Carrier 58GFA- Manuals

The ability to properly perform maintenance on this equip-ment requires certain expertise, mechanical skills, tools, andequipment. If you do not possess these, do not attempt toperform any maintenance on this equipment other than thoseprocedures recommended in the User’s Manual. FAILURETO FOLLOW THI...

9. Mark blower wheel, motor, and motor support in relation to blower housing before disassembly to ensure proper reassem-bly. 10. Loosen setscrew holding blower wheel on motor shaft. 11. Remove bolts holding motor mount to blower housing and slide motor and mount out of housing. Disconnect ground wi...

(6.) Insert brush end of cable in lower opening of cell, and proceed to clean 2 lower passes of cell in same manneras 2 upper passes. (7.) Repeat foregoing procedures until each cell in furnace has been cleaned. (8.) Remove residue from each cell using vacuum cleaner. (9.) Clean burner assembly usin...

Turn off the gas and electrical supplies to the unit beforeperforming any maintenance or service. Follow the operatinginstructions on the label attached to the furnace. A failure tofollow this warning could result in personal injury. Never store anything on, near, or in contact with the furnace,such...

6. Mark blower wheel, motor, and motor support in relation to blower housing before disassembly to ensure proper reassem-bly. 7. Loosen setscrew holding blower wheel on motor shaft. 8. Remove bolts holding motor mount to blower housing and slide motor and mount out of housing. Disconnect ground wire...

(10.) Reinstall cell inlet plates and burner assembly. Care must be exercised to center the burners in the cellopenings. 7. After cleaning flue openings, check sealant on flue collector to ensure that it has not been damaged. If new sealant is needed,contact your dealer or distributor. 8. Clean and ...