Page 3 - Uncrating; IMPORTANT NOTE; Battery Installation; Connect Battery; WARNING
S200X 25HP & 27HP - 61” Mower Deck 7/2007 3 TP 300-7333-02-M2-SP Uncrating 1. Using a reciprocating utility saw or equivalent, cut crate away from bottom skid. Remove crate. Removeshrink-wrap plastic. 2. Cut nylon banding from front of the frame and rear rear bumper. 3. Open the hydraulic releas...
Page 4 - Motion Control Handle Assembly; Seat Assembly
S200X 25HP & 27HP - 61” Mower Deck TP 300-7333-02-M2-SP 7/2007 4 TractorAssembly Motion Control Handle Assembly 1. Remove the handles and mounting hardware from the handle bar box. 2. Install the ground speed control handles (A, Figure 4) onto the control lever base using the 5/16-18 x 3/4”bolts...
Page 5 - Roll Bar Installation; Install the Roll Bar
S200X 25HP & 27HP - 61” Mower Deck 7/2007 5 TP 300-7333-02-M2-SP Roll Bar Installation Install the Roll Bar 1. Unpack the roll bar and hardware from the box. 2. Place the roll bar in to the roll bar pockets (A, Figure 6) on the frame. Refer to Figure 7 for the correct rollbar orientation. 3. Ins...
Page 6 - Check Tire Pressures
S200X 25HP & 27HP - 61” Mower Deck TP 300-7333-02-M2-SP 7/2007 6 CheckFluid Levels Check the Engine Oil Level 1. Use the dipstick (A, Figure 8) to check the engine oil level. If necessary add engine oil. Check the enginemanufacturer’s owner’s manual for the oilrecommendations. Check the Hydrauli...
Page 7 - Check Torque - Mower Blades
S200X 25HP & 27HP - 61” Mower Deck 7/2007 7 TP 300-7333-02-M2-SP Check the MowerAssembly Check Torque - Mower Blades 1. Park the machine on a flat, level surface and engage the parking brake. 2. Lock the deck lift pedal in the 5” (12,7 cm) position. 3. Check that blades are installed with the ta...
Page 9 - Check Deck Rod Timing
S200X 25HP & 27HP - 61” Mower Deck 7/2007 9 TP 300-7333-02-M2-SP Check Deck Rod Timing 1. Park machine on a flat, level surface. Disengage the PTO, stop the engine and engage the parking brake.Rear tires must be inflated to 15 psi (1,03 bar); fronttires to 25 psi (1,72 bar). 2. To check the lift...
Page 11 - Check Deck Drive Belt
S200X 25HP & 27HP - 61” Mower Deck 7/2007 11 TP 300-7333-02-M2-SP Check Deck Drive Belt 1. Lower the mower deck to its lowest cutting position. 2. Remove the mower deck guards. 3. Make sure the V-side of the belt runs in the pulley grooves (Figures 21 & 22). 4. For 61” Models: If the belt is...
Page 12 - Lubrication
S200X 25HP & 27HP - 61” Mower Deck TP 300-7333-02-M2-SP 7/2007 12 Lubrication Lubricate the unit at the locations shown in Figure 25through 28 as well as the following lubrication points. Grease: • front caster wheel axles and yokes• deck lift pivot blocks• mower deck spindles• mower deck idler ...
Page 14 - Functional Tests; Operational SAFETY Checks
S200X 25HP & 27HP - 61” Mower Deck TP 300-7333-02-M2-SP 7/2007 14 Perform theSafety Checks Functional Tests 1. Check the tractor for loose bolts, screws, nuts, etc. 2. Start the engine and check all the controls for proper operation: ground speed control levers, parkingbrake, throttle cable, ele...
Page 15 - Seat Adjustment
S200X 25HP & 27HP - 61” Mower Deck 7/2007 15 TP 300-7333-02-M2-SP AdjustmentProcedures Seat Adjustment See Figure 30. The seat can be adjusted forward andbackward. Move the lever forward, position the seat asdesired, and release the lever to lock the seat intoposition. A Figure 30. Seat Adjustme...
Page 18 - CAUTION
S200X 25HP & 27HP - 61” Mower Deck TP 300-7333-02-M2-SP 7/2007 18 Figure 35. Parking Brake AdjustmentA. Brake SpringB. Adjustment Nut Parking BrakeAdjustment 1. Disengage the PTO, engage the parking brake, stop the engine and remove the ignition key. 2. Locate the brake spring (A, Figure 35). 3....