Artusi ACG700X - Manuals - manualsarea.com

Page 3 - HOOD DUCTING GUIDE

HOOD DUCTING GUIDE Here are some important points to consider when choosing and/or installing a range hood:• An externally ducted range hood will generally outperform a recirculating range hood. • We discourage the use of flexible ducting as this has a significant negative impact on airflow and nois...

Page 5 - Know your cooker hood; Please read these instructions before using your cooker hood.

Know your cooker hood Please read these instructions before using your cooker hood. 1. Top inner chimney flue 2. Bottom outer chimney flue3. Glass 4. Cooker body5. Air duct assembly 6. Filters 1 2 3 4 5 6 Also included Damper flap Chimney fixed bolster Drill hole stencil User instruction manual Cong...

Page 6 - Installation; Ensure the power is turned off before beginning the installation

600-750mm 3 Installation Ensure the power is turned off before beginning the installation 1 2 Check the voltage and frequency on the rating plate located inside the hood. Ensure the hood is installed so that the bottom of the hood is no less than 600mm and no more than 750mm above the cooking elemen...

Page 7 - Fig. 3 Attach the damper flap on the air outlet as shown.

4 Installation 3 Fig. 3 Attach the damper flap on the air outlet as shown. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable laws, regulations and safety standards.

Page 8 - You will need two people to install this hood

5 Installation You will need two people to install this hood Using the drill hole stencil mark the screw positions on the wall. Drill four 8mm holes into the wall. Put one expansion plug and one 10mm screw into each of the holes. Screw the screws into place but not all the way into the plugs until a...

Page 10 - into a fuel

into a fuel venting direction. Installation 8 9 10 Ensure the power is turned off before beginning the installation 7 Attach the ducting hose to the air duct. Vertical discharge of air. Run the ducting through a cupboard and/or into a space in the ceiling cavity to a roof cap. Horizontal discharge o...

Page 11 - Attaching the chimney flues

Installation 11 12 Attaching the chimney flues Assemble the 2 flues, inner top to outer bottom.Place them onto the hood body covering the air duct assembly and screw into place. Measure the height for the chimney flue bracket. Pull the inner chimney to the desired height. 8

Page 13 - Hood Operation

Ensure the hood is OFF when first installed.Insert the power plug when all previous installation steps are completed. Press the Light button for the lights to turn ON.Press again to turn OFFPush button 1 for low speedPush button 2 for medium speedPush button 3 for high speedPush button 0 to turn off...

Page 14 - Replacement & maintenance; The charcoal filter cannot be washed or cleaned and must

Replacement & maintenance Clean the filters and ventilating fan at least once every 3 months or earlier as required. Recirculation mode filter instructionsInstall a charcoal filter as shown. Note: The charcoal filter cannot be washed or cleaned and must be replaced as necessary. 11

Page 15 - Cleaning instructions; Turn off the hood before cleaning.

Cleaning instructions Turn off the hood before cleaning. 1. Clean the surface of the hood frequently using mild soap or detergent at least once every 3 months. 2. Avoid the use of harsh cleaning agents as it may spoil the hood’s appearance. 3. Wash the filters using mild soap or detergent. Note that...

Page 18 - Warranty Card tear off

Please complete and send to ARTUSI at: REPLY PAID 83617 LEICHHARDT NSW 2040 Last Name: First Name: Address: State: Postcode: Email: Home Phone: Mobile: Purchase Date: / / (Please attach proof of purchase to validate warranty) MODEL NUMBER SERIAL NUMBER (if you cannot locate the serial number please ...