Casablanca S3 - Manuals - manualsarea.com

Page 2 - CONTENTS; READ AND SAVE THESE INSTRUCTIONS; For best performance and for your warranty to be valid,; SAFE USE; SAFETY FIRST; VERSA•TOUCH OPERATION; BEFORE YOU START

1 CIRCUIT BREAKER (TRIP BREAKER FOR THE CIRCUIT YOU WILL BE WORKING ON) FUSE BOX (REMOVE FUSE FOR THE CIRCUIT YOU WILL BE WORKING ON) CAUTION: MOUNT WITH THE LOWEST MOVINGPARTS AT LEAST 2.5 METRES ABOVE FLOOR ORGRADE LEVEL.ATTENTION: INSTALLER DE SORTE QUELESPIÈCES INFÉRIEURES SOIENT À AU MOINS 2.5M...

Page 3 - MOUNTING RECOMMENDATIONS; SLOPED CEILING INSTALLATIONS

2 MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation,and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We...

Page 4 - Setup; WORK BENCH SETUP; IMPORTANT SAFETY INFORMATION!

3 INSTALLATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed. PERMA•LOCK™ HARDWARE NOTE: If this is ...

Page 5 - Installing a New Ceiling Fixture Outlet Box; CROSSBAR MOUNTING BRACKET INSTALLATION

4 CEILING HARDWARE CROSSBAR MOUNTING BRACKET WIRE NUT (4) GETTING STARTED Installing a New Ceiling Fixture Outlet Box If you do not have an existing fixture located where you wishto place your Casablanca fan, an approved ceiling fixtureoutlet box must be installed and wired. Using Existing Ceiling F...

Page 6 - BLADE HARDWARE; BLADE INSTALLATION

5 BLADE HARDWARE Step 3. Assemble the blades to the motor using the 3 bladescrews and 3 metal washers. Hand tighten firmly. BLADE SCREW (3 PER BLADE) BLADE INSTALLATION BLADE (3) METAL WASHER (3 PER BLADE) BLADE SCREW & WASHERS CANOPY INSTALLATION CANOPY LOCK WASHER CANOPY SCREW CROSSBAR MOUNTIN...

Page 7 - Step 5b. Wiring Connections; CANOPY HATCH INSTALLATION

6 6 Step 4. To hang the fan body in the canopy, hold the fan body firmly and in-sert the ball into the canopy opening.Check that no wires were pinched. Ro-tate the fan body until the slot in thenylon ball fits into the pin opposite thecanopy opening. HANGING THE FAN PIN SLOT BALL CANOPY ELECTRICAL C...

Page 8 - INSTALL BULB AND GLASS; SAVING MONEY WITH YOUR CEILING FAN

7 INSTALL BULB AND GLASS Step 9. Screw the 100 Watt Halogen bulb into the socket. Do not touch the glass bulb with your fingers–it is extremelyimportant that the glass be clean. If it is touched, or dirty,clean carefully with a tissue. A dirty glass bulb will cause thebulb to fail almost immediately...

Page 9 - Install Battery

8 Removing Gently Pull the lower edgeof the control gently outfrom the holder. Control Storage Angle control in top first inthe holder until the unitcan be gently pushed backand snapped onto thebottom rim. WOOD SCREW 1” Note: The wall anchors and 6-32 x 1” screws may be usedin situations where mount...