Beefeater BS12850S - Manuals

5 TOOLS TOOLS REQUIRED You will need the following tools to assemble your barbecue�10mm Spanner (wrench) all body nuts 19mm Spanner (wrench) for gas inlet connection Phillips Head Screwdriver NOTE: Always use the correct size spanner (wrench) to tighten gas fittings� Ensure that all gas fittings are...

6 ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Assembly notes Before any assembly or installation is attempted it is important that you check for damage or missing parts� Your dealer or the manufacturer must be notified of any problems immediately before proceeding�The main frame of the barbecue has ...

7 ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Fitting the heat reflectors Completely remove all of the plastic film from the reflectors� The tabbed ends of the heat reflectors face forward to the front of the barbecue frame� The tabs fit into the slots in the front end of the barbecue (behind the co...

8 ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS Fitting the cooking plates and grills We recommend fitting the plate to the left-hand side of the barbecue frame (with the drain hole to the extreme left)� The grill or grills can be fitted to the right hand side of the barbecue frame� Grills must always...

9 INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS NOTE: the channels overlap in the centre, and must slope to each end of the barbecue such that there is one drain hole at each end�The drain holes in the Grill and Plate are to be positioned towards the front of the barbecue, above the Channel wh...

10 Converting the unit to natural gas 1� Turn off the gas supply valve on the gas cylinder� Ensure that all gas controls on the barbecue are in the OFF position� 2� Disconnect the hose and regulator from the gas cylinder and disconnect the gas hose from the barbecue gas inlet using a 19mm open-ended...

11 ASSEMBLY INSTRUCTIONS FOR TROLLEY ASSEMBLY INSTRUCTIONS FOR TROLLEY Test gas pressure by removing the last burner from the left hand side of the barbecue and attaching a hose and pressure gauge to the end of the gas valve� Turn on 2 burners and check the pressure� Inlet pressure should be 11�0” W...

12 ASSEMBLY INSTRUCTIONS FOR TROLLEY 2) Fit The Rotating Castors Fit the rotating castors into the holes in the bottom of the base� Again, use only two Allen head screws, washers and nuts for each castor in the positions shown� Spanner/wrench tighten immediately� 3) Fit The Right And Left Side Panel...

13 ASSEMBLY INSTRUCTIONS FOR TROLLEY 6) Fit The Lower Back Panel Both back panels are identical� Screw one of the back panels to the base and side panels using 7 Allen head screws, washers and nuts� Hand tighten only at this stage� 7) Fit The Upper Back Panel Screw the other back panel to the side p...

14 ASSEMBLY INSTRUCTIONS FOR TROLLEY 11) Fit The Infill Panel (5 burner models only) 5 burner models require an infill panel between the two doors� Use 4 Allen head screws, washers and nuts to secure the panel between the front cross brace and the base plate� Hand tighten only at this stage� 12) Fit...

15 ASSEMBLY INSTRUCTIONS FOR TROLLEY ASSEMBLY INSTRUCTIONS FOR TROLLEY 16) Fit The Cylinder Bracket This slips into the slot on the right side panel, on either the inside or the outside of the cart� This allows a cylinder to be placed on the outside of the cart, or inside the cabinet enclosure� 17) ...

16 ASSEMBLY AND GAS CONNECTION INSTRUCTIONS FOR SIDE BURNER Connection to Barbecue Ensure all gas controls on the barbecue and side burner are set to OFF� Take the connector hose that came with the side burner� Connect one end to the inlet of the barbecue� Connect the other end to the left side gas ...

17 ASSEMBLY AND GAS CONNECTION INSTRUCTIONS FOR SIDE BURNER Replace The Drip Plate Push the rear drip plate tabs back into the slots at the back of the side burner body, and secure the front of the drip plate with the screw removed earlier� Secure All Joints And Leak TestThe gas leak testing procedu...

18 OPERATING INSTRUCTIONS Before lighting 1� Check that all gas hose fittings and connections are spanner tight� Gas regulators that are fitted with a hand tightening wheel should be checked to ensure that the connection is secure� 2� Check that control knobs are in the Off position� Note that when ...

21 OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Operation of the optional side burnerLighting 1� Check the control knob is in the Off position and ensure the gas line is properly connected� 2� Raise the lid and check that the burner and burner cap are in the correct position� 3� Press and turn the ...

22 HOOD ASSEMBLY INSTRUCTIONS HOOD ASSEMBLY INSTRUCTIONS Preheating Guide 2, 3, 4 and 5 burner barbecue Turn on desired number of burners to the High position for approximately ten minutes or until the cooking surfaces are heated� Cooking with optional the BeefEater Indirect cooking method Indirect ...

23 GETTING THE MOST FROM YOUR ROASTING HOOD GETTING THE MOST FROM YOUR ROASTING HOOD Lifting and moving your hood The BeefEater roasting hood has been engineered for balance as well as durability� To lift the hood, place your hands as shown by the arrows� You will find the hood moves easily with ver...

24 GETTING THE MOST FROM YOUR ROASTING HOOD GETTING THE MOST FROM YOUR ROASTING HOOD You may find it useful to purchase a meat thermometer to help take the guess work out of cooking� Meats such as beef, lamb, veal and pork should be about 70˚C/160˚F when medium� Chicken and turkey should be 85–90˚C/...

25 HELP GUIDE HELP GUIDE Your BeefEater barbecue has undergone a series of quality checking points prior to leaving the factory� Should you have a problem with your appliance please refer to the help guide below before calling your dealer or service person� IMPORTANT Shut off gas supply before perfo...

26 HELP GUIDE HELP GUIDE How long will the gas in my cylinder last? If you have a full cylinder of propane, just look at the table below to see how many hours of gas you have, depending on how many burners you have alight� These figures are approximate only� You may notice that if you have several b...

27 CARE AND MAINTENANCE CARE AND MAINTENANCE Cooking surface preparation Before using your BeefEater barbecue Your BeefEater barbecue will feature either of the following cooking surfaces� 1� Standard cast iron grills 2� ‘RF Technology’ - porcelain coated grills or 3� Stainless steel grills Each sys...

28 CARE AND MAINTENANCE CARE AND MAINTENANCE RF Technology - porcelain enamel coated grills Many food acids, marinades, juices and sauces contain highly acidic elements that will slowly attack the surface of the cast iron if not removed immediately after cooking� • After use, remove all solid materi...

29 CARE AND MAINTENANCE CARE AND MAINTENANCE Stainless steel cleaning and maintenance Clean the appliance as required or at least twice annually with hot soapy water� Avoid abrasive cleaners or brushes as these will mark the porcelain enamel or stainless steel surfaces of the appliance� If you cook ...

30 CARE AND MAINTENANCE CARE AND MAINTENANCE Service and maintenance This appliance should be checked and serviced by an authorised service person every 2 years to ensure the appliance remains in a safe operation condition� These services are not covered by warranty� SERVICE AND MAINTENANCE FREQUENC...

31 LOCATING YOUR BARBECUE AND SIDE BURNER LOCATING YOUR BARBECUE AND SIDE BURNER Most importantly, this is an outdoor appliance. Ensure it is positioned safely away from anything that can catch fire. Outside Use Only: Under no circumstances is this side burner to be used indoors. This includes garag...

32 OUTDOOR INSTALLATION OUTDOOR INSTALLATION INSTRUCTIONS WARNING WARNING Contact your local municipality for any building codes regulating the installation of outdoor barbecue appliances. Outdoor installations must conform to local codes or, in the absence of local codes, with the following. We rec...

33 SPECIFICATIONS Cut out dimensions For built-in installations: islands, masonry, other non-combustible material structures� SIGNATURE SERIES BUILT-IN BARBECUES 2 burner 3 burner 4 burner 5 burner Width (mm) 508 671 828 985 Height (mm) 230 230 230 230 Depth (mm) 520 520 520 520 Minimum clearance to...

34 SPECIFICATIONS SPECIFICATIONS Barbecue Dimensions Model series S3000S, S3000E� WEIGHT WITH HOOD 2 burner 3 burner 4 burner 5 burner Weight with hood (kg) 45 55 65�5 76 537mm 495mm 2 Burner Gas inlet 3/8 SAE Male Thread 3 Burner Gas inlet 3/8 SAE Male Thread 4 Burner Gas inlet 3/8 SAE Male Thread ...

35 WARRANTY This document sets out the terms and conditions of the product warranties for BeefEater Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should there be a manufacturing defect in your Appliance. This warran...

AUSTRALIAphone: 1300 307 939 fax: 1800 356 669 email: customercare @ electrolux.com.au web: beefeaterbbq.com NEW ZEALANDphone: 0800 436 245 fax: 0800 225 088 email: customercare @ electrolux.co.nz web: beefeaterbbq.com For more information on all BeefEater products, or for dimension and installation...