Cabletron Systems 924TXG - Manuals

Page 2 - clear; VISN Patch; Product

2 Firmware Requirements The DIGITAL MultiSwitch 900 Firmware Version 5.5 or higher is required to manage the following versions of network modules: We recommend you update your network module(s) to the latest revision. Refer to the following World Wide Web site for the latest module revision upgrade...

Page 3 - Known Conditions; Reset all MultiSwitch 924TXGs that are in the hub.; Walking SNMP v2 Objects through the 900 Hub

3 Known Conditions This section describes conditions and restrictions related to the DIGITAL MultiSwitch Fast Ethernet Switch 924TXG Version 1.1.1 firmware. DIGITAL MultiSwitch 900 Resets may adversely affect MultiSwitch 924TXG LAN Interconnect configurations The DIGITAL MultiSwitch 900 maintains an...

Page 4 - NOTE

4 SNMP Downloads Downloads using SNMP sets to the pcomLoad group are not supported in this release. Use the Download Software Menu within the console interface to upgrade the module. OBM and Console Ports Not Supported The OBM and console ports on the back panel of the DEChub ONE and DEChub ONE-MX a...

Page 5 - MultiSwitch Hub 924TXG

5 The number of backplane connection subtypes per module are listed in the following table: This limitation becomes a consideration in configurations that include modules with many subtype capabilities (i.e., greater subtype values). To determine whether a configuration will allow backplane connecti...

Page 6 - Connecting Two MultiSwitch 924TXGs in 2-Wire Mode; Diagnostics; The following features are not supported in this release:; clearVISN Flash Loader; Xmodem Upgrades

6 Connecting Two MultiSwitch 924TXGs in 2-Wire Mode There are two port-ranges relevant when connecting two MultiSwitch 924TXGs on the backplane using the 2-wire mode subtype. The two ranges are: Ports 7-9, 19-21; and Ports 10-12, 22-24. NOTE A port on one MultiSwitch 924TXG may only be connected to ...

Page 7 - Restrictions and Limitations; VLAN must be enabled to use Class of Service (priority queuing).; CAUTION

7 Restrictions and Limitations 1. Certain traffic patterns may occasionally place addresses into the forwarding table that have not been actually seen by the switch. The Source MAC address of error frames (64 bytes or greater in length) is improperly learned by the switch. 2. Error and dropped packe...

Page 9 - MIB and RFC Information; The following MIBs are supported:; Documentation; Installation and Configuration; Quick Start Card; Read Me First; Web Management Guide

9 MIB and RFC Information The following MIBs are supported: • Bridge-mib • ctron-smarttrunk-mib • ianaifType-mib • if-mib • igmp-mib • multiswitch-common-mib • netvantage-mib • p-bridge-mib • q-bridge-mib • rfc1155 • rfc1213 • rfc1398 • snmpv2-mib MIB and RFC information can be found online. Refer t...

Page 10 - Firmware Upgrades; If the module is in a Digital MultiSwitch 900, select; Main Menu

10 Firmware Upgrades This section describes the process for performing firmware upgrades for the DIGITAL MultiSwitch Fast Ethernet Switch 924TXG. To perform a firmware upgrade, complete the following instructions: If the module is in a Digital MultiSwitch 900, select Start Redirect Mode from the DIG...

Page 11 - Download Software Menu; Select f from the Main Menu to view the Download Software Menu.; Save Current Configuration; Select a to confirm the process select x or z to cancel the process.

11 Download Software Menu The Download Software Menu allows you to set up and initiate a software download. To set up and initiate a software download, do the following: 1. Select f from the Main Menu to view the Download Software Menu. 2. Observe the following message prompt display (menu selection...

Page 12 - Return to Default Configuration; Logout

12 Return to Default Configuration The Return to Default Configuration screen allows you to restore the original factory default switch settings before changes were made via the user interface or SNMP. To return to default configuration settings, do the following: 1. Select h from the Main Menu to v...

Page 13 - Accessing Online Information; Online Information

13 Accessing Online Information Online Information Product-specific information can be found at the following World Wide Web sites: http://www.cabletron.com/digital http://www.cabletron.com/dnpg/dr/hubs/firmware/ http://www.cabletron.com/dnpg/dr/clearvsn/patches/ Documentation Comments If you have c...