Page 2 - Air for Combustion and Ventilation:
IMPORTANT: All local and national code requirements governing the installation of oil burning equipment, wiring and flue connections must be followed. Some of the codes (issued by the Canadian Standards Association, the National Fire Protection Agency, and/or the American National Standards Institut...
Page 3 - WARNING; Ductwork Recommendations:
In unconfined spaces in buildings of conventional frame, brick or stone construction infiltration may be adequate to provide air for combustion, ventilation and dilution of flue /--xgases. This determination must be made on an individual ( hstallation basis and must take into consideration the overa...
Page 5 - Factory Built Chimneys:; CAUTION; USE METALLIC VENT PIPE, ONLY! PLASTIC
Pre-Installation Vent System Inspection: Before this furnace is installed, it is highly recommended ;"^^that any existing vent system be completely inspected. For any chimney or vent, this should include the following: 1. Inspection for any deterioration in the chimney or vent. If deterioration ...
Page 6 - Oil Connection Entry Holes
Oil Connections: Complete instructions for installation of the fuel oil piping will be found in the oil burner installation instructions included with the furnace. Oil line entry holes are produced in the side panels and top panel. Two holes are provided in each location, so that a two-pipe system m...
Page 9 - Constant Blower Switch:
Figure 2 MAINTENANCE This furnace should never be operated without an air filter. Filters should be cleaned at least twice a year. To avoid personal injury, make sure the electrical supply power is "OFF" before servicing. Limit Control Check: After the furnace has been in operation for at le...
Page 10 - Figure 3
4. Remove the upper rear panel. 5. Remove the flue collector box from the secondary heat exchanger tube flange. This exposes the inside surfaces of the secondary tubes of the heat exchanger. If only the secondary needs to be cleaned, no further disassembly is required. 6. Clean the secondary tubes a...
Page 11 - BLOWER REMOVAL; REMOVE 3 SCREWS
BLOWER REMOVAL REMOVE 3 SCREWS Figure 4 Blower Removal (Refer to Figure 4): 1 To remove the blower from the furnace: 1. Turn "OFF" all utilities upstream of the furnace. 2. Remove the louvered door and blower door. 3. Remove the blower retaining screw (on the blower partition panel, near the...
Page 12 - MINIMUM CLEARANCE TO COMBUSTIBLES; Floor may be combustible; Figure 6
MINIMUM CLEARANCE TO COMBUSTIBLES (Adequate service clearance should be provided over and above these dimensions, as required.) CLEARANCE FROM : UPFLOW HORIZONTAL Top of furnace casing or plenum 2" 2" Top of horizontal warm-air duct within 6 ft of furnace 2" 3" Flue pipe, measured ho...
Page 13 - GENERAL LAYOUT MULTI-POISE OIL FURNACE; Figure 7; Issue
GENERAL LAYOUT MULTI-POISE OIL FURNACE ■FLUE 6 0 FOR 150 FLUE 7 0 FOR 200 UP FLOT GENERAL LAYOUT 150/200 MULTI-POISE OIL FURNACE Figure 7 Issue 9413 20074701 1318
Page 14 - BAROMETRIC DAMPER LOCATIONS; GOOD LOCATIONS; WRONG; BAD LOCATIONS; Figure 8
BAROMETRIC DAMPER LOCATIONS GOOD LOCATIONS F WRONG FIG. L 'POOR BAD LOCATIONS Figure 8 ISSUE 9413 20142901 1418
Page 15 - Filters; massmWi; Keeping Filters Clean
Filters A filter and filter rack is supplied with the furnace. It is NECESSARY THAT ALL FURNACES BE EQUIPPED WITH A FILTER. ) When filter rack is used on side of furnace: 1. Filter rack may be mounted on either side of furnace. 2. The filter rack is made up of four (4) pieces - a top and bottom (whi...
Page 16 - FILTER RACK ARRANGEMENT INSTALLATION; FILTER RACK INSTALLATION
FILTER RACK ARRANGEMENT INSTALLATION FILTER RACK INSTALLATION HORIZONTAL FILTER RACK INSTALLATION UPFLOW Figure 9 Issue 9413 20142901 1618
Page 18 - FOR SERVICE CALL
USER'S INFORMATION Here's How Your Heating System Works The furnace operates automatically. It is controlled by a thermostat which you set at the temperature most comfortable to you. When the inside temperature drops below this setting, your thermostat will turn on the heating system. When the therm...