Carrier 42PHQ018N- Manuals

Page 2 - ENGLISH; Contents; Page; Power supply

4 2 P H Q - - - NSplit system “Hi-Wall” indoor unit GB - 1 ENGLISH For operation and maintenance instructions of this unit, as well as installationinstructions of the outdoor unit, refer to the relevant manuals. Contents Page Dimensions and weight .......................................................

Page 3 - Dimensions and weight; Table I: Nominal data; Table II: Operating limits

4 2 P H Q - - - N GB - 2 Dimensions and weight Table I: Nominal data • Unit is not suitable for operation in laundry premises. • For sizing of power supply wires and delay type fuses, refer to the outdoor unit installation instructions. Mod. 42PHQ007N 42PHQ009 - 012 - 014N 42PHQ018 - 024N A mm 790 7...

Page 4 - Table lIl: Material supplied

4 2 P H Q - - - N GB - 3 E N G L I S H a Minimum clearances (mm) a Obstacle Table lIl: Material supplied The following installation accessories are supplied with unit. Use them as required. Name and shape Q.ty Use Wall hanging bracket 1 For indoor unit installation Screws 4xL10 2 For fixing unit and...

Page 5 - Unit installation; General information; Choosing the installation site

GB - 4 4 2 P H Q - - - N Unit installation Read this instruction manual thoroughly before starting theinstallation. • This unit complies with low-voltage (EEC/73/23) and electro- magnetic compatibility (EEC/89/336) directives. • The installation must be carried out by a qualified installer. • Follow...

Page 7 - Installation; Installing the wall hanging bracket

GB - 6 4 2 P H Q - - - N Marking the wall penetration for theconnection piping Rear piping • It is best for the piping to go through the wall behind the unit, so that the unit hides the pipes. • For this method of installation, make a 65 mm diameter hole in the wall at point A. • Drill a 65 mm diame...

Page 9 - Refrigerant connections

GB - 8 4 2 P H Q - - - N Refer to the outdoor unit installation manual for tube sizing,and limitations (slope, length, number of bends allowed,refrigerant charge, etc.). For refrigerant tubes use seamless, insulated refrigeration gradetube, (Cu DHP type according to ISO1337), degreased anddeoxidized...

Page 10 - Check; Use of additional screws; Installing the remote control bracket

GB - 9 4 2 P H Q - - - N E N G L I S H Check • Next, check the unit drain system by pouring some water into the unit drain pan and ensuring that it flows freely through thedrain hose and that there is no leakage from any other part. i i Remote controlbracket Use of additional screws After installati...

Page 11 - Indoor unit wiring; Electrical connection

GB - 10 4 2 P H Q - - - N Indoor unit wiring • Lift the front panel up to the top of the unit; in this way the front panel will be separated from the unit. • Remove the plastic cover of the terminal board.• Make the electrical connections to the terminal board as per the wiring diagram. • When the e...

Page 14 - The General Information For Multi or T-kit model; The configuration setting by remote controller; • Entering Configuration Mode; The Operating Test for Multi or T-kit model

GB - 13 4 2 P H Q - - - N E N G L I S H The General Information For Multi or T-kit model The configuration setting by remote controller • Entering Configuration Mode • Press the “MODE” ( 2 ) button together with the “FLAP” ( 3 )button for 7 continuous seconds while remote is in OFF mode. LCD will di...

Page 15 - Guide for the owner; Operating test; Address switch; Table IV : Accessories; Description; Part number

GB - 14 4 2 P H Q - - - N Guide for the owner When installation and tests are completed explain the Operationand Maintenance Manual to the owner, with particular attention tothe main operating modes of the air conditioner, such as:• Turning the unit on and off. Guide for the owner Operating test and...

Manuals:

Installation Manual Carrier 42PHQ018N

Summary

Carrier Manuals