Page 2 - GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES; READ ALL INSTRUCTIONS; • DON’T OVERREACH. Keep proper footing and balance at all times.
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES READ ALL INSTRUCTIONS WARNING: Read and understand all instructions before operating product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.• AVOID DANGEROUS ENVIRONMENT. Don’t use ...
Page 3 - SAFETY GUIDELINES / DEFINITIONS; result in death or serious injury.; SAVE THESE INSTRUCTIONS
• DO NOT OPERATE portable electric tools near flammable liquids or in gaseous orexplosive atmospheres. Certain components in these tools normally spark, and thesparks might ignite fumes.• EXTENSION CORDS. Make sure your extension cord is in good condition. When using anextension cord, be sure to use...
Page 4 - IMPORTANT SAFETY INSTRUCTIONS
THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FORTHE POWER TO GO ® MODEL CPI20XB. WARNING: TO REDUCE THE RISK OF INJURY: • Follow these instructions and those published by the manufacturer of any equipment youintend to use with this unit. Review cautionary markings on these produc...
Page 6 - INTRODUCTION; Thank you for choosing the; CPI20XB POWER TO GO; FEATURES; Controls and Indicators
INTRODUCTION Thank you for choosing the CPI20XB POWER TO GO ® . A convenient, easy-to- carry, rechargeable portable power source that supplies energy for 115 volt ACand USB powered personal electronic devices.This unit can be used to operate and recharge personal electronics, such asdigital/video ca...
Page 7 - The POWER TO GO; POWER TO GO
HOW THE POWER TO GO ® WORKS The POWER TO GO ® is a power inverter with built-in batteries. A power inverter is an electronic device that converts low voltage DC (direct current) electricityfrom a battery to 115 volt AC (alternating current) household power. Indesigning this inverter, Black & Dec...
Page 8 - OPERATING INSTRUCTIONS; Charging the POWER TO GO; and plug the standard two-prong plug into an appropriate,; Operating the POWER TO GO; Once fully charged (see “Charging the POWER TO GO; USB Power Port
OPERATING INSTRUCTIONS Charging the POWER TO GO ® Attach the barrel tip of the AC Charging Adapter to the AC Charging Port of thePOWER TO GO ® and plug the standard two-prong plug into an appropriate, functioning 120 volt AC outlet. The red Battery Status LED Indicator will flash,indicating a proper...
Page 9 - Protective Features; The inverter monitors the following conditions:; OPERATING TIPS
power consumption is rated in amps AC, simply multiply by the AC volts (115)to determine the wattage. Resistive loads are the easiest for the inverter to run; however, it will not run largerresistive loads (such as electric stoves and heaters), which require far morewattage than the inverter can del...
Page 10 - CARE AND MAINTENANCE; Storage; WARNINGS: TO REDUCE THE RISK OF INJURY / EXPLOSION; TROUBLESHOOTING; Common Audio/Visual Problems
CARE AND MAINTENANCE Storage 1. Make sure that the 115 Volt AC and USB receptacle covers are functioning properly and are in the closed position covering the receptacles when storing thePOWER TO GO ® . 2. Ideal storage temperature range is 0-40°C (32-104°F). 3. Store and use the POWER TO GO ® in a c...
Page 11 - TROUBLESHOOTING GUIDE; Common Power Output Problems – 115 Volt AC; Possible Cause; Recommendations
TROUBLESHOOTING GUIDE Common Power Output Problems – 115 Volt AC Possible Cause Recommendations Red battery status LED indicator is Unit is in charging mode. For optimum flashing and there is no output results, allow unit to complete chargingcycle before using. Battery Status LED indicators are Char...
Page 12 - Accessories; WARNING: The use of any accessory not recommended for use with this; tool could be hazardous.; Service Information
Accessories Recommended accessories for use with your tool are available from your localdealer or authorized service center. If you need assistance regardingaccessories, please call: 1-800-544-6986. WARNING: The use of any accessory not recommended for use with this tool could be hazardous. Service ...
Page 13 - SPECIFICATIONS
SPECIFICATIONS Input: 8.4 V DC, 5.0A Inverter Output: 115 V AC, 60Hz, 20 watts for 5 minutes,16 watts continuous USB Output: 5 V DC (350mA) Batteries: 1.2 AH NiMH Imported byBlack & Decker (U.S.) Inc.,701 E. Joppa Rd.Towson, MD 21286 U.S.A. Vector Products, Inc 4140 SW 28th Way Fort Lauderdale, ...