Page 3 - Internet Explorer Ver. 5.0 or later must be installed; CPU; At least 50 MB; Display; to get the version 4.30 update for EMP
Limitations When the PowerLite1725 / 1735W exhibit a Lamp Cover Open error state, EMP Monitor cannot detect the error. The reason is that when the lamp cover is opened, the primary power source that reports the error state to EMP Monitor is turned off immediately. This is different from other models...
Page 4 - Supported PowerLite 735c
Software Upgrade History: Version Release date Remarks 3.00 December 25,2002 Supported PowerLite 735c 3.01 February 26,2003 Supported PowerLite 7800p / 8300i 3.02 April 18,2003 Supported PowerLite 7850p / 8300i with EasyMP.net option module 3.03 November 21,2003 Supported PowerLite Cinema 500 3.04 A...
Page 5 - EPSON; RODUCT; AP; New Functions and Improvements:; Air flow sensor error; Supported Projectors:; This application supports the following Epson projectors:
Page 1 of 3 PSB.2007.11.005A EPSON P RODUCT S UPPORT B ULLETIN Date: 11/13/2007 Originator: AP PSB #: PSB.2007.11.005A Authorization: Reference: TI 07-63e, Rev. A Total Pages: 3 Product(s): Epson EMP Monitor Subject: EMP Monitor Version 4.21 Release This bulletin was created to inform you of the rel...
Page 6 - Supported Operating Environment:
Page 2 of 3 PSB.2007.11.005A PowerLite 735c PowerLite 1715c PowerLite 1815p PowerLite 737c PowerLite 6100i PowerLite 822p PowerLite 745c PowerLite 7800p PowerLite 6110i PowerLite 755c PowerLite 7850p PowerLite Cinema 500 PowerLite 765c PowerLite 7900NL PowerLite 61p PowerLite 830p PowerLite 8300i / ...
Page 7 - Version; Added support for the PowerLite 735c
Page 3 of 3 PSB.2007.11.005A Software History: Version Release Date Notes 3.00 December 25, 2002 Added support for the PowerLite 735c 3.01 February 26, 2003 Added support for the PowerLite 7800p / 8300i 3.02 April 18, 2003 Added support for the PowerLite 7850p / PowerLite 8300iwith the EasyMP.net op...
Page 8 - JD
Page 1 of 3 PSB.2005.06.001 EPSON P RODUCT S UPPORT B ULLETIN Date: 06/06/2005 Originator: JD PSB #: PSB.2005.06.001 Authorization: Reference: N/A Total Pages: 3 Product(s): Powerlite 8300/8300 with EasyMP.net/9300 series Projectors Subject: Filter-Cleaning Procedures This bulletin was created to in...
Page 9 - Both filters should be replaced when the lamp is replaced.
Page 2 of 3 PSB.2005.06.001 2) Air intake filters (2)--located at bottom of projector: Use a computer vacuum to clean both filters. If you don’t have one, then use a soft brush and gently clean the filters. If the dirt is difficult to remove or either filter is damaged or broken, replace the filter(...
Page 11 - JAM; Operating Systems tested:; Apple PowerMac G5; Video Test Generators tested:; Extron
Page 1 of 2 PSB.2005.05.004 EPSON P RODUCT S UPPORT B ULLETIN Date: 05/11/2005 Originator: JAM PSB #: PSB.2005.05.004 Authorization: Reference: N/A Total Pages: 2 Product(s): PowerLite 9300i Subject: 1400 x 1050 DVI Compatibility Support Reason: This bulletin is to inform you of the testing results ...
Page 12 - Projector Resolution “About” information:; DVI
Page 2 of 2 PSB.2005.05.004 Projector Resolution “About” information: Source: DVI Input Signal: Digital-RGB Resolution 1400 x 1050 Refresh Rate: 60 Hz Input Device: PowerMac G5 Source: Computer 1 Input Signal: Analog-RGB Resolution 1400 x 1050 Refresh Rate: 60 Hz Input Device: Extron VTG 400 Tested ...
Page 13 - System Version(s): Windows 98SE and Windows XP Service Pack 2
Page 1 of 2 PSB.2005.05.003 EPSON P RODUCT S UPPORT B ULLETIN Date: 05/11/2005 Originator: JAM PSB #: PSB.2005.05.003 Authorization: Reference: N/A Total Pages: 2 Product(s): PowerLite 8300i and PowerLite 9300i Subject: 1400 x 1050 Compatibility Support Reason: This bulletin is to inform you of the ...
Page 15 - DS; Results of Windows XP SP2 installation:
Page 1 of 14 PSB.2004.10.002 EPSON P RODUCT S UPPORT B ULLETIN Date: 10/08/2004 Originator: DS PSB #: PSB.2004.10.002 Authorization: Reference: TI 04-46e Rev. A Total Pages: 14 Product(s): EMP NS Connection, EMP Network Manager, EMP Monitor,EMP Multi Screen Adjustment, Cinema Color Editor, VCOM Driv...
Page 16 - Executing the Software:; Security alert screen (EMP NS Connection)
Page 2 of 14 PSB.2004.10.002 Executing the Software: When executing the software noted below for the first time after SP2 installation completes,the following security alert messages are displayed: [EMP NS Connection] Security alert screen (EMP NS Connection) [EMP Network Manager] Security alert scr...
Page 20 - Windows Firewall screen
Page 6 of 14 PSB.2004.10.002 Windows Firewall screen [Caution] In case the check box for Don’t allow exceptions is checked (this box is not checked at the initial setting), a network port for software is not unblocked even though the software is checked on Exceptions . Make sure this option is not s...
Page 21 - Exceptions; tab and display exceptions program.
Page 7 of 14 PSB.2004.10.002 c.) Select the Exceptions tab and display exceptions program. • Exceptions screen d.) Check the check boxes for the software you don’t want to block. [Caution] If this check box is not checked, the security alert screen is not displayed when starting software.
Page 22 - Check; EasyMP Software; box
Page 8 of 14 PSB.2004.10.002 [EMP NS Connection] • Check EasyMP Software box Unblock screen (EMP NS Connection)
Page 23 - EPSON Projector
Page 9 of 14 PSB.2004.10.002 [EMP Network Manager Application] • Check EPSON Projector box Unblock screen (EMP Network Manager)
Page 25 - EPSON Projector Software for
Page 11 of 14 PSB.2004.10.002 [EMP Multi Screen Adjustment Application] → Check EPSON Projector Software for Multi Screen box Unblock screen (EMP Multi Screen Adjustment)
Page 26 - and they can operate normally.
Page 12 of 14 PSB.2004.10.002 [Cinema Color Editor Application] ---> Check Cinema Color Editor. Unblock screen (Cinema Color Editor) By following the above procedure, the network port that each application uses is unblocked and they can operate normally.
Page 28 - VCOM Driver
Page 14 of 14 PSB.2004.10.002 VCOM Driver The following message is shown after the VCOM driver is installed on your PC.Select “No, not this time” item and continue the Plug&Play of the device. 8.) Notes: When you add the program to Exceptions list, the program can receive networkcommunication fr...