Page 2 - Dishwasher; FOR YOUR SAFETY; IMPORTANT; KEEP THESE INSTRUCTIONS.; WARNING; If you have an installation problem, contact your
Installation Instructions Dishwasher IMPORTANT – The dishwasher MUST be installed to allow for future removal from the enclosure if service is required.If you received a damaged dishwasher, you should immediately contact your dealer or builder. FOR YOUR SAFETY Read and observe all CAUTIONS and WARNI...
Page 3 - For New Installations Only:; Installation Preparation; MATERIALS YOU WILL NEED :; Materials For New Installations Only:
TOOLS YOU WILL NEED: Phillips head screwdriver 5/16" and 1/4" nutdriver 6" Adjustable wrench Level Carpenters square Measuring tape Safety glasses Flashlight Bucket to catch water when flushing the line Gloves For New Installations Only: Tubing cutter Drill and appropriate bits Hole saw s...
Page 4 - DRAIN REQUIREMENTS; Clearance for Door
3 Installation Preparation DRAIN REQUIREMENTS • Follow local codes and ordinances. • Do not exceed 10 feet distance to drain. • Do not connect drain lines from other devices to the dishwasher drain hose. • Dishwasher must be connected to waste line with an air gap (not supplied) or 32" minimum h...
Page 5 - Cabinet Preparation & Wire Routing; • The wiring may enter the opening from either side,; Electrical Connection to Dishwasher; • For power cord connections, install a 3-prong grounding; PREPARE ELECTRICAL WIRING; Electrical Requirements
4 Installation Preparation Cabinet Preparation & Wire Routing • The wiring may enter the opening from either side, rear or the fl oor within the shaded area. • Cut a 1-1/2" max. dia. hole to admit the electrical cable. The hole must be free of sharp edges. If the cabinet wall is metal, the h...
Page 7 - Installation Instructions; STEP 5 INSTALL 90° ELBOW; Do not use; STEP 3 REMOVE TOEKICK; Skip this step if dishwasher will be direct wired.; Adjust
6 Remove Junction Box Cover Installation Instructions • Do not over tighten 90° elbow, water valve bracket could bend or water valve fitting could break. • Position the end of the elbow to face the bottom dishwasher. STEP 5 INSTALL 90° ELBOW • Wrap 90° elbow with thread seal tape. Do not use plumber...
Page 9 - STEP 9 POSITION DISHWASHER UNDER COUNTERTOP; STEP 10 LEVEL DISHWASHER
Do Not Push AgainstFront Door Panel With Knee. Damage to The Door Panel Will Occur. Reposition Dishwasherby Grasping BothSides With Hands STEP 9 POSITION DISHWASHER UNDER COUNTERTOP • Check to be sure that wires are secure under the dishwasher and not pinched or in contact with door springs or other...
Page 10 - TO THE COUNTERTOP; STEP 12 CONNECT WATER SUPPLY; METHOD 1
9 Installation Instructions STEP 11 SECURE DISHWASHER TO THE COUNTERTOP IMPORTANT – Drive screws straight and flush. Protruding screw heads will scratch the top of the control panel and can interfere with door closing.If the gap is less than STEP 12 CONNECT WATER SUPPLY Connect water supply line to ...
Page 11 - STEP 13 CONNECT DRAIN LINE; DRAIN LINE INSTALLATION; Fasten to underside
10 Installation Instructions • If a longer drain hose is required, add up to 42" of length for a total of 10 ft. to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps. STEP 13 CONNECT DRAIN ...
Page 12 - STEP 15 PRE-TEST CHECKLIST
11 Installation Instructions STEP 15 PRE-TEST CHECKLIST Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty. Check to be sure power is OFF. Open door and remove all foam and paper packaging. Locate the Owner’s Manual in the liter...
Page 13 - STEP 17 REPLACE TOEKICK
12 Installation Instructions • Figure Z STEP 17 REPLACE TOEKICK STEP 16 DISHWASHER WET TEST Turn on power supply (or plug power cord into outlet, if equipped).Turn on your dishwasher (please refer to the Owner's Manual for instructions).Close door, select RINSE ONLY cycle and press START/CANCEL.Chec...
