Carrier Furnace- Manuals

Page 2 - ELECTRICAL

TABLE OF CONTENTS WELCOME TO A NEW GENERATION OF COMFORT_______ 2 FURNACE COMPONENTS.............................................................. 3 SAFETY CONSIDERATIONS ......................................................... 4 BEFORE STARTING YOUR FURNACE........................................ ...

Page 3 - FURNACE COMPONENTS

FURNACE COMPONENTS (Furnace shown in iipflow position; may be used in downflow or horizontal orientation or applications. MANUAL RESET ROLLOUT SWITCH OPERATING INSTRUCTIONS NOT SHOWN (LOCATED ON MAIN FURNACE DOOR, SEE OPERATING INSTRUCTIONS INSIDE DOOR FIGURE). ELECTRICAL JUNCTION BOX (IF REQUIRED, ...

Page 4 - SAFETY CONSIDERATIONS; A WARNING

SAFETY CONSIDERATIONS Installing and servicing of heating equipment can be hazardous due to gas and electrical components. Only trained and qualified personnel should install, repair, or service heating equipment. Untrained personnel can perform basic maintenance functions such as cleaning and repla...

Page 5 - FIRE OR EXPLOSION HAZARD; A CAUTION; UNIT OPERATION HAZARD; BEFORE STARTING YOUR FURNACE; Burner Flame; FIRE AND EXPLOSION HAZARD; STARTING YOUR FURNACE; Follow these important safeguards:

A WARNING FIRE OR EXPLOSION HAZARD Failure to follow this warning could result in personal injury, death, or property damage. Do not keep combustible materials, gasoline, and other flammable liquids or vapors around your furnace. Keep the area around your furnace clear and free of combustible materi...

Page 6 - STEPS FOR STARTING YOUR FURNACE

Read and follow the operating instructions on inside of main furnace door, especially the item that reads as follows: (See Fig. 3f,)“Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol low “B” in the safety information on furnace label. If...

Page 7 - Continuous Fan Operation

SINGLE-STAGE GAS CONTROL TWO STAGE GAS CONTROL Fig. 11 - Control Switch to OFF 6, After waiting five minutes, turn control switch on the gas con trol to the ON position. Turn the control switch to ON, See Fig. 12, Fig. 12 - Control Switch to ON 7, Replace main furnace door. See Fig. 13, A112S7 Fig....

Page 8 - Comfort FanTM; SHUTTING DOWN YOUR FURNACE; Fig. 17 - Close the External Manual Valve; UNIT AND PROPERTY DAMAGE HAZARD; PERFORMING ROUTINE MAINTENANCE; ELECTRICAL SHOCK HAZARD

Comfort Fan™ - On all but the base series furnace, the blower speed can be increased or decreased if desired due to change of seasons, large gatherings in your home, etc. Simply change your FAN from ON to OFF for f to 3 seconds (or AUTO depending on your thermostat), and then return to ON. The blowe...

Page 9 - CUT HAZARD; FILTERING OUT TROUBLE; UNIT PERFORMANCE HAZARD

A CAUTION CUT HAZARD Failure to follow this caution may result in personal injury. Although special care has been taken to minimize sharp edges, be extremely careful when handling parts or reaching into the furnace. Wear safety glasses, gloves, and appropriate protective clothing. FILTERING OUT TROU...

Page 11 - COMBUSTION AIR AND VENT SYSTEM; CARBON MONOXIDE POISONING HAZARD; If

COMBUSTION AIR AND VENT SYSTEM A WARNING CARBON MONOXIDE POISONING HAZARD Failure to follow this warning could result in personal injury or death. If holes are found or if the vent pipe is obstructed or is not connected, toxic fumes can escape into your home. DO NOT OPERATE YOUR FURNACE, Call your d...

Page 12 - WINTERIZATION; UNIT COMPONENT DAMAGE HAZARD

WINTERIZATION A CAUTION UNIT AND PROPERTY DAMAGE HAZARD Failure to follow this caution may result in unit component or property damage. If the furnace is installed in an unconditioned space where the ambient temperatures may be 32° F (0° C) or lower, freeze protection measures must be taken to preve...

Page 14 - NOTE TO EQUIPMENT OWNER:; FURNACE

NOTE TO EQUIPMENT OWNER: For your convenience, please record the model and serial numbers of your new equipment in the spaces provided. This information, along with the installation data and dealer contact information will be helpful should your system require maintenance or service. FURNACE Model #...

Page 15 - Owner’s Manual; THIS MANUAL MUST BE LELT WITH THE; ELECTRICAL OPERATION HAZARD

Owner’s Manual NOTE TO INSTALLER: THIS MANUAL MUST BE LELT WITH THE EQUIPMENT USER. USER: PLEASE READ ALL INSTRUCTIONS IN THE MANUAL AND RETAIN ALL MANUALS LOR EUTURE REEERENCE. A. WARNING FIRE OR EXPLOSION HAZARD Failure to follow warnings could result in personal injury, death, or property damage....