Bromic BH0420033 - Manuals - manualsarea.com

Page 2 - heating; IMPORTANT; by the following safety alert symbols:; NOTE: IMPORTANT INSTRUCTIONS, SAVE THESE INSTRUCTIONS

2 www.bromic .com/ heating ! IMPORTANT This manual contains important information about the installation, operation, and maintenance of Tungsten Smart-Heat™ Electric Heaters. Please pay close attention to the important safety information shown throughout this instruction manual. Any safety informati...

Page 3 - CONTENTS

3 www.bromic .com/ heating CONTENTS IMPORTANT NOTES & WARNINGS 4 PRODUCT OVERVIEW 5 PRODUCT DESCRIPTION AND FEATURES 5 SPECIFICATIONS 5 HEATER INSTALLATION 6 INSTALLATION CLEARANCES 6 CEILING WALL MOUNTING 7 CHAIN SUSPENSION 7 TUBE SUSPENSION 8 CEILING RECESS 9 ELEMENT INSTALLATION 11 ELECTRICAL...

Page 4 - IMPORTANT NOTES AND WARNINGS; WARNING

4 www.bromic .com/ heating IMPORTANT NOTES AND WARNINGS WARNING • Read all instructions before installing or using this heater • Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. • Improper instal...

Page 5 - PRODUCT OVERVIEW; CONTINUES; PRODUCT FEATURES; Model

5 www.bromic .com/ heating before use and at least annually serviced & inspected by a qualified & licenced service person. • Do not perform maintenance until heater has been turned off, power disconnected, and heater temperature has cooled to room temperature. • Check for damage to the appli...

Page 6 - HEATER INSTALLATION

6 www.bromic .com/ heating HEATER INSTALLATION INSTALLATION CLEARANCES FOR 2000W & 3000W MODELS 2000W & 3000w models must be installed with the minimum installation clearances shown in below diagrams. 2000W & 3000W models are supplied with short mounting brackets to be used for both ceil...

Page 7 - CEILING & WALL MOUNTING

7 www.bromic .com/ heating HEATER INSTALLATION CONTINUED... 24” 3” 35.5” 3” 2 3 4 2 3 CEILING & WALL MOUNTING (1) Mark mounting hole centres on ceiling or wall. (2) Attach mounting brackets to ceiling or wall using appropriate fasteners (Not supplied). (3) Bring heater up to mounting brackets an...

Page 8 - Suspension; TUBE SUSPENSION

8 www.bromic .com/ heating 31 575 625 2000W & 4000W Models Mounting Hole Centres & Heater Position 1 31 918 868 3000W & 6000W Models 2 Suspension 20 10 6.5 DETAIL Suspension SCALE 1 : 5 Suspension Tube Mounting Hole 3 4 6 7 5 8 9 1. Mark mounting hole centres on ceiling. Attach mounting ...

Page 9 - MODEL

9 www.bromic .com/ heating 9 www.bromicheating.com CEILING RECESS KIT (SOLD SEPARATELY) 1. Prepare ceiling cut out & ceiling box. Minimum ceiling box dimensions must be as shown in table. Heater must be installed with heater surface at least 2400mm above the floor level. HEATER INSTALLATION CONT...

Page 11 - ELEMENT INSTALLATION

11 www.bromic .com/ heating ELEMENT INSTALLATION 1. Remove the front cover from the heater. 2. Check that ring terminals are crimped securely to cables. 2000W & 3000W models have one cable at each end for assembly of one element. 4000W & 6000W models have two cables at each end for assembly ...

Page 13 - ELECTRICAL INSTALLATION

13 www.bromic .com/ heating ! WARNING This Heater MUST be permanently Installed and hard wired by an authorised/licenced person. Do Not perform maintenance, or carry out installation or assembly procedure while electrical power is switched on. 1. Check product label for correct voltage and wattage. ...

Page 14 - ELECTRIC AL INSTALLATION

14 www.bromic .com/ heating Junction Box AC Heater Element 1 240 V AC SINGLE PHASE EARTH WIRE WARNING 240 V AC Single Phase Heater must be permanently installed and hard wired by an authorised/licenced person. WARNING 240 V AC Single Phase Heater must be permanently installed and hard wired by an au...

Page 15 - MAINTENANCE; SERVICING; TUBE ELEMENT REPLACEMENT

15 www.bromic .com/ heating For longest product life & to maintain product appearance mount heater under cover & protect from rain & weather whenever possible. The exterior housing of the heater should be cleaned regularly with a soft damp cloth. For locations near the coast, salt in the...

Page 16 - REPLACEMENT PART LIST; SYMPTOM; TROUBLESHOOTING

16 www.bromic .com/ heating REPLACEMENT PART LIST No. Description BH0420002 (2000W) BH0420003 (3000W) BH0420004 (4000W) BH0420005 (6000W) 1 Tube Element BH8180001 BH8180002 BH8180001 BH8180002 2 Front Cover BH8180003 BH8180004 BH8180003 BH8180004 3 Element End Cover Set BH8180005 BH8180006 BH8180005...