Casablanca 66HXXF - Manuals

Page 2 - MOUNTING RECOMMENDATIONS; Calculation of 32°; Ceiling Angle Template; SLOPED CEILING INSTALLATIONS; Pole Length

2 MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. W...

Page 3 - INSTALLATION INSTRUCTIONS; Prepare for fan installation as follows:; CAUTION: Failure to fully lock in the down-; important safety information!; perma•lockTM hardware; SUPPORT INSTALLATION

333 P anama ® H alo INSTALLATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed. GETTING STARTED CEIL...

Page 4 - crossbar mounting bracket installation; After removing the old fixture, check the outlet; LAG SCREW INSTALLATION

4 crossbar mounting bracket installation JOIST CEILING WIRING CrOSSbAr mOunTIng brACKET FLAT WASHER GREEN GROUND WIRE CEILING FAN AppROVED WIRING BOx RIDGE SIDE DOWN AppROVED OUTLET BOx HARDWARE note: After removing the old fixture, check the outlet box to insure that it is supported by a joist or b...

Page 5 - hANGING ThE FAN; noTE: Independent control of; CANOPY hATCh INSTALLATION; Fan Weighs 27 lbs; CANOPY ELECTRICAL CONNECTIONS

55 P anama ® H alo Step 4. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Check that no wires were pinched. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening. hANGING ThE FAN pIN SLOT BALL noT...

Page 6 - holder to the flywheel (round holes); Hand tighten

6 Install the assembled blade and blade holder to the flywheel (round holes) or direct drive motor. Hand tighten securely. Repeat for each assembly. FELT WASHER (3 pER BLADE) BLADE HOLDER SCREW (2 pER BLADE HOLDER) BLADE hOLDER & BLADE wARnIng: To reduce the risk of personal injury, do not bend ...

Page 7 - - SPEED OPTIONAL LIGhT FIxTURE INSTALLATION; Not for use with single; CAUTION! Failure to set the pull-chain speed to HIGH can

7 Pull-chain switches on the fan control the fan and lights. Using the fan control pull-chain switch: Fan off at start. First pull: fan ON, High speed Second pull: Medium speed Third pull: Medium Low speed Fourth pull: Low speed Fifth pull: Fan OFF The sequence of Light pull chain as follows: Light ...

Page 9 - sure the power is turned off during this inspection.; TROUBLEShOOTING; BeFOre reqUeSTING ServICe:; PROBLEM

99 P anama ® H alo FAN WILL NOT START •Check main circuit fuses, circuit breakers, or wall switch position. Check all wire connections, making sure the power is turned off during this inspection. •Pin connectors are not making good contact. Check the connections in the switch housing and under the t...

Page 10 - Product SPecificationS; Panama® Halo

10 Product SPecificationS Model Name: Panama® Halo Model Number: 66HXXF Dimensions: A = 10.75" B = 12.46" C = 3" D = 13.43" E = 5.6" Weight: 27 lbs. Motor: XTR200® x 20mm Blade Span: 42" or 50" Blade Iron Pitch: 20° No. of Blades: 5 Technology: 4-Speed Airflow*: 6,480 cfm...