Page 2 - TABLE OF CONTENTS; INSTALLATION CLEARANCES; WARNINGS; adhere to all local, state and national electric codes.; READ AND SAVE THESE INSTRUCTIONS; is manual for future reference.
2 TABLE OF CONTENTS 1 - SAFETY ............................................................................................................................................................ 3 2 - INSTALLATION INSTRUCTIONS ...................................................................................
Page 3 - IMPORTANT INSTRUCTIONS; Read all instructions before; SAFETY; Do not use the heater together with; WARNING: PERSONAL INJURY HAZARD - OPERATION
3 IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following outlined in section 1 – SAFETY. Read all instructions before installing or using this heater. 1 - SAFETY W...
Page 4 - The heater must be installed at level on a; SAVE THESE INSTRUCTIONS
4 WARNING: PERSONAL INJURY HAZARD - CLEANING AND MAINTENANCE ● To avoid property damage, personal injury or deathdue to electrical shock DO NOT service the unitwithout turning the unit OFF and disconnecting theheater from the main power supply. ● Before cleaning the unit or replacing the emitter,tur...
Page 5 - INSTALLATION; The minimum clearances indicated on the nameplate and in the user
5 2 - INSTALLATION INSTRUCTIONS Heater installation must be carried out by qualified personnel in compliance with local National Codes (NEC) as well as any other applicable standards. Failure to comply with applicable requirements could result in personal injury and/or property damage. Wiring proced...
Page 6 - ’ in Canada, and 7’ in USA
6 2.2 INSTALLATION CLEARANCES – CEILING MOUNT This heater works best when installed 8’ in Canada, and 7’ in USA when measured to the bottom of the heater. The minimum mounting height in Canada is 8’, and 6’7” in USA measured to the bottom of the heater. In outdoor environments it is not recommended ...
Page 7 - in CANADA and 7
7 2.3 INSTALLATION ON HIGH CEILINGS When installing the heater on high ceilings, it is highly recommended to suspend the heater to ensure optimal heating performance. In outdoor environments it is not recommended to mount the bottom of the heater above 8’ in CANADA and 7 ’ in USA. This section will ...
Page 8 - Safety Precautions; with standard 4” brackets.
8 2.4 ELECTRICAL INSTALLATION Safety Precautions 1. Each power supply circuit must be properly grounded.2. Use a certified ground fault protection device for wet environment installations.3. Use a proper electrical connection box.4. Supply voltage and frequency must correspond to the electrical rati...
Page 9 - WARNING; ceiling bolts or anchors are not supplied.; NEVER direct the infrared heat produced
9 2.6 CEILING MOUNTED INSTALLATION WARNING Heater should be hung using rigid mounting brackets, the unit must not be able to swing in any direction under applied load from wind or persons. The unit must be installed using the supplied brackets or Aura Shadow extension brackets. 1. Secure the heater ...
Page 10 - tighten the fixing bolts.; Notice; INCORRECT
10 2.7 ADJUSTING DIRECTIONAL POSITIONING WARNING Never attempt to move or adjust the heater angle while it is running. Personal injury could result. 1. Turn off the heaters electrical supply line from the main power supply.2. Allow the heater to cool before adjusting the angle.3. Loosen the fixing b...
Page 11 - MAINTENANCE; Allow the heater and the emitter to cool down before handling.; CLEANING; To remove dust or dirt on the reflector, follow these steps:
11 3 - MAINTENANCE WARNINGS 1. Allow the heater and the emitter to cool down before handling. 2. Installation and maintenance must be performed by a qualified technician. 3. Turn off the power before beginning maintenance. 4. Do not attempt to service or repair the unit while it is running. 5. Should...
