Page 2 - CONTENTS; READ AND SAVE THESE INSTRUCTIONS; SAFE USE; SAFETY FIRST; BEFORE YOU START
1 CIRCUIT BREAKER (TRIP BREAKER FOR THE CIRCUIT YOU WILL BE WORKING ON) FUSE BOX (REMOVE FUSE FOR THE CIRCUIT YOU WILL BE WORKING ON) 18 ″ 84 ″ 70 ″ • The blades in each pack are matched for equalweight to assure smooth fan operation. Ifmore than one fan is being installed, becareful not to mix blad...
Page 3 - SLOPED CEILING INSTALLATIONS
2 Calculation of 32 ° Use the tear-off Ceiling Angle Template card inserted in the back of this manual, it provides you with a simple ‘go’ or‘no-go’ for installing your fan on a sloped ceiling. SLOPED CEILING INSTALLATIONS MOUNTING RECOMMENDATIONS 7 ′ MINIMUM Pole Length StandardStandard 6 ″ 12 ″ 12...
Page 4 - STRADA; IMPORTANT SAFETY INFORMATION!
3 PREPARATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check themagainst the parts listed here. Before discarding packaging material, be certain that all parts have been removed. FAN PREPARATION PERMA•LOCK™ HARDWARE E S...
Page 5 - CEILING HARDWARE
4 CAUTION: To reduce the risk ofpersonal injury, use only themounting hardware provided withthe approved outlet box to installthe crossbar mounting bracket. CROSSBAR MOUNTING BRACKET INSTALLATION CEILING WIRING CROSSBAR MOUNTING BRACKET FLAT WASHER GREEN GROUND WIRE CEILING FAN APPROVED OUTLET BOX R...
Page 6 - CANOPY INSTALLATION
5 HANGING THE FAN Step 3. To hang the fan body in the canopy, hold the fan body firmly and in-sert the ball into the canopy opening.Check that no wires were pinched. Ro-tate the fan body until the slot in theball fits into the pin opposite the canopyopening. CAPPED BLUE D1-OPTION WIRE. PIN SLOT BALL...
Page 7 - RUBBER GROMMET INSTALLATION; CORRECT INSTALLATION
6 RUBBER GROMMET (4 PER BLADE) BLADE SCREW (4 PER BLADE) BLADE TO BLADE HOLDER INSTALLATION BLADE & BLADE HOLDER HARDWARE BLADE HOLDER BLADE HOLDER SCREW (2 PER BLADE) Step 8. Insert a rubber grommet through each blade hole of every blade. Inspectboth sides of the blade to assure thatthe lips of...
Page 8 - BLADE/BLADE HOLDER INSTALLATION; BLADE INSTALLATION; REMOVE SHIPPING BLOCKS
7 BLADE/BLADE HOLDER INSTALLATION Step 11. Using the five screws removed in Step 10, and the five additional screws fromthe pack, attach each blade/blade holder as-sembly to the motor. Using the screwdriver, tighten securely by hand only. BLADE SCREW (4 PER BLADE) BLADE BLADE INSTALLATION Step 10. O...
Page 9 - TROUBLESHOOTING; PROBLEM
8 COLLAR SWITCH HOUSING 3-SPEED ♦ OPTIONAL LIGHT FIXTURE INSTALLATION REVERSE PULL CHAIN SWITCH 3-SPEED ♦ OPERATION Pull-chain switches on the fan control the fan and reverse.Using the fan control pull-chain switch: Fan off at start. First pull: fan ON, low speed Second pull: medium speed Third pull...