Page 2 - WARNING; Installation instructions; A gas nozzle; Requirements
2 WARNING Read this instruction booklet before installing and using the appliance. The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or improper use of the appliance. The manufacturer reserves the right to make changes to its products ...
Page 3 - INSTALLATION MANUAL; BACKGUARD INSTALLATION INSTRUCTION; WORKTOP FRONTGUARD INSTALLATION INSTRUCTIONS
3 INSTALLATION MANUAL BACKGUARD INSTALLATION INSTRUCTION Please follow the following installation instructions afther installing the cooktop: 1) Remove n°2 screws fixing worktop as shown in fig.1 2) Place front part of the backguard and attach it from bottom side with the two removed screws (point 2...
Page 4 - PROXIMITY TO SIDE CABINET INSTALLATION; MIN
4 PROXIMITY TO SIDE CABINET INSTALLATION 1. This rangetop may be installed directly adjacent to existing 36" (91.5 cm) high base cabinets. IMPORTANT: The top grate support MUST be 3/8" (.95 cm) above the adjacent base cabinet countertOP. 2. The rangetop CANNOT be installed directly adjacent ...
Page 5 - Electrically ground appliance
5 COOKER HOOD INSTALLATION The bottom of the hood should be 25 ½ " (65 cm) min. to 31 ½ " (80 cm) above the countertop. Refer to the rangehood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood. ELECTRICAL CONNECTION Th...
Page 6 - and dangerous operation.; CAUTION; and dangerous operation.
6 Wiring diagram For freestanding gas range model C36600X ( Z36 6 00 X ) C3Y0..U4X(2 or 5)A CAUTION : label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. For freestanding gas range model C3...
Page 7 - GAS CONNECTION
7 GAS CONNECTION All gas connections must be made according to national and local codes. This gas supply (service) line must be the same size or greater than the inlet line of the appliance. This range uses a 1/2" NPT (see fig. in this chapter for details of gas connections installations) inlet....
Page 8 - - CHANGING THE NOZZLES FOR USE WITH OTHER TYPES OF GAS:
8 REPLACEMENT PARTS Only authorized replacement parts may be used in performing service on the appliance. Replacement parts are available from factory authorized parts distributors. CONVERSIONE TO DIFFERENT TYPES OF GAS Before carrying out any maintenance work, disconnect the appliance from the gas ...
Page 10 - SERVICE & MAINTENANCE INSTRUCTIONS; USER MANUAL; DESCRIPTIONS; DESCRIPTIVE CAPTION FOR HOB; CONTROL PANEL DESCRIPTION
10 SERVICE & MAINTENANCE INSTRUCTIONS Service and maintenance only to be carried out by an authorised person To replace parts such as burners, valves and electric components, the appliance must be open removing the worktop. Note: if the valves must be replaced, first disassemble the ignitions sw...
Page 11 - USING BURNERS; Burner; Medium; Correct usage of pans:
11 USING BURNERS A diagram is etched on the control panel above each knob which indicates which burner corresponds to that knob. Manual ignition: Manual ignition is always possible even when the power is cut off or in the event of prolonged power failure. Turn the knob that corresponds to the burner...
Page 12 - CLEANING THE APPLIANCE:; BERTAZZONI SPA; SERVICE CENTERS; Name
12 CLEANING THE APPLIANCE: Never use abrasive cleaners Before cleaning the appliance it should be disconnected from the power supply. Cleaning the work surface: periodically clean the burner heads, the cast iron pan supports and the burner caps using warm water. Any spillage must always be removed a...
Page 13 - SPARE PART LIST; Quantity; AUA
13 SPARE PART LIST Quantity Number Drawing Code Description C3 W0..U4X5 AUA C3Y0..U4X 5 A UA 1 601739 CIRCUIT DIAGRAM 1 1 11 202317 PART FOR BURNER FIXING 3 3 11 202386 PART FOR DUAL WOK AND SEMI RAPID BURNERS 1 1 13 510507 SMALL BURNER 1 1 13 510508 SEMI RAPID BURNER 1 3 13 510509 RAPID BURNER 1 1 ...