Page 3 - Technical Information; Do not install this faucet on a sink with a raised lip.
Starck 10101XX1/10106XX1/10140XX1/10145XX1 Starck X 10170001/10175001/10180001/10185001 Technical Information Recommended water pressure 15 - 58 psi Max. water pressure 58 psi Max. hot water temp. 176 o F* Recommended hot water temp. 10 o F - 140 o F* Flow rate 1. gpm Battery CR-P / 6 V Lithium Auto...
Page 4 - Installation notes; not; Do not bend or twist the supply hose!
4 Installation notes • Flush the hot and cold supplies thoroughly before installing the faucet. Damage to the faucet caused by debris is not covered under the warranty. • The hot and cold supplies should be of equal pressure. • The faucet should not be used with a con- tinuous flow water heater. • D...
Page 5 - Installation; Tighten the hoses with two wrenches, as shown, to
5 Installation Position the faucet on the sink or countertop (1). Install and tighten the mounting nut (). Tighten the tensioning screws (). Connect the /8” adapters to the stops (4). Connect the hoses to the adapters (5). Tighten the hoses with two wrenches, as shown, to prevent the hoses from twis...
Page 6 - Temperature adjustment -
6 Connect the faucet power cable to the battery pack or AC power pack (1). Plug the AC power pack in. Turn the hot and cold supplies on (). Remove the protective film from the sensor window (). Wait 0 seconds before attempting to use the faucet (4). Position your hand in front of the sensor to turn ...
Page 7 - Wait 30 seconds
7 Remove the faucet body (1). Turn the temperature screw forward to make the water cooler, backward to make it warmer (). Dry any drops of water from the faucet or mounting surface. Replace the faucet body (1). Replace the screw (). Turn the water supplies on (). Reconnect the power cable (4). Wait ...
Page 8 - Battery Replacement
8 Battery Replacement -- models 10101XX1/ 10106XX1/10170001/10175001 only If the LED in the sensor window flashes, the battery is low, but the faucet can still be used. If the LED lights continuously, the battery must be changed before the faucet can be used. Remove the four screws and the battery p...
Page 9 - Clean the aerator and filters; If the water flow is reduced over time, clean the aerator; Starck; At another sink, rinse the filters and the aerator or spray former.
Clean the aerator and filters -- all models If the water flow is reduced over time, clean the aerator (a) and the filters (b). Turn the water supplies off (1). Disconnect the power cable (). Starck 10101/10106/10140/10145 -- unscrew and remove the aerator (a). Starck X 10170/10175/10180/10185 -- rem...
Page 10 - Place a hand in front of the sensor to turn the faucet on
10 Turn the water on (1). Reconnect the power cable (). Wait 30 seconds (1). Place a hand in front of the sensor to turn the faucet on ().
Page 11 - Cleaning
11 Cleaning The faucet may be turned off temporarily so that the sink may be cleaned. Cover the sensor window with a hand for approximately 10 seconds. The faucet will turn off for approximately 60 seconds, so that the sink may be cleaned. The LED in the sensor window will flash. When the LED no lon...
Page 12 - Change the Spray Former
1 Change the Spray Former -- Starck X 10170 / 10175 / 10180 / 10185 only The waterfall spray former is installed on the faucet at the fac- tory. A round monospray spray former is included with the faucet. The spray former may be changed easily, if desired. Use a mm Allen wrench to remove the spray f...
Page 13 - Reduce the Sensor Range
1 Reduce the Sensor Range The sensor is set for maximum range at the factory. If the faucet is used on a very small or highly reflective lavatory, the sensor range may be reduced by ap- proximately ”. Disconnect the power cable for approximately 10 seconds (1). Reconnect the power cable (). The LED ...
Page 14 - Replacement Parts; Maintenance note
14 Replacement Parts 1 battery, lithium CR-P / 6V connection hose 880000 spray former 8867000 4 aerator, Starck 4005XX0 5 fixing set 161000 6 electronics, Starck 87000 electronics, Starck X 884000 7 AC adapter 8 battery box 8801000 check valve 6456000 10 aerator, Starck X 8610000 XX = color 00 = chr...
Page 15 - Limited Lifetime Consumer Warranty; Cleaning Recommendation for Hansgrohe Products; Cleaning Materials for Faucets and Showers
15 Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 16, and installed in either the ...