Cerwin-Vega CV-5000 - Manuals

Page 2 - IMPORTANT SAFETY INSTRUCTIONS

Page 3 - TABLE OF CONTENTS

3 Introduction ……………………………………………..... 4 Features ………………………………………………….. 5 Front Panel Controls …………………………………...…. 6 Rear Panel Controls ………………………………………. 8 Protection ……………………….……………………....... 10 Setup ………………………………..…………………… 11 Connections …………………………………………..….. 13 Wiring…………………………………………………….. 15 Speci...

Page 5 - FEATURES

5 The CV-5000 amplifier delivers the following power ratings. 2 x 1100 Watts at 8 ohm, 2 x 1800 Watts at 4 ohms and 2 x 2500 Watts at 2 ohms 2-channel, parallel or bridged mono operating modes for flexible application - 5000 Watts …and the following features.  Independent limiters for each channel ...

Page 6 - FRONT PANEL CONTROLS

6 1. Rack Mounting Ears Two front panel mounting holes are provided on each mounting ear. 2. Fan Vent CV-5000 amplifier is cooled by two rear-mounted fans. Cool air flows through the front fan filters, reducing the temperature of the inside components while forcing the heat out the rear vents. Never...

Page 8 - REAR PANEL CONTROLS

8 1. Fan This is a variable speed cooling fan. Cool air enters the amplifier through the fan ports located on the front of the amplifier chassis, be sure not to block these ports when installing the amplifier or other associated equipment. 2. Input connectors Connect the input source to these electr...

Page 10 - PROTECTION

10 The CV-5000 incorporates protection features. The front panel Protection LED indicates the activity of the relay speaker connection circuitry in each channel. When the Protection LED turn on, this circuitry is active and all connected speakers are muted. Initial Power Up - For approximately five ...

Page 11 - SETUP

11 Clip Limiter Clipping is the result of an amplifier running into a power supply limitation. The maximum output voltage that any amplifier can produce is limited by its power supply. Attempting to output a voltage (or current) level that exceeds the power supply results in a “flattenin” effect on ...

Page 13 - CONNECTIONS

Page 15 - WIRING

15 These are several ways to interface the CV-5000 to support a variety of applications. The CV-5000 features balanced inputs and outputs, so connecting balanced and unbalanced signals is possible. BALANCED TRS 1/4” CONNECTOR UNBALANCED TRS 1/4” CONNECTOR WIRING

Page 17 - SPECIFICATIONS

17 0dB=0.775V 0dBV=1V Rated Output Power Stereo 8 ohms 1100W 4 ohms 1800W 2 ohms 2500W Rated Output Power Bridged Mono 8 ohms 3600W 4 ohms 5000W Signal to Noise Ratio <-100dB (20 Hz ~ 20k Hz) Distortion (SMPTE-IM) < 0.02% Input sensitivity @8 ohms 1.42V (+5.3dB) Voltage Gain 36dB Output Circui...