Carrier 1300L - Manuals

5 INSTALL SHELVES Product shelves and a bag containing shelf support clips are packed inside the unit. Refer to Table 1 to verify quantity of shelves and shelf supporting clips. Bottom shelf must be placed on interior floor and should be inserted into the two retainer clips provided at the rear corn...

6 START-UP PRELIMINARY CHECKS „ BI-PIN FLUORESCENT LAMP INSTALLATION/ VERIFICATION — Before applying power to the unit, verify that all lamps have been properly installed and are fully engaged in the lamp holders. Sizes 750L, 1100L, and 1300L have 2 lamps, one in the signboard and one inside the coo...

8 REFRIGERATION SYSTEM SERVICE COMPONENTS The Carrier Miracool™ refrigeration system consists of a hermetically sealed compressor and finned evapo- rator and condenser coils. „ CONDENSER — The condenser has wide finned spaces, which allow more air passage with less dirt or dust accumulation. The con...

10 TABLE 3 — REFRIGERATION SYSTEM SERVICE AND ANALYSIS CHART (Refer to Figures 10-12 for wiring diagrams) NOTE: All servicing must comply with state and federal regulations. MALFUNCTION POSSIBLE CAUSE SOLUTION Compressor Will Not Start —No Hum. 1. Line cord not plugged in. 1. Plug in the cord. 2. Po...

14 MAINTENANCE LAMP REPLACEMENT Remove lamp by rotating lamp 90 degrees to align lamp pins with holder slots. Refer to Bi-Pin Fluores- cent lamp Installation/Verification section on page 6. CONDENSATE REMOVAL The evaporator drain pan is located in the base of the cartridge. In general, the condensat...

15 TABLE 4 — METHODS FOR CLEANING STAINLESS STEEL *Use of brand names is intended only to indicate a type of cleaner and does not constitute an endorsement; nor does the omission of anybrand name cleaner imply its inadequacy. Many products named areregional in distribution and can be found in local ...