Briggs & Stratton 1695354 - Manuals

Page 2 - SAVE THESE INSTRUCTIONS; READ THE MANUAL; Hazard Symbols and Meanings; DANGER

SAVE THESE INSTRUCTIONS READ THE MANUAL The operator’s manual contains important safety information you need to be aware of BEFORE youoperate your unit as well as DURING operation. Safe operating techniques, an explanation of the product’s features and controls, and maintenanceinformation is include...

Page 3 - Table of Contents; Normal Removal

Table of Contents Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Safety Decals . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

Page 4 - Safety; GENERAL WARNINGS; SAFETY DECALS; WARNING

2 Safety • Know the unit’s controls and how to stop quickly. READ THE OPERATOR’S MANUALS. • Read and obey all safety decals.• Only allow responsible adults, who are familiar with the instructions, to operate the unit. • Disengage the PTO. Shut off the engine and wait for all moving parts to stop bef...

Page 5 - After Operation; CAUTION

3 Before Operation Clear the lawn of all sticks, stones, wire and otherdebris which may be caught or thrown by the mowerblades. Check grass condition. If wet, wait until later in theday. If grass is wet, the grass catcher is likely tobecome plugged. For efficient bagging, air circulation under themo...

Page 7 - Assembly

5 INSTALL MOUNTING PLATES -BROADMOOR / 1600 / 2600 / LTSERIES Install Plates & Spacers 1. Mount the side brackets (C, Figure 1) to both sides of the frame using the holes shown. Securewith one 3/8-16 x 1 capscrew (D), 3/8 lockwasher(B), and 3/8-16 nut (A) per side. 2. Install the rear spacers (C...

Page 8 - Remove Blowout Baffle

6 Assembly Remove Blowout Baffle 1.Remove and discard short blowout baffle (C, Figure 4), carriage bolts (B) and locknuts (D) from mowerdeck (A). Figure 4. Baffle RemovalA. Mower DeckB. Carriage Bolts,5/16-18 x 3/4C. Blowout Baffle, ShortD. Nuts, Whizlock, 5/16-18 x 3/4 C A D D B Install Baffles 1. ...

Page 10 - Install Components

8 Assembly Figure 8. Install Lower Chute and Pin to BootA. Pin, LatchB. Carriage Bolt, 1/4-20 x 5/8C. Locknut, 1/4-20D. Lower ChuteE. Locknut, Center Lock, 5/16-18F. Strap, RubberG. Locknuts, Whiz Lock, 5/16-18H. Rod, Boot MountI. Capscrew, Hex Head, 5/16-18 x 1-1/4 J. Capscrew, Hex Head, Thin, 5/16...

Page 16 - Collector Installation; Normal Removal & Installation

14 Normal Removal & Installation A. Hitch Support AssemblyB. Cover K. Nut & Capscrew C. Pin L. Mounting plate D. Hair Pins M. Lower Chute Rod E. Bag N. Lower Chute F. Grass Bag Hanger O. Pin G. Upper Tube P. Strap, Middle H. Middle Tube Q. Ridge I. Strap, Boot R. Ridge Cutout J. Deflector S....

Page 17 - Collector Removal

15 Normal Removal & Installation Collector Removal 1. Unhook strap (P, Figure 17) from pin (O). Slide middle tube (H) into upper tube (G) and removemiddle tube (H). Remove upper tube (G) fromcover (B). 2. Lift up cover (B) remove and empty bags (E). 3. Unhook strap (I) from locknut and capscrew ...