Cerwin-Vega CVA-115 - Manuals

Cerwin-Vega CVA-115 – Manual in PDF format online.

Manuals:

Manual Cerwin-Vega CVA-115

1 Page 1
2 Page 2
3 Page 3
4 Page 4

Summary

Page 2 - Note This only applies to power cables – not the audio cables.; Warning Make sure you have selected the correct voltage based; as for an acoustic guitar.

9. Polarity Switch Changes the polarity of the subwoofer, also referred to as the “phase.” Listen and adjust for maximum bass. 10. Variable Low Pass (Sub frequencies) When sending a full range signal to the subwoofer, the variable LPF blocks HF signals above indicated frequencies from reaching the s...

Page 3 - Pass knob in the Bypass position.; OFF or CONTOUR Switch

5. Level Adjusts the input signal (master volume) to the amplifier (i.e. over all loudness / volume). Make sure this is not turned up when powering On or when switching the input (Mic/DI – Line). 6. Audio Input (XLR or ½”) Balanced (Left & Right) XLR and 1/4 inch TRS connectors accept signals fr...

Page 4 - Basic CVA Settings Guide:; SETTINGS ON THE CVA Series SUB:; muddiness or notice the limit light stays On more than it is Off.; E u r o p e

Basic CVA Settings Guide: Note This is not intended for all applications but an easy way to get good sound from your setup. Using at least a 20 AMP breaker per stack and all XLR cables, use the following as an average settings guide when using two CVA-28’s on a dual antler (CVANT-2A) per one CVA-118...

Cerwin-Vega Manuals