Page 4 - Box Scraper; WARRANTY POLICY; must; GOVERNMENT LEGISLATION:; This warranty does not apply to rentals
Box Scraper 1 WARRANTY POLICY Buhler Manufacturing products are warranted for a period of twelve (12) months (90 days for commercial application) from original date of purchase, by original purchaser, to be free from defects in material and workmanship under correct, normal agricultural use and prop...
Page 5 - INTRODUCTION; for a complete list of dealers in your area.
Box Scraper 2 INTRODUCTION The Buhler Farm King Box Scraper features two ½” x 6” replaceable, back-to-back blades to make this a bi-directional scraper. The scarifier shanks are heat treated and are easily adjusted for depth. The Box Scraper is available in 5’, 6’ & 7’ models . This product is Q...
Page 6 - SAFETY; The safety alert symbol means...; CAUTION; alert against unsafe practices.; WARNING; against unsafe practices.; DANGER
Box Scraper 3 SAFETY Remember, YOU are the key to safety. Good safety practices not only protect you, but also the people around you. Make these practices a working part of your safety program. Be certain that everyone operating this equipment is familiar with the recommended operating and maintenan...
Page 8 - SERVICE AND MAINTENANCE SAFETY; keep service area clean and dry; STORAGE SAFETY
Box Scraper 5 SERVICE AND MAINTENANCE SAFETY Stop engine, set brake, remove ignition key, and wait for all moving parts to stop before servicing, adjusting, repairing, or unplugging. Support the equipment with blocks or safety stands before working beneath it. Follow good shop practices including: -...
Page 9 - ASSEMBLY; Raise the Box Scraper off the ground.
Box Scraper 6 ASSEMBLY 1. Bolt the hitch (#2) and hitch braces (#3) to the frame (#1) using hardware supplied. 2. Use the position or draft mode on the three-point control to make a cut at constant depth. Use float when you want the scraper to follow the contour of the ground. The weight of the scra...
Page 10 - MAINTENANCE
Box Scraper 7 MAINTENANCE 1. Raise the Box Scraper off the ground. 2. Securely block up the frame. 3. Remove blade mounting bolts. 4. If the top side of the blade has not been used, reverse and reattach. If it has been used, replace blade. 5. Install mounting bolts and re-tighten.
Page 14 - NOTES
Page 16 - Buhler Manufacturing
DIVISION LOCATIONS U.S. WAREHOUSES Farm King Division 301 Mountain Street S. Morden, MB R6M 1X7 Ph.: (204) 822-4467 Fax: (204) 822-6348 Allied/Inland Division 1260 Clarence Avenue Winnipeg, MB R3T 1T2 Ph.: (204) 284-6100 Fax: (204) 477-2325 B.I.I. Division 1330 43 rd Street N.W. Fargo, ND 58102 Ph: ...