Page 2 - Table of Contents; General
Page 2 Table of Contents Page No. General Unpacking ...................................................................................................Page 1 Description ..................................................................................................Page 1 Installation Basic Instal...
Page 3 - Bard; wall mounted products. They are
Page 3 I. GENERAL This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or condition nor for use in the mitigation, treatment, or prevention of any disease or condition. U NPACKING The WUVCLP light package is shipped in one carton, which contains the ele...
Page 4 - Table 1; * Indicates design revision of basic model.
Page 4 Compatibility Chart: Table 1 WA18*-A WH18*-A WH26*-A SH26*-A WA24*-A WH24*-A WH31*-A SH31*-A WA30*-A WH30*-A WH38*-A SH37*-A WUVCLP-A WA37*-A WH36*-A WH43*-A SH43*-A WA42*-A WH42*-A WH49*-A SH49*-A WA48*-A WH48*-A WH61*-A SH61*-A WA60*-A WH60*-A WA70*-A WA24*-B WH18*-B WH26*-B SH26*-B WA30*-B...
Page 5 - Table 2; Wall Mount Unit
Page 5 II. INSTALLATION B ASIC I NSTALLATION 1. Before doing any service work, the unit disconnect must be turned off and locked to prevent injury or death due to electrical shock or contact with moving parts. The thermostat must also be turned off. 2. Unpack the ultraviolet light kit, accessories, ...
Page 6 - Place the WUVCLP light assembly in the unit 1”; Figure 2
Page 6 4. Remove the exterior blower access panel from the wall mount unit and set it aside. (See Figure 2) 5. Using the top screw hole for the blower door panel as a starting point, drill two ¼ inch holes on each side of the unit to secure the mounting brackets of the WUVCLP. See Figure 3 for hole ...
Page 7 - 30/208 Volt Single Phase and Three Phase Units Only; Figure 5
Page 7 7. Slide the left bracket tight against the left side of the unit. Insert two self drilling screws on the left side of the unit and into the left side mounting bracket of the WUVCLP light assembly. Use the pilot holes in the mounting brackets for alignment. Tighten the ¼ in screw on the left ...
Page 8 - Figure 7A; Install
Page 8 2. Remove outer and inner control panel covers. Install the 3 pin accessory plug from the parts bag into the control panel if not already equipped. See figure 7A for side installation on the 5 or 6 ton cabinet size. See figure 7B for back installation on the 2 and 3 ton cabinet size. 3. Plug ...
Page 9 - Caution; Figure 9
Page 9 3. Remove outer and inner control panel covers. Install the 3 pin accessory plug from the parts bag into the control panel if not already equipped. See figure 6A for side installation the 5 or 6 ton cabinet size. See figure 6B for back installation on the 2 and 3 ton cabinet size. 4. Plug the...
Page 10 - LIST; Holder
Page 10 WARNING: Hazard of Electric Shock • Electric shock can cause serious injury or death • Disconnect power before servicing the light WARNING: Hazard of Ultraviolet Type C Light • Looking directly at the UVC light may cause permanent eye damage or blindness. • Disconnect power before servicing ...
Page 11 - DIAGRAM