Casablanca 65GxxD - Manuals

Page 2 - SLOPED CEILING INSTALLATIONS

2 Calculation of 32° Use the tear-off Ceiling Angle Template card inserted in the back of this manual, it provides you with a simple “go” or “no-go” for installing your fan on a sloped ceiling. SLOPED CEILING INSTALLATIONS MOUNTING RECOMMENDATIONS 7 ′ MINIMUM Pole Length standardstandard 18”18”24”36...

Page 3 - ERRAZANO; PREPARATION INSTRUCTIONS; IMPORTANT SAFETY INFORMATION!; PERMA•LOCKTM HARDWARE; GETTING STARTED

3 V ERRAZANO ™ PREPARATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed. FAN PREPARATION MOTOR COUP...

Page 4 - CROSSBAR MOUNTING BRACKET INSTALLATION; CEILING HARDWARE; SUPPORT INSTALLATION PARTS

4 CROSSBAR MOUNTING BRACKET INSTALLATION JOIST CEILING WIRING CROSSBAR MOUNTING BRACKET FLAT WASHER GREEN GROUND WIRE CEILING FAN APPROVED WIRING BOX RIDGE SIDE DOWN APPROVED OUTLET BOX HARDWARE Note: After removing the old fi xture, check the outlet box to ensure that it is supported by a joist or ...

Page 5 - CANOPY INSTALLATION; CANOPY HARDWARE; LAG SCREW INSTALLATION

5 V ERRAZANO ™ CANOPY INSTALLATION Step 4. Attach the canopy to the crossbar mounting bracket with three of the 8-32 x 2 1 / 2 ” long canopy screws and lock washers provided with your Casablanca fan. Hand-tighten until snug against the ceiling. CANOPY SCREW CANOPY LOCK WASHER FEED OUTLET BOX WIRES T...

Page 6 - HANGING THE FAN

6 HANGING THE FAN Step 5. To hang the fan body in the canopy, hold the fan body fi rmly and insert the nylon ball into the canopy open-ing. Rotate fan body until slot on nylon ball fi ts into pin opposite canopy opening. CANOPY BALL SLOT PIN NOTE: The fan weight is 37.5 pounds. • T h e f a n m u s t...

Page 7 - CANOPY HATCH INSTALLATION; INSTALLATION OF WALL CONTROL

7 V ERRAZANO ™ CANOPY HATCH INSTALLATION Step 7. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening. Step 8. Install canopy hatch with the last canopy screw and lock wa...

Page 8 - BLADE HARDWARE; INSTALL BLADE RODS; BLADE TIP INSTALLATION; BLADE INSTALLATION

8 BLADE BLADE ROD BLADE TIP SCREW (2 PER BLADE) BLADE HARDWARE BLADE TIP Step 10. Remove the shipping cover from each of the blade rod holders on the fan body. Using the provided Allen wrench, unscrew the blade rod holder screw a few turns to assure proper installation of the blade rod. Insert the m...

Page 9 - INSTALL LIGHT KIT BASE; LIGHT KIT PARTS

9 V ERRAZANO ™ INSTALL LIGHT KIT BASE Step 14. Route the motor wires through the center of the light kit base. Align the light kit base onto the switch housing using the tabs of the switch housing. Using the three switch housing screws removed in Step 13, attach the light kit base to the switch hous...

Page 11 - REVERSING FAN DIRECTION; SAVING MONEY WITH YOUR CEILING FAN

11 1. Raise the Fan slider to increase fan speed, lower it to decrease. 2. For the fan, four positions are available: OFF, LOW, MEDIUM, and HIGH. The bottom position is OFF. 3. The Light slider is a dimmer, the bottom is OFF; raise to increase intensity of the light. W-1811 OPERATION W-1811 CEILING ...

Page 12 - CARE RECOMMENDATIONS

12 12 TROUBLESHOOTING Before requesting service: Please consult this troubleshooting guide before contacting your dealer for assistance. PROBLEM POSSIBLE REMEDIES FAN WILL NOT START Check main circuit fuses, circuit breakers, or wall switch position. Check all wire connections, making sure the power...

Page 13 - AUTHORIZED SERVICE CENTERS

13 V ERRAZANO ™ AUTHORIZED SERVICE CENTERS STATE/CITY ZIP SERVICE CENTER NAME PHONE TYPE COLORADO BOULDER 80306 ENERGETICTECH 303-684-7543 FFS COLORADO SPRINGS 80903 HOME LIGHTING 719-471-3520 WTS DENVER 80229 M.D ELECTRIC 303-288-7988 FFS FORT COLLINS 80525 LIGHT CENTER 970-226-3430 WTS LONGMONT 80...