Bowers & Wilkins FP31062 M1MKII - Manuals

Page 2 - IS; Contents; Moving the ball socket position; Removing the table stand base; Connecting using the table stand; ENGLISH

2 E N G L IS H www.bowers-wilkins.com Welcome to Bowers & Wilkins and M-1 Thank you for choosing Bowers & Wilkins. When John Bowers first established our company he did so in the belief that imaginative design, innovative engineering and advanced technology were keys that could unlock the en...

Page 3 - Contents

3 E N G L IS H 1 Contents Check that you have: 1. Speaker on table stand2. Wall bracket cover3. Wall bracket The wall bracket and cover are supplied clipped together. Pull them apart if required for installation. If you peel off the rubber mat on the underside of the table stand, you will find a Tor...

Page 4 - This method of fixing is; Use the supplied Torx key.; Figure 8

E N G L IS H 3 Moving the ball socket position You can skip all of Section 3 completely if you are going to use the speaker in portrait orientation on its table stand as supplied, or you want to mount it high on the wall with maximum downward tilt (Figure 7). Note: To achieve maximum tilt, it is nec...

Page 5 - Replace the rubber mat.

E N G L IS H 4 Connecting using the table stand Remove the rubber mat from the underside of the base (Figure 15). Strip back the outer sheath of the cable by 75mm (3 in) to expose the two inner sheathed wires. Strip back the positive and negative wires to expose 10mm (3/8 in) of bare wire. If using ...

Page 6 - Adjusting the angle of the speaker; CH

E N G L IS H 6 Adjusting the angle of the speaker There are two screws next to the ball socket joint at the back of the speaker that tighten the joint to hold the speaker in place. It is only necessary to loosen one of these to free the joint. Indeed, in portrait orientation, only one screw will be ...

Bowers & Wilkins FP31062 M1MKII - Manuals

Manuals:

User Manual Bowers & Wilkins FP31062 M1MKII

Summary