Page 4 - Contents
3 Contents 1. Safety and operating instructions ___________________________ 4 2. Installation and hook-up __________________________________ 7 3. Description of the controls _______________________________ 11 4. Operating instructions ___________________________________ 19 5. Cleaning and maintenanc...
Page 5 - Safety and operating instructions
4 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, ...
Page 8 - Installation instructions; door hinge area must be covered for safety
Installation instructions 7 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source...
Page 10 - Electrical connection and precautions
9 2.1 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGUL...
Page 11 - THIS APPLIANCE IS EQUIPPED WITH 10 AMP 3 PIN PLUG'.; Class of protection against electric shock: I
10 AN OMNIPOLAR CIRCUIT BREAKER IN OVERVOLTAGE PROTECTION CLASS III MUST BE INSTALLED IN AN EASILY ACCESSIBLE POSITION ON THE POWER SUPPLY LINE. THE CONNECTION TO THE MAINS MUST BE CARRIED OUT BY A QUALIFIED TECHNICIAN IN ACCORDANCE TO THE SCHEME SHOWN BELOW AND THE REGULATIONS IN FORCE. THIS APPLIA...
Page 12 - Description of the controls; Front panel; DOOR HANDLE
11 3. Description of the controls 3.1 Front panel All the dishwasher control are grouped on the front panel. Programming and option selection are only possible with the door closed. 1 ON/OFF BUTTON 2 SELECTION PROGRAM BUTTON 3 PROGRAM PHASE INDICATOR LIGHTS 4 START/PAUSE BUTTON 5 PROGRAM STARTED/STO...
Page 13 - Only run the soak program with partial loads.; or 2 cold rinses depending on the model.
12 SETTING THE WASHING PROGRAM This dishwasher has 10 wash programs as per the following 2 pages. To select the most suitable program for the dishes to be washed refer to the table below, which indicates the most appropriate program according to dish type and degree of soiling. PROGRAM SELECTION TYP...
Page 14 - ADVANCE PROGRAMS; (see relevant section for explanation of functioning modes)
13 ADVANCE PROGRAMS (see relevant section for explanation of functioning modes) PROGRAMME NUMBER E SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MINUTI (1) WATER LITRES POWER KWh (1) 6 RAPID 27’ + Dishes with light dirt, washed immediately after use Wash at 38°C Rinse at 50°...
Page 15 - Washing programs; Before starting a washing program make sure that:; AUTOMATIC OPENING DOOR
14 3.2 Washing programs The dishwasher is equipped with a control panel an and 3-FIGURE DISPLAY (12), “section 3.1” described in chapter "3. Description of the controls", from which it is possible to carry out all the power switch-on, switch-off and programming operations. Before starting a ...
Page 16 - ADVANCE PROGRAMS OPTION; PROGRAMMING; SELECTION PROGRAM
15 ADVANCE PROGRAMS OPTION These 5 extra programs in addition to the previous ones can be selected directly using the program selector button. This button must be pressed (the light comes on) after selection of the “main” program (1,2,3,4 or 5). This function is retained in the memory, so the button...
Page 17 - program delay returns to zero; START THE DISHWASHER
16 DELAYING THE PROGRAM The PROGRAM DELAY button (6) can be pressed to delay the start of the washing program by up to 24 hours. This means that the dishwasher can be operated at the time of day of your choice. Press the PROGRAM DELAY button (6) again; the 3-FIGURE DISPLAY (12) (Section 3.1) will sh...
Page 18 - END PROGRAM; Always try to run the dishwasher fully loaded.; ENERGY MANAGEMENT
17 If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed. After correctly closing the door, press the START/PAUSE button (4) again. This operation may negatively affective the progress of the washing cycle. END PROGRAM T...
Page 19 - Operating instructions; Using the rinse aid and detergent dispensers
18 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Add the rinse aid and detergent. 4.1 Using the rinse aid and detergent dispensers The detergent and rinse aid dispensers are situated on the inner part of the door: the detergent dispenser is...
Page 22 - General warnings and recommendations
21 The introduction of detergent into the rinse aid dispenser, even in liquid form, will damage the dishwasher. 4.2 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be washed and their ...
Page 24 - Accessories on lower basket:
23 4.3 Using the baskets The dishwasher has a capacity of 15 place-settings, including serving dishes. LOWER BASKET The lower basket receives the full force of the lower spray arm, and should therefore be used for the “toughest” items with a heavier degree of soiling. All types and combinations of l...
Page 26 - LOADING THE LOWER BASKET
25 To lie completely flat, lift the end and turn it towards you so that the retainer F rotates into place above point S. LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them vertically. Pots, pans and their covers must be loaded upside down. ...
Page 27 - FLEXIBLE SPLIT CUTLERY TRAY
26 FLEXIBLE SPLIT CUTLERY TRAY This comprises two independent sliding, pull-out tray racks for easier loading/unloading of cutlery. Various loading systems and configurations are possible. For example, tea cups can be loaded with the right-hand rack set in the low position, while the left-hand rack ...
Page 28 - STANDARD CUTLERY BASKET
27 STANDARD CUTLERY BASKET The basket has removable top grids into which items of cutlery should be inserted to keep them properly spaced and allow water to pass between them effectively. The top grids and central lid are in the bag of accessories. The central lid functions as a lid only. The top gr...
Page 30 - Accessories on upper basket:
29 Accessories on upper basket: - Supports for cups or long objects (ladles, spoons…), on the left; can be tipped to the vertical position when not in use. - Long-stemmed glass holder, on the left; to use, simply lift and fix onto the hooks provided. - Cutlery racks, on the right, designed for knive...
Page 31 - ADJUSTING THE UPPER BASKET
30 ADJUSTING THE UPPER BASKET The height of the top basket can be adjusted to allow large dishes or pans to be placed in the bottom basket. It is a third level adjustable upper basket and therefore can be adjusted to 3 different levels. The sides of the basket must always be set at the same height. ...
Page 32 - Cleaning and maintenance
31 5. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of th...
Page 33 - CLEANING THE FILTER UNIT; remove the centre filter by lifting it upwards.
32 CLEANING THE FILTER UNIT • It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn them anticlockwise and lift upwards; • push the centre filter D from the underside to remove it from the micro-filter: • separate the tw...
Page 36 - To “reset” an alarm is necessary:
35 6. Troubleshooting The dishwasher is equipped with a self-diagnostics system that is capable of detecting and signalling a number of possible faults TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM FAULT DESCRIPTION E1 The anti-flooding system (where present) has been tripped. E2 The water...
Page 37 - 5 Standard place settings; Water supply pressure; See rating plate
36 TECHNICAL DATA Width 598 mm Depth measured flush with the outer edge of the control panel 570 mm Height 868 mm Capacity 15 Standard place settings Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) Electrical characteristics See rating plate
Page 40 - relevant electrical & plumbing regulation in their State.; WHAT IS COVERED: By Our Warranty
During the warranty period, Blanco or its authorised Service Centre will at noextra charge, if your appliance is readily accessible without the need of specialequipment and subject to the terms and conditions of this warranty, repair orreplace any parts which it considers defective. 1. Products inst...
