Blanco CGG905WFFC - Manuals

Page 2 - DESCRIPTION OF HOBS

2 Natural Propane 1 Ultra rapid gas burner/WOK 17.0 MJ/h 16.2 MJ/h 2 Rapid gas burner 12.0 MJ/h 10.4 MJ/h 3 Semirapid red. gas burner 5.4 MJ/h 4.86 MJ/h 4 Semirapid gas burner 7.1 MJ/h 6.3 MJ/h 5 Auxiliary gas burner 4.1 MJ/h 3.6 MJ/h 7 Cast iron trivet pan support 2F 8 Cast iron trivet pan support ...

Page 3 - USE

USE FIG. 1 FIG. 2 1) BURNERS A diagram is screen-printed above each knob on the front panel. This diagram indicates to which burner the knob in question corresponds. After having opened the gas mains or gas bottle tap, light the burners as described below: - automatic electrical ignition Push and tu...

Page 5 - CLEANING

5 CLEANING IMPORTANT: always disconnect the appliance from the gas and electricity mains before carrying out any cleaning operation. 2) HOT PLATE Periodically wash the hot plate, the enamelled steel pan support, the enamelled burner caps “C” a n d t h e b u r n e r h e a d s “ M ” ( s e e f i g . 3 ...

Page 6 - INSTALLATION; COMPLY WITH THE DIMENSIONS; C D; TECHNICAL INFORMATION; ) INSTALLING THE HOT PLATE

6 INSTALLATION FIG. 4 COMPLY WITH THE DIMENSIONS (in mm) A B C D E 2F (30) 285 473 59 59 100 min. 2F (45) 285 473 63.5 63.5 117 min. 4F (60) 553 473 63.5 63.5 173.5 min. 4F - 5F (70) 645 473 63.5 63.5 173.5 min. 5F (90) 833 475 62.5 62.5 73.5 min. TECHNICAL INFORMATION FOR THE INSTALLER This applian...

Page 7 - ) FIXING THE HOT PLATE

7 4) FIXING THE HOT PLATE The hot plate has a special seal which prevents liquid from getting into the cabinet. Strictly comply with the following instructions in order to correctly apply this seal: - take off all the movable parts of the hob. - Cut the seal in 4 parts of the necessary lenght to pos...

Page 8 - ) ELECTRICAL CONNECTION

8 5) GAS CONNECTION The gas connection is located in the rear and on the underside of the appliance 100 mm from the right hand side. There are two ways to carry out the connection to the main gas line: A. The hotplate can be connected with rigid pipe as specified in AS5601 table 3.1. B. If installin...

Page 9 - ADJUSTMENTS

9 ADJUSTMENTS Always disconnect the appliance from the electricity main before making any adjustments. All seals must be replaced by the technician at the end of any adjustments or regulations. Our burners do not require primary air adjustment. a) Data Label The Data Label is located on the undersid...

Page 10 - CONVERSIONS; ) PROPANE GAS TO NATURAL GAS; ) NATURAL GAS TO PROPANE GAS

10 CONVERSIONS 8) PROPANE GAS TO NATURAL GAS CONVERSION PROCEDURE Appliance models: Gas stainless steel hotplate models: 1. Remove each burner cap and burner skirt. 2. Remove the Propane Gas main injector with a 7 mm/VF tube spanner and replace with the appropriate size Natural Gas injector for each...

Page 11 - 0) REPLACING THE INJECTORS; TABLE 1

11 CONVERSIONS 10) REPLACING THE INJECTORS The burners can be adapted to different types of gas by installing injectors suited to the type of gas required. To do this, first remove the burner tops using a wrench “B”. Now unscrew injector “A” (see fig. 11) and fit a injector corresponding to the type...

Page 12 - SERVICING; 1) COMPONENT REPLACEMENT

SERVICING WARNING: s e r v i c i n g s h o u l d b e c a r r i e d o u t o n l y b y authorised personnel. 11) COMPONENT REPLACEMENT NOTE: BEFORE ANY MAINTENANCE REQUIRING R E P L A C E M E N T O F A C O M P O N E N T I S U N D E RTA K E N E N S U R E T H AT T H E ELECTRICAL LEAD HAS BEEN ISOLATED A...

Page 13 - CABLE TYPES AND SECTIONS

FIG. 17 SERVICING Gas hot plate H05 RR - F Section 3 x 0.75 mm 2 TYPE OF TYPE OF SINGLE - PHASE HOT PLATE CABLE POWER SUPPLY CABLE TYPES AND SECTIONS ATTENTION!!! If the power supply cable is replaced, the installer should leave the ground wire longer than the phase conductors (fig. 17) and comply w...

Page 14 - TECHNICAL ASSISTANCE AND SPARE PARTS; BLANCO CUSTOMER SERVICE

14 TECHNICAL ASSISTANCE AND SPARE PARTS BLANCO CUSTOMER SERVICE 1300 739 033 www.meaappliances.com.au SALES OFFICES AND SHOWROOMS SERVICE AND SPARE PARTS NEW SOUTH WALES. QUEENSLAND. Head Office, Sales and Marketing Brisbane. 104 Vanessa Street. Endeavour Refrigeration and Appliance Service. Kingsgr...

Page 15 - WARRANTY SECTION

15 WARRANTY SECTION 1.Subject to the “Statement of Standard Warranty Conditions” this product is covered by the following Warranty. TWO (2) YEARS WARRANTY from date of purchase, covering all parts and labour. 2. The appliance is warranted under normal single family domestic installation and use, as ...