Page 2 - THIS APPLIANCE HAS BEEN DESIGNED FOR DOMESTIC USE ONLY
2 3100257 READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE. It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. The manufacturer will not be responsible for any damage to property or...
Page 3 - CONTENTS
3 CONTENTS SECTION Page WARNINGS 3 LOCAL AUTHORITY REQUIREMENTS 4 IMPORTANT INFORMATION FOR INSTALLING THE APPLIANCE 5 APPLIANCE GAS CONNECTION 6 SUPPORT LEGS 8 ANTI-TIL DEVICE 9 CONVERTION TO A DIFFERENT TYPE OF GAS 10 APPLIANCE ELECTRIC CONNECTION 12 APPLIANCE USE AND MAINTENANCE 13 TROUBLESHOOTIN...
Page 5 - LOCAL AUTHORITY REQUIREMENTS; withstand a minimum temperature of 65°; Clearance above and around domestic cookers; REQUIREMENTS; Overhead clearances; protection of the rear wall is not required.
5 LOCAL AUTHORITY REQUIREMENTS Before installation, unpack all parts from carton, remove all internal packaging and check for da mage. Check Gas Type and specifications plate placed on the rear of the unit, alternatively there is a second label supplied. All gas fitting work, se rvice and repairs ca...
Page 6 - IMPORTANT INFORMATION FOR INSTALLING THE APPLIANCE; LENGTH; Room Ventilation; These openings should be built so that they cannot be clogged.; Location and Aeration
6 IMPORTANT INFORMATION FOR INSTALLING THE APPLIANCE The cooker can be installed separately, as a freestanding unit, or between kitchen units or between a kitchen unit and the wall. This appliance is not connected to devices which exhaust combustion products. Special attention must be focused on the...
Page 7 - APPLIANCE GAS CONNECTION; flexible hose; Gas inlet positions with different leg heights; Gas Regulator; Using a flexible connection
7 APPLIANCE GAS CONNECTION IMPORTANT: This appliance must be installed by an authorised person. WARNING: DO NOT MODIFY THIS APPLIANCE If the appliance cannot be adjusted to perform correctly, contact the service department. This appliance utilises a threaded 1/2" gas male fitting. To connect the...
Page 8 - Adaption to various types of gas; Burners; Test the operation of the cooker before leaving; SUPPORT LEGS
8 TABLE N°1 Adaption to various types of gas Burners Gas type Pressure (kPa) Injector (mm) Mj/hr Small Natural 1.00 0.90 3.60 Small LPG 2.75 0.54 3.60 Medium Natural 1.00 1.18 6.30 Medium LPG 2.75 0.70 6.30 Large Natural 1.00 1.55 10.80 Large LPG 2.75 0.92 10.80 Wok Natural 1.00 1.80 14.40 Wok LPG 2...
Page 10 - WARNING
10 ANTI-TILT DEVICE A chain should be fitted by the installer within 50mm of the hose connection point to prevent strain on the hose when the cooker is pulled forward. The chain should restrict the appliance movement to no more than 80% of the hose length. After the chain is installed, check that th...
Page 11 - CONVERSION TO DIFFERENT TYPES OF GAS; REPLACING THE NOZZLES TO OPERATE WITH ANOTHER TYPE OF GAS; If converting to Natural Gas, fit gas regulator; Work surface burner adjustment; : follow the instructions below to adjust the minimum:
11 CONVERSION TO DIFFERENT TYPES OF GAS Before performing any maintenance operation, disconnect the appliance from the gas supply and electricity network. REPLACING THE NOZZLES TO OPERATE WITH ANOTHER TYPE OF GAS When converting to LPG remove the NG gas regulator (if fitted) and fit LPG test point a...
Page 12 - Fig. 12 Fig.13 Fig.14
12 • With a slotted screwdriver turn the choking screw (see figure 14) and, while observing the flame at the same time through the cooker porthole, evaluate the consistency of the flame so it remains on when switching quickly from the MINIMUM to the MAXIMUM position. WARNING: The above-mentioned adj...
Page 13 - APPLIANCE ELECTRICAL CONNECTION; appliance (see the label applied to the bottom of the casing).; When the connection is made directly to the electric network:; The ground wire must not be interrupted by the circuit-breaker.; should be longer than the other wires by about 2 cm.; TABLE N°3: TYPES OF POWER CORDS; Work surface; Ground symbol
13 APPLIANCE ELECTRICAL CONNECTION The electric connection must comply with the current legal standards and regulations. Before making the connection, check that: • The system electrical rating and the current outlet are adequate for the maximum power output of the appliance (see the label applied t...
Page 14 - APPLIANCE USE AND MAINTENANCE; along the support base.; Please maintain your; REPLACING PARTS
14 APPLIANCE USE AND MAINTENANCE ATTENTION: Important Warnings. • For cookers resting on base ATTENTION : if the cooker rest on a base, take the measures necessary to prevent the cooker from sliding along the support base. • For cookers with electric ovens ATTENTION : The unit becomes hot during use...
Page 15 - CONTROL PANEL DESCRIPTION; OVEN RACKS AND TRAYS
15 WARNING: Before replacing the bulb, disconnect the appliance from the electric power supply. WARNING : The power cord supplied with the appliance is connected to the appliance with an X type connection (in compliance with standards AS/NZS 60335-1, AS/NZS 60335-2-6 and subsequent amendments) for w...
Page 16 - Tips for using burners correctly:
16 this position until the burner ignites, and then wait 2 seconds for the the rmocouple to heat up. Release the control knob and adjust to the correct setting. Fig. 18 • -Use of the dual burner (Fig19) This model controls both the central and external crown of the burner with just one valve. To ign...
Page 17 - USING THE GAS OVEN; relight the oven until after at least 1 minute.; THERMOSTAT SETTING; The oven burner can be ignited in different ways:; cooker cover open to prevent it from overheating.
17 USING THE GAS OVEN GAS OVEN: All the gas oven cookers are equipped with a thermostat and safety device to adjust the cooking temperature. The oven temperature is set by turning the knob counterclockwise to match the indicator with the temperature selected. The gas oven can be combined with a gas ...
Page 18 - FISH; the symbol
18 TABLE N°7 GAS OVEN COOKING TABLE TEMP °C HEIGHT MINUTES MEAT PORK ROAST 220 (210) 2 60-70 BEEF ROAST (YOUNG STEER) 250 (240) 2 50-60 BEEF ROAST 240 (230) 2 60-70 VEAL ROAST 220 (210) 2 60-70 LAMB ROAST 220 (210) 2 45-55 ROAST BEEF 230 (230) 2 55-65 ROAST HARE 235 (225) 2 40-50 ROAST RABBIT 220 (2...
Page 19 - USING THE OVEN THERMOSTAT CONTROL KNOB
19 USING THE OVEN THERMOSTAT CONTROL KNOB The thermostat is used to set the maximum internal temperature of the oven. Turn the thermostat control knob clockwise and align the selected temperature indicated on the knob with the index etched on the control panel above it. Thermostat operation is indic...
Page 20 - USING THE ELECTRIC OVEN; conventional cooking
20 FAN ASSIST COOKING FUNCTION : This function runs the upper and lower elements, and runs both rear internal fans. It is dependent on the timer and the thermostat setting. Best used when cooking large amounts of food at one time, for frozen potato products and crumbed/battered chicken or fish. FAN ...
Page 21 - USING THE END OF COOKING TIMER (fig 25) Fig 24; NOTE; : This function is available for the electric oven only.; USING THE DIGITAL CLOCK (fig.26); Power on; Display is flashing; Time of day function; minutes in the long time section.
21 minutes before inserting the trays. Adjust oven function control knob to fan oven cooking and place food inside oven. Set timer if needed. grilling The grill is controlled using the oven’s temperature knob. The grill function uses both elements at the top of the oven, so is faster and more powerf...
Page 22 - Reset timer; Count down to ze; Signal; USING THE TOUCH CLOCK; Mains frequency detection; is cancelled.; The Buzzer; First; Clearing Programs and Manual function; ic; Key Lock
22 The maximum time is 10 h. The format change will happen after 99 minutes and 50 seconds to 1 hour and 40 minutes. The pot- symbol illuminated. To show time of day press “time of day” button for 6 seconds. Reset timer Count down to ze ro with permanent pressing “ – “ button. (automatic stop at zer...
Page 24 - any point by pressing the appropriate function button.; Cancelling timer functions; USING THE; The first start up
24 Minute minder Press the minute minder button and set required time with the +/- buttons. While the function is running, the bell symbol is displayed. When the time set has elapsed, the audible signal sounds. Press any of the 3 buttons to the left to stop the audible sound. Audible signal The audi...
Page 25 - End of cooking; wi
25 End of cooking once having selected a cooking function and set the desired temperature, touch the M key to access the programming mode for at least 2 sec. the ) symbol switches on. Release and touch again the M key. On the display the A symbol starts blinking and the writing " dur " appea...
Page 26 - USING THE THERMOMETER; temperatures more accurately.; USING THE SELF-CLEANING OVEN; and dried before being replaced.
26 USING THE THERMOMETER (fig.31) The cooker is fitted with a device to measure the temperature in the middle of the oven. This lets you check the temperature inside the oven and adjust food cooking temperatures more accurately. Electric oven When you turn on the oven, the orange light comes on to i...
