy any ballooning place self tapping metal screws or rivets where the curtain leaves the roll. Secure thesethrough the curtain into the drum wheel at each end of theroll. ...
Page 6 - Optional accessory not provided; • Align the extension pole holes with the drive legs.; LEFT / RIGHT HAND INSTALLATION
5 Release cable Rope Manual ReleaseWarning Label Release handle Overhand knot Optional accessory not provided • Align the extension pole holes with the drive legs. • Insert the extension poles into the drive leg and fix in place using screws provided. • Slide the reinforcing brace over the poles and...
Page 7 - INSTALLATION PROCEDURE
6 INSTALLATION PROCEDURE NOTE: The opener can be installed on either sideof the door. The following instructions are forRIGHT HAND INSTALLATIONS (as illustrated i.e.inside the garage looking out). For left handinstallations, reverse the instruction terminology(eg LEFT for RIGHT etc). Preparation: • ...
Page 8 - SETTING THE LIMITS FOR RIGHT OR LEFT HAND OPERATION AND FORCE; Setting right or left hand operation:
7 SETTING THE LIMITS FOR RIGHT OR LEFT HAND OPERATION AND FORCE Travel limits set how far your door goes up and down. Your opener must be configured correctly for right or lefthand installation to operate correctly, if not the door will rotate in the reverse direction. NOTE: The MR850EVO/MR650EVO op...
Page 9 - FIXING WARNING LABELS; Repeat test of the safety reverse system.; TESTING THE SAFETY REVERSE SYSTEM; The safety reverse system test is important.; STANDARD INSTALLATION COMPLETE
8 Wall control, orwireless push buttonno less than 1.5 m Handle should beless than 1.8 m <1.8 m >1.5 m Once you have completed your installation andsuccessfully carried out the safety reverse systemtest (outlined above), install the warning labelsprovided with your opener as shown. The risk of...
Page 10 - when it is installed and; IR Beams must be installed; INSTALL THE PROTECTOR SYSTEMTM (IR BEAMS) OPTIONAL ACCESSORY; NOTE: The Protector System; Installing and adjusting:; Auto close is NOT recommended for households with young children.
9 NOTE: This accessory must be used for allinstallations where the closing force as measuredon the bottom of the door is over 400 N (40 kgf). After the opener has been installed and adjusted, theProtector System™ accessory can be installed.Instructions are included with this accessory. The Protector...
Page 11 - Press LEARN; or; TO ADD Transmitters / Wireless wall button; Press LEARN for 9 seconds; TO DELETE ALL REMOTES; Deleting ALL transmitter codes
WIRELESS PROGRAMING (OPTIONAL ACCESSORIES) NOTE: Transmitter(s) and wall button supplied with your opener are factory programmed. INSTALLING YOUR E128M WIRELESS WALL BUTTON To install: • Carefully pry open the E128M and locate the two screws for mounting. • Attach to the wall using the two screws an...
Page 12 - Wireless Keypad E840M; To set the keyless entry PIN:; KEYLESS DEVICE PROGRAMMING (OPTIONAL ACCESSORIES )
11 19 2 3 4 3 Press and releasethe yellowlearn button Enter a 4-digitPIN of yourchoice? ? ? ? _ _ _ _ Press and holdthe enter buttonOpener light bulbsblink After the lightsblink release theENTER button 1 Locatethe yellowlearn button Activate the opener only when the door is infull view, free of obst...
Page 13 - OPERATION OF YOUR OPENER; Obstruction behaviour:; MAINTENANCE OF YOUR OPENER; be installed on all garage door openers.; CARE OF YOUR OPENER
12 OPERATION OF YOUR OPENER Your opener can be activated by any of the followingdevices: • The ACTIVATION button Press the button until door starts to move. • The wall control, outside keyswitch or keyless entry system (if you have installed any of theseaccessories). • The Transmitter or Wireless Wa...
Page 14 - ACCESSORIES; gnd; com; Information for Service Personnel
13 1 2 3 4 8 9 10 5 7 6 ACCESSORIES 1. Model E128M 2 Channel wireless wall button 2. Model E940M 1 Channel transmitter 3. Model E943M 3 Channel transmitter 4. Model E945M 3 Channel mini transmitter 5. Model E840M Keyless entry system 6. Model 760 Outside keyswitch 7. Model CM1702 Outside quick relea...
Page 15 - SPECIAL FEATURES - Information for Service Personnel
14 2 4 5 3 1 12V DC MR850EVO ONLY SPECIAL FEATURES - Information for Service Personnel (OPTIONAL ACCESSORIES) 1. Solenoid roller door lock (SRDLK01-12 V) - (MR850EVO only)2. 12 VDC power output for external devices - (MR850EVO only)3. The Protector System TM IR Beams - C77 4. LCD Motion detecting co...
Page 16 - SPARE PARTS - Information for Service Personnel
15 If the supply cord is damaged, it must bereplaced by the manufacturer, its serviceagent or similarly qualified personsin order to avoid hazard. 001A6621 041A6811-2 041B0655 001A6528 204D0250 (MR850)204D0251 (MR650) 041B0640 (MR850) 041B0640-1 (MR650) 001B6681 041A7460 (MR850) 041A7460-1 (MR650) 0...
Page 19 - TROUBLESHOOTING
18 TROUBLESHOOTING 1. The opener will not operate from either the ACTIVATION button or the transmitters : • Does the opener have electric power? Plug a lamp into the outlet. If it does not work, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page ...
Page 20 - © 2012 The Chamberlain Group, Inc; ® Registered Trademark of The Chamberlain Group, Inc.
114A4209D © 2012 The Chamberlain Group, Inc TM Trademark of The Chamberlain Group, Inc. ® Registered Trademark of The Chamberlain Group, Inc. 19 CHAMBERLAIN LIMITED WARRANTYMerlin Professional MR850EVO/MR650EVORoller Garage Door Opener Chamberlain Australia Pty Limited / Chamberlain New Zealand Limi...